Answered: For a T.L. of Zo=50 Ohm, terminated…

Engineering

Electrical Engineering

For a T.L. of Zo=50 Ohm, terminated with ZL= 100 Ohm, the value of the VSWR is: O 5 O 2 O 3

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.8MCQ: The units of admittance, conductance, and susceptance are siemens. (a) True (b) False

See similar textbooks

Related questions

Q: Briefly explain about a) Primary transmission b) Secondary transmission c) Primary distribution d)…

A: Transmission: a) Primary transmission: The primary transmission includes the generation of the…

Q: Determine the load currents at 2 0, 14 N, 4 N and 100 Q using Superposition theorem. 2ng 15A 59

Q: Derive the relation of SWR in terms of ZL (load impedance) and Zo (Characteristic impedance)

Q: 1.The primary conductor in the figure is one phase of a three-phase transmission line operating at…

Q: Q) A 50 0 lossiess transmission line is terminated by a load of impedance Zi. The VSWR on the line…

A: We come to know that there exist a minimum at the load end hence reflection coefficient must be…

Q: We say a transmission line is matched when: a) ZĻ=Zo b) Z_=vZo c) ZL=Zo/2 d) Z, =2Z.

A: For a transmission line, two of the most common parameters under consideration are: 1. The…

Q: Connect the system to obtain Y/A (Wye/Delta connection. PRIMARY SECONDARY

Q: Example: A lossy TL has a length of 200 Km and its characteristie impedance is Za 683-j1382. The…

A: Here, we have a lossy transmission line having length of 200 km and the characteristic impedance of…

Q: If a transmission line has Zc =200 0 and the line voltage3D400 kV, then its SIL in MW is: Answer:

Q: 18. The reflection coefficient for the I transmission line shown in figure at P is Transmission line…

A: In the question, What is value of reflection coefficient of the given transmission line.

Q: Q4: Lossless transmission line of 0.25 having Z. ZL = 40 + j 30 . Find the following numerically…

A: We need to find out input impedance and reflection coefficient and standing wave ratio .

Q: a O---------- 6 m 3 m b O- 7 m 3 m C O--------- 6 m a'

Q: A coaxial cable's shiled diameter is 0.4cm and the inner conductor has a diameter of 0.02cm. What is…

A: STEPS: First find the L and C of the cable using Inner and outer diameter Characteristics impedance…

Q: Note: - You are attempting question 6 out of 12 A rectangular surge of 500 kV 3 us travels along the…

Q: -3-phase line conductor 3/5 E the dielectric strength of citical voltage for the line. actor mo=…

Q: a) A 345 kV, three phase transmission line is 100 km long. The resistance per phase is 0.033 2/km…

Q: B 0.5m 0.5m 12m 12m A three phase,50 Hz transmission line with bundled conductors is shown in the…

Q: 5) Choose the correct answer with the explain: a) The maximum power transferred to the load is…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: ng, determine the unknown load.

Q: A generator with Zg = 0.5 + 0.5j and Vg (t) =v2cos(2n*108 t) v is connected via a losses coaxial…

A: A generator with Zg=0.5+0.5j and Vg(t)=2cos(2π×108t) V is connected via a lossless coaxial line…

Q: Z, Source Transmission line Load

Q: 3) Choose the correct answer with the explain: a) The maximum power transferred to the load is…

A: 3. a.) Acc to max power transfer max power id delivered to load when R(thevenin) is equal to R(load)…

Q: A three-phase transposed line is composed of three conductor bundle. The conductors have a diameter…

A: Given A three phase transposed line with its parameters.we need to determine Geometrical mean…

Q: Q: 3 Figure below shows a 735 kV three-phase transposed line composed of four ACSR, 954, 000- cmil,…

A: Given: Geometric mean radius, GMR= 1.173

Q: Problem statement: A three phase 60- Hz, 550- kV transmission line is 300 km long. The line…

A: we have given ;A three phase system frequency f=60Hzsource voltage =550kVlength of transmission line…

Q: For a transmission line terminated with short circuit (ZL=0), the value of Z at (I = N4 )is: * O je…

A: This question belongs to the concept of transmission lines.

Q: 13] A transmission line circuit consists of an air transmission line of length 175.752 and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Match a load of ZL=120+80j Ω to a Z0=100 Ω transmission line using a shunt single stub if the stub…

Q: Q3: A lossless transmission line as shown below. Find Kr, S, and Zin? -1 = 0.352 - Zin Zo = 100 2 ZL…

Q: A long transmission line of 370 N surge impedance is connected to two cables each of surge impedance…

A: According to question we have to calculate the value of junction voltage, current wave and voltage…

Q: 4- We say a transmission line is matched when: a) ZL=Zo b) ZL=Z0/2 5- Expression for a transmission…

Q: If V = 50/0°, v) = 20/90° and VO) = 10/180° V, determine analytically the voltages to neutral Ven,…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Theoretical Impedance Admittance Transmission Parameters Parameters Parameters yı1 A Z12 y12 В y22 D

