For the admittance locus shown below, if Vs=10Cos4t Volt. Find the * ?maximum power delivered to the circuit C- jB Y3 AB=BC B 0.5 Y2 450 G Yc A 25 W 40 W 50 W 30 W O

Q: For the given network below, determine the current through the 1-kn 1 kN - j4 kN + 6 V. 10 VZ 0° 2…

A:

Q: 2. Find the value of RL for maximum power transfer in the network and the maximum power that can be…

A:

Q: Dr. Kanaan A. Jalal University of Technology/ Dept. of Electrical Eng. H.W Q.) For the circuit…

A:

Q: I 0° A j1 n 4/0°A -j2 0 V 20 (1) 2/0° A 20 Using Mesh-Current Method., if I = 12.4 A, the value of…

A: The correct solution can be achieved as follows.

Q: 6. Find the current lo in the network below using Thevenin's Theorem 10 1220v V,07 j10 ll j10 le 10…

A: In this question,  We need to calculate the current Io  using the Thevenin theorems.  Here one is…

Q: 2. a. Find 11, 12, and Vs b. Find Va, Vb and Vc a 11 12v C + 1 ww 2002 ww 1502 Vs b 12 + 1 2 A www…

A:

Q: 142 I j 402 木-jis 5or 136 20°V 土 主 4052 los2

A:

Q: 2420°v -j20 I2 I3 j20 le 12430°A 30'a I4 -j427 d For the following ac networks, determine, using the…

A:

Q: Find the value of R for maximum power transfer in the network and the maximum power that can be…

A:

Q: Use source transformation method to find the value of the current flowing inside the vo ? 20 2 0.4…

A: To calculate the value of current through vo i.e 80 ohm resistor

Q: 2. In the circuit, find the value of Z, that will absorb the maximum power and the value of the…

A:

Q: the circuit given below; O Find the value of Z that will result in the maximum power being delivered…

A: The explanation is as follows.

Q: For The Given Table Find y[n]=x1[n]*x2[n] x1[k] -5 -2 + 1.7321j -2+1.7321j x2[k] 3 -4.5 - 4.3301j -…

A: The given sequence x1(k) and x2(k) are the discrete fourier transform of sequence x1(n) and x2(n).…

Q: 21 For the circuit above, if v(() = 100cos(8r) V, R, = 200, R, = 40 0 L-5 mH, and C- 300 mF, answer…

A: In the circuit A wattmeter connected to the circuit to measur the power as shown in the figure.…

Q: 2000/ 4 ΚΩ 3 kM RL 15 V 6 ΚΩ In the circuit shown above, determine the maximum power that can be…

A:

Q: 2. Given the information of the network shown below: L = 0.153 H, C = 0.3183 mF, lz = 5 2 60°A, and…

A: Given that frequency of the circuit is 50Hz. The inductor and capacitor reactance is written as…

Q: Use wye to delta transformation to obtain the equivalent resistance, ohms, at the terminals a-b. *…

A: In this question we will find equivalent resistance using star delta transformation.....

Q: For the circuit shown, find the value of coupling coefficient "k" when the total consumed ?power is…

A: Given circuit, Total consumed power, P = 450 W

Q: 60mH 0.35: For the mutual electnc arcuit shown in figure beside if Vs=10cos100t Volts, write the set…

A: In this question,   We need to write the mesh current equations of the given circuit?.

Q: • 3- Find the Thevenin's equivalent 14 V 142 ww IA ЗА 52 ob www ww

A:

Q: Q3\ For the network shown in Figure, Where is = 4 cos (600r) A and v = 110 cos (600f + 30º), Find:…

A: The given question can be solved by writing the KVL equations in the two loops. The obtained…

Q: Find the current 12, voltage VL and the power dissipated across RL in the circuit given below. X13…

A: In this question,  Find the power across the load.  Power P= I2 RL  Watt Current I2 and voltage VL?…

Q: Compute the Thevenin impedance and voltage for the equivalent circuit shown given that the…

A:

Q: Find power factor of given circuit (1) 1/2 (2) √/2 120 V, 50 - Hz T R = 60 92 L=0.6 H (3) -/-/ www…

