For simple batch distillation, which of the following can we expect as the distillation time is increased? A) temperature of the still decreases concentration of the heavy component in the still decreases c) more of the heavy component collects in the distillate D concentration of the light component in the still increases E none of the choices

Q: Given the following composition of the fuel gas: 9.2% CO2, 0.4% C2H4, 20.9 % CO, 15.6% H2, 1.9%CH4, ...

A:

Q: A water containing 25 mg/L of phenol is to be reduced using PAC to a concentration of 10 mg/L. The P...

A: Find the value of constant b.

Q: Question: 2. Given The Following Composition Of The Fuel Gas (Table 1 Supplied At 1 Atm, 80°F And 10...

A: Given Fuel gas supplied at (100% RH) T=80F P=1 atm Air supplied at (50% RH) T=80F P=1 atm No exce...

Q: Lthe thermaL eficienciof as turbine decreases if the anbient temberature decreases. True False 2-the...

A: 1. The thermal efficiency of a turbine decreases if the ambient temperature decreases. low temperatu...

Q: he following graph shows the pH curve for the titration of 25 mL of a 0.1 M monoprotic acid solution...

A:

Q: In a tubular reactor, the fluid composition varies from position to position. along its route; conse...

A:

Q: Using a centrifugal pump, process fluid is pumped from the bottom of one distillation column to anot...

A:

Q: 1 Kg of 02 gas occupies a volume of 10°m at a temperature of 300K, so the work needed to compress th...

A: At constant pressure, the work done is obtained from the product of pressure and change in volume. t...

Q: An ideal gas in a closed system starting at 1 bar and 1200 K undergoes a three-step cycle: (i.) isob...

A: In isobaric process the pressure remains constant. In isochoric compression the volume is constant ....

Q: The density of air under ordinary conditions at 25°C is 1.19 g/L. How many kilograms of air is in a ...

A: Given that density of air (d)=1.19 g/L dimension of room=11.0 ft×11.0 ft×10.0 ft  

Q: A tank contains certain volume of fresh water .A stream of brine containing 2 gm/lit of salt fed int...

A:

Q: 01:A homeowner uses 4x10³ m of natural gas in a year to heat a home. Assume that natural gas is all ...

A: A perfect gas is one that follows the ideal gas law. For a perfect gas, the intermolecular forces ar...

Q: As reported the production of nylon intermediates. The separation and purification section for cyclo...

A: The relative volatility is obtain ed from partial pressure and liquid compositions of components pre...

Q: a Prove that Laplace (sin at ) s2+ a2

A:

Q: Which of the following is not considered an equilibrium stage in tray tower separation processe A) r...

A: Given and Find- some options and statement regarding which is not considered as an equilibrium Stage

Q: A heat engine operates between a heat-source reservoir at a T = 535 K and a heat-sink reservoir at a...

A: Given TH=535 K TC=315K ηth=0.38 ηC

Q: Laboratory works were carried out to measure the composition of vapor and liquid of chloroform (1) a...

A: we have to measure Henrys constant and to be plot the graph.

Q: A pure saturated hydrocarbon is burnt with excess air. Orsat analysis of the stack gas shows 7.9% CO...

A: Given, The mole fraction of the components in the stack gas is 7.9% CO2, 1.18% CO, 0.24% H2, 5.25% O...

Q: 600 kW of heat is removed from a heat exchanger with 200 mol/s formaldehyde flowing through. The flu...

A:

Q: 4+3i Divide, 2-i O1+;i 01+ 2i 11 O " + 2i O 2 + 2i

A: A mathematical Expression  and need to simply it  

Q: Consider the following chemical reaction between component A and B: A(l) + 2B(g) → C(g)+ 3D(l) ….....

A: The given reaction is an exothermic reaction Exothermic reaction is one in which heat is evolved. He...

Q: What kind of methods we can use to purify the water of lephalale river

A: Cleaning of river is a very hectic and tideous job. It cant be done through any direct methods. It c...

Q: What is the maximum change in entropy and work that can be produced in a steady state flow process f...

A: Given: 12 moles of nitrogen at 800 K and 50 bar, if the ambient temperature and pressure are at 300 ...

Q: PAir at 1.02 bar and 22°C initially occupying a cylinder of 0.015m3, is compressed reversibly and ad...

A:

Q: The submarine in Question #4 |has now moved to the gulf of Mexico, where the water temperature is Q4...

A: Following values are given in the question Dimension of submarine: Diameter (D)= 12 m length (L)=90 ...

