For a given soil, the void ratio e, water content w, and specific gravity Gs are found to be 0.50, 15%, and 2.65, respectively. Find: (a) Total unit weight of the soil γt (b) Degree of saturation S (c) Dry unit weight γd if the water in the void is removed

For a given soil, the void ratio e, water content w, and specific gravity Gs are found to be 0.50, 15%, and 2.65, respectively. Find: (a) Total unit weight of the soil γt (b) Degree of saturation S (c) Dry unit weight γd if the water in the void is removed

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter3: Weight-volume Relationships And Plasticity

Section: Chapter Questions

Problem 3.5P

See similar textbooks

Related questions

Q: 10 kh 20 kn i= 3m a i - 3m - 3m • which of the Following nearly gives the reaction CKN) at the rolle...

Q: Which of the following most nearly gives the internal degree of indeterminacy?

Q: Outline some of the causes of soil erosion in Lesotho basin yourself on land capability and land sui...

Q: The 600-lb, 20ft-wide rectangular gate shown is hinged at B and leans against the floor at A making ...

Q: SHOW CLEAR SOLUTIONS (STEP BY STEP). USE NSCP 2015. uaume a concrete cover of 40mm, 10mm stirrups an...

Q: The gate shown is hinged through a point A and is restrained from opening by a fixed ridge at point ...

Q: a a 100 mm -75 mm- - 75 mm- 50 mm 100 mm 50 mm A a Figure Q2[b]

Q: Using the Internet, find information about the following two subjects and answer the questions below...

A: 1. Genrich Savlovich Altshuller was a Soviet engineer, inventor and writer. He was born in Tashkent,...

Q: 2. A man is pulling a crate that has a mass of 50kg and it attains a velocity of 4 m/s after moving ...

A: This question is related to Engineering Mechanics. In this question we calculate Force P using force...

Q: Determine the horizontal and vertical components of reaction at the supports A and C. Assume the mem...

Q: Give and discuss the advantages and disadvantages in the design using Renewable Energy.

A: Advantages of Renewable Energy 1. When compared to fossil fuels, it is safe, abundant, and clean to...

Q: Coarse aggregate is placed in a rigid bucket and rodded with tamping rod. The volume of the bucket i...

A: Given data: Volume of bucket=20,000 cm3. Weight of aggregate= 400N. Bulk specific gravity of the agg...

Q: Compute the total elongation caused by an axial load of 142 kN applied to a square bar, tapering fro...

Q: The satellite S travels around the earth in a circular path with a constant speed of 18 Mm/h. The ac...

A: Velocity ν=18Mm/h=18×1063600=5000m/s Since, at=dvdt=0 at= V2ρ ρ=v2at=500022=12.5×106m =12500km ...

Q: Show

Q: Problem 3: Find the cross sectional area of members AB, and BC for the truss shown if the stress for...

Q: For the beam and loading shown below, calculate the maximum and minimum factored reaction for suppor...

Q: Compute the vertical movement under P 50

Q: PROBLEM 1: Both a gage and a manometer are attached to a tank lo measure pressure, Given the reading...

A: The values and diagram given in the question are as follows

Q: Show that F f | gL _H when resistance force (F) for a boat has related with a function of length L, ...

A: solutionUse buckingham pi theoremGiven parameteres Resisting force F; Length L; VelocityVacceleratio...

Q: A bicyclist is moving 6m/s when he is passed by another bicyclist. He instantly begins to accelerate...

Q: what are the 4 Types of Forecasting Model in Transportation? Give 1 example on each type. Where and ...

A: Forecasting models in transportation: Forecasting in transportation is a way to find the number of v...

Q: An old equal-tangent crest vertical curve was designed with a PVI at station 117+45 and elevation of...

A: An equal tangent crest vertical curve is as below The point PVC is called as the initial tangent po...

Q: car

Q: A hollow alloy tube 4 m long with external and internal diameters of 40 mm and 25 mm respectively wa...

Q: A metallic cantilever 150 mm wide, 200 mm deep and 2 m span carries a uniformly varying load of 50 k...

Q: Determine

Q: What is the difference between a concrete and an abstract class?

Q: Define the major losses and minor losses in pipe flow.

A: MAJOR LOSSSES ARE DUE TO FRICTION AND MINOR ARE DUE TO VARIOUS REASONS

Q: ember with no holes is subjected to an axial load P, which is 40 percent dead load and 60 percent li...

A: Given:- W12 x 30 dead load=40% live load=60% uniform service wind load =2.40 k/ft Cb=1.0, Fu=65ksi ...

Q: Find the work required to pump all of the water from a rectangular tank with an 8mx5m base and a hei...

A: To determine the work done to pump out the water from the given rectangular tank. Given, Dimension...

Q: A soil has the following soil properties for use in the Green-Ampt equation: K = 1.5 in/hr = -9.8 in...

Q: eom/coune/1361/qui/ aloustions/2101 E 20 k 12 12 ft 5 k 5 ft-5 ft-- -14 ft

Q: In the cantilever method, the axial force at columns is proportional from its distance in all cases.

A: Answer:-True

Q: In the absence of proper fire detection and control equipment, which of th following is most critica...

