For a system having damping factor, 8 =0.7 and frequency of natural oscillations, wn =14.5 rad/sec. %3D The Delay time , to is =

Q: Example 2: calculate the RMS noise voltage arising from thermal noise in two resistors 100 & 150…

A:

Q: Example 2: calculate the RMS noise voltage arising from thermal noise in two resistors 100 & 150…

A: Answer:-

Q: 1. Determine the frequency of oscillation of a three-stage phase shift ladder network oscillator…

A: According to the Bartelby guideline we are suppose to answer only one question at a time. Kindly…

Q: If the transient response of a given system settles within 5% in 9.6 Sec then the extra time…

A: Given that if the transient response of a given settles within 5% in 9.6 sec then the extra time…

Q: Assume that for a given accelerometer sensor the measured output voltage is 15 mV (g is the…

A: Please check the step 2 for solution

Q: Q1/A 750V voltmeter is specified to be accurate within 3% at full scale. Calculate the limiting…

A:

Q: Determine the characteristic table for the following excitation table. Q(t) Q(t+1) | S R X 1 1 1 1 1…

A: Given :   Given the excitation table we have to determine the characteristics table

Q: If the maximum amplitude of a sine wave is 2 V, the minimum amplitude is ________ V. a. 2 b. 1 c. -2…

A: Answer is option c

Q: If the maximum amplitude of a sine wave is 2 V, the minimum amplitude is ________ V. a. 2 b. 1…

A: There is one multiple choice question given about the amplitude value of sine wave.

Q: If the maximum amplitude of a sine wave is 2 V, the minimum amplitude is ________ V. a. 2 b. 1 c. -2…

A: Answer is given below .

Q: For the amplifier circuit shown in Fig. (1), assume B 70, r. (10 Marks) a) Sketch the re-model. b)…

A: ANSWER: Amplifier Circuit:

Q: andwidth of the light for the following wavelength ranges (assume a propagation speed of 2x108…

A: Assume a propagation speed of 2x108 m/sec 1000 to 1200 nm 1000 to 1400 nm

Q: Q2/A 600V voltmeter is specified to be accurate within 2% at full scale. Calculate the limiting…

A: 600V voltmeter

Q: Q.3/ A=175,0) Z= 10 MII Z= 75 11 a. Determine the bias current, /BIAS, given that the input currents…

A:

Q: If the maximum amplitude of a sine wave is 2 V, the minimum amplitude is ________ V. a. 2 b. 1

A: If the maximum amplitude of a sine wave is 2 V, the minimum amplitude is - 2V maximum and minimum…

Q: For the circuit shown, a) If vg = 1 kV and ig = 5 mA, find the value of R and the power absorbed by…

A: a) Given The source voltage Vr = 1 kV The source current ig = 5mA Resistance = R= Vr / ig = 1*103 /…

Q: Light of wavelength falls on a metal having work Photoelectric effect will take place only if hc…

A: Here in this question we have given a  light of wavelength =λ fall on metal having work function=…

Q: If x[n] is input to a discrete time LTI system with impulse response h[n], find the Fourier series…

A:

Q: Write the short answer for the following: (a) What is "Seebeck Effect"? Explain (b) Explain how…

A: a. Seebeck Effect:- In 1821 Thomas Seebeck, a German physicist discovered that when two dissimilar…

Q: A signal x(t) is known to be sinusoidal with frequency 100 Hz. It is sampled by an A/D converter,…

A: the answer is given below:-

Q: Q3 // Obtain the transfer function of the system whose signal flow graph as shown in Figure below.…

A: Given : Given the signal flow graph. The task is to get the transfer function for the given figure.

Q: Q3: b) The characteristic equation of a feedback control system is: s' + 4S? +2S + 2+K=0 Using Routh…

A:

Q: Q.5/ How to change the frequency of oscillation of the following circuit to 10kHz? 0.022 uF 22 k 56…

A: Given:- f=10kHZ R1=22 kΩR2=56 kΩR3=18 kΩc=0.22μF the frequency of oscillation is given by -…

Q: 2. Consider the following R-L circuit: t- to Rs iz(t) V's Vz(t) If to = 0 and initial current…

A: Question :-

Q: 4. An RC circuit has a 5 kQ resistor and a 1 µF capacitor. This circuit is driven by a 100 Hz sine…

A:

Q: A laser beam 1 mm wide is aimed at a detector 1 mm wide 100 m away on the roof of a building. How…

