For a trapezoidal open channel, the total discharge is 28 m^3/sec, bed width 6.0 m, side slope 3H:1V, manning's coefficient 0.015, slope of the channel is 0.0005, find water depth, and type of flow. If the channel is replaced with a concrete pipe (n=0.012) and with the same slope of channel, determine the pine diameter for max velocity

For a trapezoidal open channel, the total discharge is 28 m^3/sec, bed width 6.0 m, side slope 3H:1V, manning's coefficient 0.015, slope of the channel is 0.0005, find water depth, and type of flow. If the channel is replaced with a concrete pipe (n=0.012) and with the same slope of channel, determine the pine diameter for max velocity

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A rectangular channel of best hydraulic cross-section, n = 0.016, is laid on a slope of 0.0064 and carries 16.98 m³/ s. For critical conditions, what with is required?
y=2.44m, use the equivalent channel roughness formula when calculating Q
A 10m Rectangular channel passes a discharge of 2 m³/sec/unit width, longitudinal slope 0.0009, Manning's roughness coefficient, n = 0.03. If this longitudinal slope changes to 0.009, find: 1. Normal depth for the two slopes. No wrong answes please 2. Critical depth
Find the base width and water depth of a trapezoidal channel with side slopes of 1.5horizontal to 1 vertical. Manning’s constant n = 0.030. The slope of bed of the channel is 1 in1666 and discharge (flow rate) is 2.7 m3/s.
A trapezoidal channel with 3 meters bottom width, side slope 2H:1V, channel gradient of 0.002, and n = 0.025, carries a discharge of 200 m3 /min. Compute the normal depth and velocity. Given data Wbottom (b)= 3 meters Slope= 2:1 S= 0.002 n= 0.025 Q= 200 m3 /min= 3. 33 m3 /sec Normal depth=? Velocity=? Formula below:
For the channel shown assume a = 1m, b = 3m, d = 2m, w = 8m and n = 0.015, what bed slope is required to have a flow of 16m3/s with a depth of flow of 1.5m? (Fig 10.3.6)
a triangular shaped channel is to be designed to carry 741 L/s on a slope of 0.0152. assuming that the channel is made of timber, n = 0.0178, and use manning's formula. what depth of water )in meters) over the vertex will be necessary to give a section with minimum perimeter (most efficient proporion)?
*hydraulics *use handwritten A rectangular channel 5.50 m wide and 1.30 m deep is laid on a uniform slope of 0.002. The roughness coefficient of the channel is 0.013. Which of the following most nearly gives the savings in earth excavation per meter length of channel that could have been offered by using the most efficient rectangular Section but adhering to the same flow capacity and slope in m^3/s. Choices are A.) 21.04 B.) 13.02 C.) 1.03 D.) 22.63 E.) 0.24 F.)0.67
Determine the section factor (Z) of a triangular channel with right angle corner (900) with a depth of 3 meters.
A trapezoidal channel has a bottom width of 10 ft and side slopes of 2 horizontal to 1 vertical. The bed slope is 0.0005 and n = 0.025. The flow rate is 350 cfs . Determine the normal depth, critical depth, and flow regime. I found the normal depth to be 5.6 ft using mannings equation I found critical depth to b 7606 ft using froude number ratio when it equals 1
determine the (a)depth in m and (b) area in sqm of the economical trapezoidal brick lined channel having a discharge of 1.2 cum/sec with a slope of 0.008. n=0.015.
Find the critical slope for a discharge of 125 cfs in a trapezoidal channel with a bottom width of 3.00 feet and side slopes of 2 horizontal to 1 vertical. The channel is lined with riprap (stones) (n=0.024) and has a slope of 1.00 percent.