Q: Consider two closed systems A and B. System A contains 2000KJ of thermal energy at 20°C whereas syst...

A: Here , two closed systems are there. A and B .

Q: Q2.A local soap factoryproduces "homemade" soap and the major waste of the process is the salt disso...

A: The component balance of salt is taken into account. The component balance consists of inlet, outlet...

Q: 19. a 1.99 kg of gas (R= 428.6 J/kg=K) undergo a non-flow isometric process from 577.7 kPa and 57.15...

A: Given Mass of gas m=1.99kg R=428.6 J/kg-K P=577.7 kPa T=57.15 °C  P=1765.46 kPa Heat added=119 kJ/s...

Q: i need help with this question  asap

A:

Q: A fuel containing 75% ethane and 25% propane is burned with dry air. All the H subscript 2 burns to ...

A: Given Fuel=75% ethane+ 25% propane Products-H2,H2O,CO2 and CO CO2/CO=10/1 Excess air=15% Find a. M...

Q: Q: The weight density of oil is (0. 8 KN/m3) if the relative density of oil is. . 0.08158 8.158 81.5...

A: Given:  Weight Density of oil =0.8 KN/m3 we know that, 1 N/m3  = 0.10197 kg/m3 KNm3 = 1000Nm3 =101.9...

Q: It was found that, Van Laar model fits the behavior of the system at temperature and pressure of 65 ...

A: Van Laar model is a thermodynamic activity model. The model is empirical model and used for correlat...

Q: Question 7 Soft and non-abrasive materials can be made into fines by A Cutting (B) Attrition Compres...

A:

Q: Q1/A catalytic dehydrogenation process shown below produces 1,2-butadiene (C,H) from re normal butan...

A:

Q: 'A. Calculate the pressure of steam at a temperature of 500°C and a density of 24 kg/m³ using (a) th...

A: Given: T = 500oC = 773 K Density = 24 kg/m3, Molar mass of steam (water) = 18 kg/kmol R = 8.314 J/mo...

Q: Q2: A nozzle is a device for increasing the velocity of a steadily flowing fluid. At the inlet to a ...

A:

Q: When you convert a certain value of ° C to ° F, you have found out it is just simply numerically the...

A: When we convert into Degree to Fahrenheit then we have to multiply the temperature in degrees Celsiu...

Q: As reported in the production of nylon intermediates. The separation and purification section for cy...

A: Azeotropic mixtures can be observed in chemical , pharmaceuticals industries. The system is said to ...

Q: Determine the concentration of a 187 L solution that contains 0.33 moles of NaCN. - report answer ou...

A: Given Volume of solution=187L Moles of NaCN=0.33 Find Concentration of NaCN

Q: c) Ifa species A diffuses in z-direction at unsteady state condition with homogeneous reaction, dete...

A: Write the expression for the diffusion of A  as follows: NAz = -DABdCAdz     ......1   Write the mat...

Q: Q4: The process shown in figure below is the dehydrogenation of propane (C3HS) to propylene (C3H6) a...

A: The conversion of propane percent given is the conversion per pass. The flow rate balance is applied...

Q: A fluid of unknown density is used in two manometers - one sealed-end, the other across an orifice i...

A: To measure the pressure difference between two points we use manometers. There are two types of mano...

Q: What is the value of the Langmuir constant "a"? *

A: Isotherm explains the change in amount of adsorbate with change in concentration. Langmuir adsorptio...

Q: (b) Sketch the schematic diagrams of three characteristics stress-strain behaviors for polymeric mat...

A: The schematic diagram of the stress-strain behavior of a polymeric material is shown below:

Q: 2. A chromium metal was deposited coming from a solution of Cr*3. The amount of the said metal depos...

A:

Q: PART IV: Determine either the decay constant or the half-life of in each of the following. Present y...

A: To fill up the missing values in the table on half life and rate constants 

Q: Exercise (Given the equation) 1, A + 2B →c

A: Given equation, A+2B→C (a) rate of reaction of different components is given by, (-rA)=-1VdNAdt(-rB)...

Q: Q3 (a) Describe the engineering concept that occurs when syrups or sweeteners are added to brewed co...

A: Dear user! Please note that in view of the nature of this question, there is no relevant diagram or ...

Q: The rate law for the reaction A +3B →C + 2D +E in an inert solvent (liquid) has been found to be (-r...

A:

Q: Giving the importance of Hydrogen as Fuel of the Future and the basis for classification of the thre...

A: 3 main types of hydrogen are: 1) Grey Hydrogen: The most common form of hydrogen, it's created from ...