A: Formula for determining the angular diversion of laser before it misses the detector is given below-

Q: During sound digitizing the sound frequencies ranged from  200 Hz to 2.2  kHz. Based on Nyquist…

A: Dear Student, According to Nyquist the sampling frequency should be at least twice of the maximum…

Q: Calculate the voltage Vo using Kirchhoff's Laws, if Vs = 76 and R = 41. R + Vo - Vs

A: Here in this question we have given a circuit in which we have asked to apply kirchoff law.and find…

Q: 2. Consider the following R-L circuit: Rs t= to iz(t) V's Vz(t) If to = 0 and initial current…

A: Question :-

Q: Q1: For the following system: G(s) s2 +s+ 4 Find the response for: 2-Saw tooth signal 1 as period…

A: % solution as matlab code:- sysGs = tf(3,[1 1 4]) % given system sysGs =%3%-----------%s^2 + s +…

Q: 17 Determine the eight-point DFT of the signal x(1) = (1, 1, 1, 1, 1, 1,0, 0} and sketch its…

A: Consider the following signal. Write the expression for 8-point DFT of the signal.  ……. (1)…

Q: x is measured as 11.4 V and Vmin measured as 2.6 V.

A: Solution 2.Ans Amplitude of the carrier signal Vc = 7v Amplitude of the message signal  Vm= 4.4 v…

Q: For the full-wave rectifier circuit shown in Fig. below, assume ideal diodes Find : (i) d.c. output…

A:

Q: If the maximum amplitude of a sine wave is 2 V, the minimum amplitude is ________ V. a. 2 b. 1 c. -2

A: Here in this question we have given a sine wave. And for this sine wave maximum amplitude is 2 V and…

Q: Laplace transform of, signal is represented as G(s) = 1. O Unit Parabolic O Unit Ramp O Unit impulse…

A: Answer: Option D Unit Step

Q: Find the outer radius of a coaxial cable whose characteristic impedance is 10Ω. The inner radius and…

A: The impedance of coaxial cable is calculated using below formula Z0=138* log10(Dd)εr

Q: e given Full-Wave Bridge Rectifier circuit below with capacitor filter, it produces a ripple voltage…

A: It is defined as the circuit consists of two power diodes connected to a single load resistance (RL)…

Q: 1. The damping ratio of a second order system is 0.6. The settling time is 0.75 sec. Calculate (i)…

A:

Q: How many stored carriers are outside depletion region with an ideal abrupt junction silicon diode…

A: Here is the answer :-

Q: QUESTION:4 A 10k2 resistor is to be designed to handle a current density of 50A/cm? when a 5V is…

A:

Q: A uniform Simply-supported beam is found to vibrate in its first mode with the amplitude of 12 mm at…

A:

Q: A beam containing 1000 monoenergetic photons applied to material with a thickness of 0.5cm and…

A: Intensity of light is given by I=I'e-μx  (1) Where: I = the intensity    of photons transmitted…

Q: Q1:ff capacitance between two conductors of a 3-phase line is 8 µF, then * capacitance of each…

A: Q1:lf capacitance between two conductors of a 3-phase line is 8 µF, then * capacitance of each…

Q: 01: A/ For RC electrical circuit shown in Figure R v,(1) 1- Derive the differential equation RC…

A:

Q: Find the analytical expression for magnitude of the system given. 1 F(s) = (s + 2)(s + 4) 1 a.…

A:

Q: Q/ Calculate the area of the radar cross-section (RCS) to a conductive metal sphere by hfss program.

A: Radar cross section(RCS): Radar move phase (RCS) is the degree of a target's potential to mirror…

Q: In a vibration exercise, given that x0-D0 m and v0=1 m/s, x0 and v0 are called: Select one: O a.…

A: % Specify Inital Conditions x0 = 0; % [m] v0 = 1; % [m/s]

Q: A parallel-plate capacitor connected to a battery, with air between the plates. The capacitor stores…

A: The answer is given in step 2.

Q: Given the frequency 24Hz the corresponding period would be a. 87.9ms b. 41.7ms c. 90ms d. 12ms

A: Answer to the above question with calculation of corresponding periods is detailed  in step2.

Q: (a) The logic gate G, and G2 as shown in Fig. have propagation delay of 10 ns and 20 ns…

A: Introduction to Logic Gate: A logic gate is an idealized model of computation or physical electronic…