For an RLC series circuit, the voltage amplitude and frequency of the source are 130 V and 800 Hz, respectively. The resistance and inductance are fixed at R = 250N and L = 0.35 H. Find the average power dissipated in the resistor for the following values for the capacitance: (a) C = 31µF and (b) С 3 3.1иF. Hint a. The power dissipated in the resistor for C = 31µF is 1.34765 XW. b. The power dissipated in the resistor for C 3.1µF is 1.338995552 X W.

For an RLC series circuit, the voltage amplitude and frequency of the source are 130 V and 800 Hz, respectively. The resistance and inductance are fixed at R = 250N and L = 0.35 H. Find the average power dissipated in the resistor for the following values for the capacitance: (a) C = 31µF and (b) С 3 3.1иF. Hint a. The power dissipated in the resistor for C = 31µF is 1.34765 XW. b. The power dissipated in the resistor for C 3.1µF is 1.338995552 X W.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Similar questions

An RLC series circuit has an impedance of 60 Ω and a power factor of 0.50, with the voltage lagging the current. (a) Should a capacitor or an inductor be placed in series with the elements to raise the power factor of the circuit?(b) What is the value of the capacitance or self-inductance that will raise the power factor to unity?
What is incorrect about the RLC AC Circuit shown? 1 The power dissipation through the (ideal) capacitor is vanishing. 2 The current leads the voltage across the capacitor by 90deg. 3 The voltage across the inductor leads the current by 90deg. 4 If the AC source is replaced by a constant DC source, after a very longtime, the voltage across the inductor vanishes. 5 If the AC source is replaced by a constant DC source, after a very longtime, the voltage across the capacitor will be equal to that across theresistor.
A LC circuit in a radio tuned to 1080 kHz has an inductor with an inductance value of 60 μH and a resistance of 0.25 Ω. a. what is the capacitance of the LC circuit? b. sketch the impedance phasor diagram for the radio. Be sure to label important features of the diagram.
An RLC circuit (has resistance and reactive elements) supplied by a 60Hz power source is found to have a lagging power factor (PF). What can you say about the relative contributions of the resistance (R), XL inductance, XC capacitance & resistance/reactance (ratio) utilized in this circuit at the 60Hz frequency? (min two statements – major reactive element & comparison to Resistive element)
A circuit is designed with an AC source of max voltage 12 and frequency 60 Hz. The circuit has a resistance of 1050 Ohms, an inductance of 0.06 Henrys, and a capacitance of 0.009 coulombs per volt. - omega for source in rad/s? - omegaR for circuit? -XL? -XC? -phi in radians? -Z? -imax?
Solve for the total capacitance from the circuit shown
Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 11.80 Volts and is running at a frequency of f = 147000 Hz. The resistor has a resistance of R = 3910 Ω, the capacitor has a capacitance of C = 4.01e-10 Farads, and the inductor has an inductance of L = 5.97e-03 Henries.Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit ?Ztot = Determine the numerical value of Ztot = ΩDetermine the numerical value of ?Ztot = degreesDetermine the current through the circuit: I(PEAK) = Amps I(RMS) = Amps Determine the voltage across the inductor: VL(PEAK) = Volts VL(RMS) = Volts Determine the voltage across the capacitor: VC(PEAK) = Volts VC(RMS) = Volts If a second circuit were connected in parallel with the resistor, this circuit would be considered as: a high-pass filtera flux capacitor a radio tunera phase…
A 200 Ω resistor, 0.900 H inductor, and 6.00 µF capacitor are connected in series across a voltage source that has voltage amplitude 30.0 V and an angular frequency of 250 rad/s. (a) What are v, vR, vL, and vC at t = 20.0 ms? Compare vR + vL + vC to v at this instant. (b) What are VR, VL, and VC? Compare V to VR + VL + VC. Explain why these two quantities are not equal.
A 20µF capacitor has a sinusoidal voltage across it given by?(?) = 5 sin(500? + 45°) V.(a) Find the phasor representation of the voltage in polar (magnitude and phase) form.(b) Find the phasor representation of the voltage in Cartesian (real and imaginary part) form.(c) Find the phasor representation of the current through the capacitor. (d) If this same voltage appeared across the terminals of a 100mH inductor, what would be thephasor representation of the inductor current?
The phase angle between the input waveform and the capacitor can then be measured using thefollowing equation, sin(ω t) = sin(2π f t) and θ = 2π f t the difference in the phase angle is, ∆(θ) = 2πf∆t, in radians Resistor = 1 kΩ Capacitor = 100nF Peak voltage (AC Voltage) = 2V Frequency = 1KHz Where ∆θ is the phase difference, ∆t is the time difference and can be found as shown in the image below.What is the Value of the phase shift, ∆(θ) =?
An RLC series circuit contains an unknown capacitor, an inductor with an inductance of 40 mH, and a resistor with a value of 16 Ω. The circuit is connected to a 240-V, 60-Hz line. If a current of 8 A flows in the circuit, determine the value ofthe unknown capacitor? Show your work. a) 2.575 uF b) 25.75 uF c) 257.5 uF d) 2575 uF
A series RLC circuit has an inductor that has a value 500 mH, the capacitor 25 µF, and the resistor has a value of 400 Ω. They are connected to an ac power supply functioning at frequency 60 Hz. The peak current is 450 mA a) Find Vmax b) Find the angle by which the current leads, or lags, the voltage. Using your result is it leading or lagging? c) How much power is the circuit dissipating on average?