A: Detection and alarm systems are crucial components of your comprehensive fire safety plan. Early det...

Q: A simply supported beam with rectangular cross-section is subjected to a central concentrated load. ...

Q: A hollow alloy tube 4 m long with external and internal diameters of 40 mm and 25 mm respectively wa...

Q: 10 k F 5k 16 ft D 10 k E 16 ft A C B 12 ft 12 ft Determine the Horizontal Reaction at C. 15 kinc lof...

Q: 2"

Q: For the illustrated plain concrete T-beam, compute the stress at top and bottom of the extreme ...

Q: the advantages and disadvantages of having multiple gauge system

Q: If 6 m3 of oil weighs 49 kN, calculate its specific weight γ, density ρ, and specific gravity

Q: PROBLEM 2: The 280-kg, 6m-wide rectangular gate shown is hinged at B and leans against the floor at ...

Q: The table below shows the observed rainfall intensity on a 2.26 km2 catchment area. Estimate the o i...

Q: 9. Angle bars are used for the determinate truss as shown in the figure. Horizontal and vertical mem...

A: The given values are as follows,A-steel =L6×6×3/8Ag=4.38in2t=0.375inBolt diameter(db)=22mm=0.866inS=...

Q: PLEASE DISPLAY ALL STEPS BELOW! THANKS GIVEN: a cantilevered steel beam with a circular cross sectio...

Q: A steel section as shown in figure is subjected to a shear force of 20 kN. What will be shear stress...

Q: - Because of a minor collision, one of the two SB lanes on a freeway is blocked at 8:13am. The norma...

A: Given, Freeway Capacity =3600 vehicles/hour Capacity when one lane blocked=1340 vehicle/hour Arrival...

Q: 1. Compute the interior angles between the given pair of lines whose magnetic bearings are given. OA...

A: rule: (a)If the lines are on the same side of the meridian and in same quadrant (Fig. a) The include...

Q: If the liquid limit value of the experimental results is 70% and the plastic limit is 35%, and the c...

Concept explainers

Weight-Volume relationships

Weight is defined as the quantity of matter contained in a body. Weight can also be defined as the force acting on a body due to gravity. Mathematically, weight can be defined as-

Question

For a given soil, the void ratio e, water content w, and specific gravity Gs are found to be 0.50, 15%, and 2.65, respectively. Find:

(a) Total unit weight of the soil γt
(b) Degree of saturation S
(c) Dry unit weight γd if the water in the void is removed

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a given soil, the void ratio e, water content w, and specific gravity Gs are found to be 0.50, 15%, and 2.65, respectively. Find: Total unit weight of the soil γt, Degree of saturation S, Dry unit weight γd if the water in the void is removed
For a given soil, the following are known. Gs=2.74,moist unit weight = 20.6 KN/cu.m, and moisturecontent is 16.6%.a) Determine the dry unit weightb) Determine the void ratioc) Determine the porosityd) Determine the degree of saturatione) Determine the weight of water in KN to beadded per cubic meter of soil for a 100%degree of saturation.
The bulk unit weight of the soil is 16.680 kN/m3 at a saturation of 36.870 % and the effective unit weight is 9.580 kN/m3. If the maximum and minimum void ratio of the soil is 0.880 and 0.390, respectively, determine the following: max dry unit weight , relative density , saturated unit weight
The moist unit weight of a soil is 19.2 kN/m3. Given that Gs = 2.69 and w = 9.8%, determine:a. Void ratiob. Dry unit weightc. Degree of saturation
a. A soil specimen with volume of 0.60x10-4 m3 , weighs 0.105 kg. Its dry weight is 0.0802 kg, and Gs is 2.65. Compute • Water content m, % • Void ratio e and porosity n Degree of saturation Sr, %
the moist unit weight of a soil is 19.2kN/m3. Given that Gs = 2.69 and w =9.8%, determine the void ratio, dry unit weight and degree of saturation
For a moist soil specimen, the following are given Gs= 2.67, volume = 0.5 m³ moist unit weight = 9.5 KN and the moisture content = 7.3%. Determine Dry unit weight, Void ratio, porosity, Degree of saturation.
For a given soil, the following are given: Gs = 2.67; moist unit weight,y= 112 lb/ft3; and moisture content, w = 10.8%. Determine:a. Dry unit weightb. Void ratioc. Porosityd. Degree of saturation
3. A saturated soil sample has a unit weight of 23 Kn/m^3 and specific gravity of 2.69. Compute the Dry Unit weight in English units, void ratio, Porosity, moisture content and the degree of saturation.
The void ratio of a soil is 1.2. Determine the bulk and effective unit weights at, first 75%, second 95%, and 100% saturation. What is the percentage error in the bulk unit weight if the soil is 95% saturated but assumed to be 100% saturated?
A saturated soil specimen has w = 36% and ᵞd = 85.43 lb/ft3. Determine: i) Void ratio ii) Porosity
An undisturbed sample of clay is found to have a wet weight of 63 lb, a dry weight of 51 lb, and a total volume of 0.50 ft3. If the specific gravity of soil solids is 2.65, determine the water content, void ratio, and degree of saturation.