A:

Q: 12 420°A 1220°v Io Ix j10 j10 12 2Ix A,079

A:

Q: 10. Use KIRCHHOFF'S LAWS to determine the branch currents of the circuit shown below. IOLGOʻV P. 202…

A: Step 1: Apply KCL at node b By KCL ,…

Q: 0 Find the current at in the ff circuit. 145 17 31: 100V 5N 45

A:

Q: If Zth=2+j5 then Z, that have maximum power must be -2+j5 Select one: O True False

A: Given: Thevenin's impedance Zth=2+j5. Load impedance for maximum power, ZL=-2+j5.

Q: Use the nodal analysis to find voltages Va, Vb, Vc, Vd. 20 Ω Vb im ww 10 2 502 ww . + Vc * İz 10 A…

A: A circuit diagram is shown below. Find Va, Vb, Vc, and Vd by using nodal analysis.

Q: 4000 2 kn 3 kn V. + 1 mA 3 kn

A:

Q: Find X Z, I, VR Vcand don't forget to put their units. Source voltage 115260 12.5 kQ 3.5 kQ 140 μF

A: According to question: Note: As the frequency of supply is not given in the question so assuming the…

Q: A 1002 transmission line with T = 0.447Z63.5°. Find Z1. Select one: a. 25 + 25j О Б. 25 — 25j O c.…

A: consider the given question

Q: w - 500 rad/s IL = 2.540° If and v, (t) find + 25/-30° V – 10 N v,(1) 25 N 20 mH lle

A: The inductive reactance is given by: XL=jωL=j500×20×10-3=j10 Ω The voltage across inductor is given…

Q: Find l in the network using Norton's Theorem. I 12 -j22 2.5IA 30 20230°v j42 ll IA

A: Norton's theorem :

Q: Answer the given problems. Submit your solution in pdf form. Activity no. 3. Combination of…

A:

Q: Find the current in the circuit. www 20 Ω 120V I 40 92

A: Given circuit:

Q: Figuie: 12 I1 3/2 2 V2 Va 2180F 1090F for the in figure Find Y12 network

A:

Q: Solve for the following using the circuit shown below: a) Z parameters b) A,B, C and D values 1₁ 12Ω…

A: In this question,  We need to determine the Z parameters and ABCD parameters of the given network.…

Q: For the network shown below, determine a) re b) Zi c) Zo d) Av

A: The solution can be achieved as follows.

Q: Calculate the voltage and the current between terminals A and B of the circuit shown by: (a)…

A: network theory problem.. Look below for the explaination..

Q: a 20 2420°v A I1 Iz -j1Q j10 le b 20 -ji0 30 A I4 Is

A: Given

Q: Q.2) By using Mesh theorem find (lo) 20 5A 4$2 ww 16 60 3l6 10 V ww

A:

Q: 220°A 220v 10 Vo 10 Ix 21x -jia7

A:

Q: Use the concept and principle of Kirchhoff's law to calculate I, lz and I, if V, is 36 V; V, = 12 V;…

A: Given  Voltage is V1 = 36 V Voltage is V2 = 12 V Resistance is R1 = 4 ohm Resistance is R2 = 8 ohm…

Q: For the network shown, find Zab and I,. k = 0.5 4Ω a ΙΩ ww 0.5 F 12 sin 2t V IH 2H 2Ω ll lll all

A:

Q: For the circuit shown, the following mesh currents are given: IA=1.92Z 2.10 A IB = 1.30Z -2.12 A Ic…

A: we need to determine the voltage VB.

Q: Use mesh analysis to obtain i, in the circuit below 60V 40 13 i1 i0 20 = 120V 100 12 40A

A: Redrawing the circuit diagram,

Q: j4 N 4 2 20/0 V j2 2 ZL ll

A:

Q: 3. In a given R-L circuit, R = 3.5 N and L = 0.1 H. Find a) the current through the circuit and b)…

A:

Q: Q.2) By using Mesh theorem find (lo) 22 5A 20 ww 60 10V ww ww

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.