For The cable shown. Find the angle 02.at segment AB h A 2m B 3KN 2m www 1.5 m 0₁ 8 KN D 2m 2m
Q: A contour map of the lake was prepared as shown below. The area bounded between contours are given…
A:
Q: The roof is made from what type of precast concrete element? Single Tee beam Double Tee beam Solid…
A: Precast concrete: A concrete member that is cast and cured at a location other than its final…
Q: In the following photo, identify the type of footing that is being installed. Photo D: Photo D:…
A: Given data in question Footing picture To find out What type of footing is used there
Q: At a point on a streamline, the velocity is 3 m/s and the radius of curvature is 9 m. If the rate of…
A: Given Data Velocity (V) = 3m/s Radius of curvature (R) = 9m Rate of increase of velocity along…
Q: A ŢI 105 20 B mx 73m 13m | 1.5m x Compute 1.5m a) Fixed-end moment b) distribution factor C) moment…
A:
Q: The depth of water flow at a section of a rectangular channel of 4m wide is 0.5 m. This discharge…
A: Given data- A rectangular channel- width of the channel B=4 m, Depth y1 =0.5 m, Discharge Q=16 m3/s,…
Q: To hang a statue with a mass of 102.06kg, you will be using a slender cable made of a steel alloy. A…
A: Note : As per guidelines, I will solve first 3 parts of the question. Mass of statue= 102.06 kg =…
Q: Course AB BC CD DE EF FG Total: Distance 235.1 243 241.2 235.2 271.4 253.5 Bearing S563 E N 85 15' E…
A: To determine- Compute the table
Q: 4) Wire is being drawn at a constant rate from a spool by applyin vertical force P to the wire as…
A:
Q: 1. What is the unit weight of aggregate? 2. How do you calculate void content of aggregate? 3. What…
A: 1.The weight or mass of an aggregate needed to fill a container with a given unit volume is its unit…
Q: a non • sprinklered fire compartment temperature of 1170° F, what is the pressure difference at For…
A:
Q: The soil below is a dense well-graded clayey sand with Ya = 112 pcf and G₁ = 2.63, a permeability k…
A: Given : γd = 112 pcf Gs = 2.63 Permeability k = 240 mm/min e = 0.85 Cross sectional area = 36 ft2…
Q: the continuous beam shown, it carries a uniform load from A to B and a uniformly varing load at B to…
A: Given Data Find a. Fixed end moment b. Distribution factor c. Moment at B. Using Moment…
Q: 3) Use two (2) decimal places in all your answers 4) Stiffness factor (K) and distribution factor…
A:
Q: 4.0 m 1.50 kN/m
A:
Q: For the laminar flow of an oil having dynamic viscosity, μ = 2Pa in a 0.5 m diameter pipe, the…
A: Given data- Laminar flow- Dynamic viscosity of oil- μ= 2 Pa, Diameter of the pipe D=0.5 m, Parabolic…
Q: For the data shown in the table below find AWT, ADT, AADT and AAWT. Total Weekday No. of Weekdays in…
A: Month No. of weekdays in a month (days) Total days in month (days) Total Monthly Volume (Vehicle)…
Q: An oil of specific gravity 0.9 contained in a vessel. At a point the height of oil is 40 m and for…
A:
Q: Use superposition method to solve for the reactions at A, B, C. where EI is constant. Draw the shear…
A: Given: Required Support reaction and shear and moment diagram
Q: This is a question from slope stability bishop method Please Note i am not asking for the entire…
A: Data given Bishop Circle method of analysis
Q: 2. A 2m B 30kN 2m с 10kn/m 4m D 3m 15 kN/m E
A: Concept First we will calculate the reaction at supports.At every section we will calculate the…
Q: A structure as shown in the figure is hinged at A and rests on a roller at C. In using Castigliano's…
A:
Q: Homework: Determine the displacement and slope of point (C) of the beam shown below. Take E 200 GPa,…
A:
Q: a) A PFR has a conversion of A of 90% (i.e. C = 0.1C), and the reaction is first order. If a…
A: Given, Dispersion number = 1 % conversion = 90%
Q: For each of the building properties listed below, identify which parameter from the base shear…
A: To find: Which parameter from the base shear equation will apply to the Weight of the building?