Q: 100 km, 132 kV, 50 Hz transmission line has per phase resistance R=0.036 (Q/km). The conductors of…

A: Given 100km, 132kV, 50Hz transmission line Resistance per phase R=0.036ohm/km

Q: 2.5 as 20 25 15 10 D 2.5

Q: In short transmission line calculations, the effects of the line capacitance are neglected because…

Q: You are a Power System Design Engineer of a power utility company in Malaysia. You are tasked to…

Q: HowiAlossless TL with charneteristic impedance of z. is terminated in Zr=3Zo use crank dingram to…

A: A lossless transmission line with a characteristic impedance of Zo is terminated in ZL=3Zo . We need…

Q: Z, - Z, = 50n D=0.0742 Zo = 5on Z, = 500 Zy Z, = 750 L=0.0944

A: Solution

Q: c) Enumerate advantages suspension tower has as compared to other transmission line supports.

A: In an electric power transmission line, a suspension tower is where the conductors are simply…

Q: the regulation of line at this pf and at a pf of 0.7 lead, system voltage is 220kV. L Transmission…

Q: mpedance ZL = 90 + j60 N is to be matched to a 75 N line using a single shunt-stub tuner. o designs…

A: Please find your answer below

Q: A 132 Kv, 50 Hz, 3-phase tensmission line delivers loaed of 5omw at 08 lagging Pf. 9, the…

A: For a 3-phase transmission line,Voltage, V=132kVFrequency, f=50HzPower, P=50MWPower factor,…

Q: A Three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of…

A: In this question we will find distance between conductors D with given GMD....

Q: . The relation between impedance and admittance locus is Opposite Mirrored Inversely Reciprocally

A: Impedance is reciprocal to admittance

Q: The parameters of transposed overhead transmission line are given as: self reactance Xs=0.4 ohm/km…

A: Given: For overhead line, Self reactance (Xs)=0.4 Ω/km Mutual reactance (Xm)=0.1 =Ω/km

Q: The power obtained at the receiving end of a transmission line is generally less than the sending…

A: The power obtained at the receiving end of a transmission line is generally less than the sending

Q: Theoretical Admittance Transmission Impedance Parameters Parameters Parameters y11 A Z12 y12 В C y22…

A: It is given that: Z1 = 10 ohms Z2 = 25 ohms Z3 = 50 ohms Z4 = 75 ohms Z5 = 100 ohms Z6 = 75 ohms…

Q: ) To match a load of ZL = 30 (2), to a transmission line with characteristic (f) ( impedance Zo = 75…

A: According to the question, to match a load line, we need to find the distance of the quarter-wave…

Q: impe Z,- 100 2 which is terminated in a load impedance Z, - 50 2 and driven by a voltage source with…

A: Solution- l = 175.75λ i) l=175.75λ…

Concept explainers

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.

Question

For a T.L. of Zo=50 Ohm, terminated with ZL= 100 Ohm, the value of the VSWR is:
O 2
O 3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A load line of infinite length is located at y = 3, z = 5; if ρL = 30nC / m. FindE at a) the origin, b) A (0,6,1); c) B (5,6,1).ANS .: - 47.6 ay - 79.3 az N / m; 64.7 ay - 86.3 az N / m; 64.7 ay - 86.3 az N / m
Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. Determine 1)The capacitance in uF/km without effect of ground 2)The capacitance in uF/km with effect of ground
1. Based on the exercise, what do you understood about STAR connection? 2. What are the relationships between the Line parameters and Phase parameters in Star Connection?
CITE SOME OF THE REQUIREMENTS TO FEED THIS GENERATEDELECTRICITY TO THE TRANSMISSION LINES.
For the figure below, determine the mesh currents ?1 , ?2 and ?3 .
A transmission line having a diameter of 2 cm and ur=5 produces an internal inductance 0.060 uH/m. If it is replaced by an ACSR conductor which has ur=8 with the same size than what will be Lint.
A 3-phase 50 km long single circuit 66 kV transposed overhead line has horizontal spacing with3 m between adjacent-conductors and 6 m between outer conductors. The conductor diameter is2 cm. Find the Inductance per phase. [61.85 mh]
A three-phase 60Hz transposed transmission line has a flat horizontal spacing configuration. The line reactance is 0.486 ohm per km. The conductor geometric mean radius is 2.0 cm. Determine the spacing D in meter.
3-phase 132 kV, 100 km, 50 Hz, single circuit line has horizontal spacing with 3.5 m betweenadjacent conductors. The conductor diameter is 1.2 cm. Find the line capacitance per phase and__charging current per phase.[0.8415 uF, 20.15 A]
help me calculate the Rn, In or Isc, and current at Zc using NORTON’S THEOREM
The resistance and reactance of the single-phase 60Hz transmission line conductors are 7.6 ohm and 6.6 ohm respectively. The transmission line delivers 20MW at a power factor of 0.66 lagging to the load with 54kV receiving end voltage. Determine the following a) The inductance of the transmission line in mH b) Sending end power factor c) Percentage voltage regulation d) Percentage Efficiency