Q: A parabolic vertical crest curve connects two road segments with grades +1.0% and -2.0%. If a 200 m…
A: Given data : G1 = +1.0 % G2 = - 2.0 % Stopping sight distance = 200 m Height of driver = 1.2 m…
Q: Which seismograph has higher amplitude shaking? A Seismograph A Seismograph B They are the same…
A: Seismograph: The motion of the ground caused due to the earthquake is determined by the seismograph.…
Q: Tisha owned a rectangular lot in their province. The given values below are the sides and…
A:
Q: Problem 1: A -3% grade meets a +5% grade near an underpass. In order to maintain the minimum…
A: Answer (a) Calculation of the elevation at station 10 + 040 Elevation at B (station 10 + 040) =…
Q: Explain the terms human cognitive and perceptual capabilities and how they impact on safe design of…
A: Brief concept introduction- Human cognitive- It is the process of learning and understanding…
Q: A pump with an efficiency of 80% is used to draw groundwater from a well for Irrigating a flat field…
A: Given : Efficiency = 80 % Area = 108 hectares base period = 120 days and Delta = 144 cm This is a…
Q: Problem 1. Draw the shear and Bending Moment Diagram of the beam shown. Use the Method of…
A: Given Data Find the support reaction using superposition method and draw shear force and bending…
Q: A bar obtained by bonding together pieces of steel (E = 29 x 106 psi) and brass (E = 15 106 psi) has…
A: Given : Es = 29 X 106 psi Eb = 15 X 106 psi M = 40 kip-in. This is a problem of Solid mechanics…
Q: A strip load of q =53 kN/m^3 is applied over a width B =11m. Determine the increase in vertical…
A: A strip load of q = 53 kN/m2 Width, B = 11 m Depth, z = 4.6 m To determine the vertical stress due…
Q: 3. Find the value of El midway between the supports for the beam shown. Use the Super Position…
A:
Q: SITUATION t is in seconds and x is in meters. Determine the time at which the acceleration is zero.…
A: GIVEN : X =( -2 + 3t ) e-0.5t TO FIND : time ( t ) where acceleration (a) = 0
Q: In the soil profile shown, compute the vertical effective stress at points A, B, and C?
A: Effective stress is defined as the ratio of force at contact of particles of soil to the total area…
Q: [(2x - (2x - x²) sin x dx
A: Given: Expression for integration
Q: 30 KN/m 6 m
A: Given To Find Maximum deflection of beam
Q: A nozzle is a device for increasing the velocity of a steadily flowing stream of fluid. At the inlet…
A: Reference : Fluid mechanics Given : Specific enthalpy, velocity at exit and inlet. To determine :…
Q: In writing the station, no space between the numbers and the plus (+) sign. Example: correct:…
A:
Q: Find the magnitude of the force PROJECTED on the U and V axes
A: Given Data Find the components of F on the U and V axis.
Q: X. Area by Triangle Point H is the middle portion of a four-sided tract of land and reads directions…
A: Data given Find: Area by triangles
Q: In a certain portion of road to be constructed, the following data were taken. Station 1+ 0 20.00…
A: Given for station 1+0206.85+2.3 0+1.5 6.39+1for station 1+0706.0+2.0 0+1.…
Q: Find the value of Elō midway between the supports for the beam shown. Use the Super Position method.…
A:
Q: Show a complete solution. Classify each of the structures as statically determinate or…
A: To classify the each structure-
Q: Homework: Determine the displacement and slope of point (C) of the beam shown below. Take E 200 GPa,…
A: A simply supported beam is given as shown in the figure above and it has been asked in the question…
Q: 2) Draw the shear and moment diagrams of the beam shown below. Determine the maximum absolute values…
A: Given Data
Q: Using either formula, double integration method, or area moment method, determine the maximum…
A:
Q: The beam is built in at both ends and loaded by a distributed load which has the constant intensity…
A: Solution: Convert the UDL to point load for the given beam:
Step by step
Solved in 3 steps with 3 images
- Determine the angle ø (0°≤ø≤90°) between cables BA and BC so that 500N vertical force has a component of 250N which acts along cable CB, from C to B. Set angle = 60°Determine the total length of cable, If y=20m. a.) 177.809 KN b.) 176.089 KN c.) 175.980 KN d.) None of the above e.) 178.908 KNThe W (newtons) traffic light is held up by the same cables, AB and BC. 2.50 N/m each. Determine the shortest possible possible length of each cable and the corresponding vertical distance h if the maximum allowable horizontal force exerted by a cable on a vertical post is 600 N. P (in kN) or W (in N) = 516 Thank you in advance.
- Use Channel Section: C7x12.25X = 193 Y = 93 A = 2 B = 7 C = 9 What is the force in cable BC? What is the force in cable AB? What isthe force in cable AD? What is the angle of inclination in degrees of cable BC with respect to the horizontal axis?The horizontal boom OC, which is supported by a ball-and-socket joint and two cables, carries the vertical force P = 8 kN. Neglect the weight of the boom. 1. Which of the following most nearly gives the tension in cable AD in kN? a. 12.77 b. 15.66 c. 18.61 d. 9.150 2. Which of the following most nearly gives the tension in cable CE in kN? a. 4.512 b. 7.01 c. 8.91 d. 3.51 3. Which of the following most nearly gives the reaction at point O in kN.? a. 6.32 b. 5.81 c. 14.71 d. 13.96
- X = 193 Y = 93 A = 2 B = 7 C = 9 Whatistheforce in cable AH?(kN) Whatistheforceincable AE?(kN) WhatistheforceincableAB?(kN) What is the force in cable CB?(kN) WhatistheforceincableBD?(kN)Determine the distance "x" on the loaded cable as shown in the figure. B= 200N C= 300NDetermine the Tension in Cable "Ta" if Td=300kn.
- X = 193 Y = 93 A = 2 B = 7 C = 9 What is the force in cable DF? What is the force in cable DE? What is the force in cable DC? What is the force in cable CA? What is the force in cable CB?bearing : N29°Wa 1000n block is suspended on a string that makes an angle of 40 degrees with the vertcal. find the tension in the cable?