Question

For the circuit below, use superposition to find i. Calculate the power delivered to the 3-Ω resistor. (circuit is displayed in attached picture)

For the circuit below, use superposition to find . Calculate the power delivered to the 3-Ω resistor.
1 2
4Ω
2Ω
3Ω
Expand
Transcribed Image Text

For the circuit below, use superposition to find . Calculate the power delivered to the 3-Ω resistor. 1 2 4Ω 2Ω 3Ω

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: A 69-kV, three phase short transmission line is 16km long. The line has a per phase series impedance...

A: We need to determine the sending end voltage, voltage regulation, the sending end power, and transmi...

Q: 4. Find the current I assuming ideal diod es 1.2k2 10V (+ 15%4 12V+ 3V

A: The given is redrawn as shown in Figure 1.

Q: Problem 2 question 2

A: In this problem, It is said that the value of R1, R2 and C should be physically realistic value such...

Q: .il Verizon LTE 7:42 PM 100%- Done 2- In the following circuit find ve) and i(t) given; y(1)-240 V ,...

A: We have been given with below values: -v1(t) = 240V, v2(t) = 120V, L=1H, C = (1/16) F and R=2 Ohm fo...

Q: A single phase overhead transmission line delivers 4000 kW at 11 kV at 0·8 p.f. lagging. If resistan...

A: The equivalent circuit diagram is as follows:

Q: When you are converting an instantaneous current to a phasor, how does the phase angle being positiv...

A: The overall solution depends on the phase angle or epoch (initial phase) of the instantaneous form o...

Q: he follo miny Cu nd R omptete ミ? 2 2. /2 レ

A: Click to see the answer

Q: .il Verizon LTE 7:42 PM ร์ 100%- Done 3- In the following circuit find vc(t) andi,(t) given; v,(1)-2...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: Sketch the derived result for Vout(t). Clearly labeling your initial voltages and time constants for...

A: From the given figure, apply KVL rule,Take Laplace Transform of above equation,Take  as common from ...

Q: A single phase transmission line has two parallel conductors 1·5 metres apart, the diameter of each ...

A: Given,The spacing between the two parallel conductors is,

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of ...

A: Given,The length is 15 km.The inductive reactance is,

Q: How would I sketch the output waveform and calculate the frequency of a op-amp / signal generator?

A: Operational amplifier is a device which is linear and is capable of ideal DC amplification and is th...

Q: If we want to have a Q+ state of 0, which of the following input combinations would work for a DFF w...

A: The table which gives input combinations with knowing the present and next state is called as excita...

Q: Resistor Color CodeWhat Color Code would a 30Ω ±5% look like?

A: Use color code table to obtain the desired result of your problem: -Let us consider a resistor have ...

Q: KCL Iav 2N 0sv Soue the curcut gnd

A: The circuit diagram is shown on the board:

Q: Ii

A: Redraw the circuit in s domain as shown in Figure 1 to obtain the required values.

Q: Feedback Control of Dynamic Systems (7th edition) - Problem 7.19

A: Click to see the answer

Q: The three conductors of a 3-φ line are arranged at the corners of a right angled isosceles triangle....

A: The conductors are at the corners of right-angled isosceles triangle. So, the distance between the c...

Q: Ql: a) A set of reading obtained in an experiment is 49.7. 50.1, 50.2, 49.6, 49.7 determined: 1- Ari...

A: As this question has many sub parts, so I will be answering the first five sub-parts of Q1. a.   In ...

Q: A load of 1000 kW at 0·8 p.f. lagging is received at the end of a 3-phase line 20 km long. The resis...

A: Given that:

Q: In the following circuit, use either differential equation approach or the step by step method to fi...

A: Figure 1 shows the modified circuit when t < 0.

Q: 3.45 Find current i in the circuit of Fig. 3.91. ML 492 8 92 4 A 2Ω 6Ω ts 30 V (+ ΙΩ Figure 3.91

A: There is a current source in the given circuit. So , we are applying nodal analysis.

Q: How was the value of the capacitor derived?

A: Click to see the answer

Q: In the following circuit, use either differential equation approach or the shortcut method to find i...

A:  The current i0(t) is to be calculated in the following circuit: -

Q: une nodal amolipis to Soue the euit omol vo bupe loop ondly sij ho sohe hme ardu and iud Vo S Vo Sl ...

A: This problem will be solved by the application of Kirchoff's Voltage Law and current law. According ...

Q: a the following circuit find i,o 1-0 t= る(t) 1н =0 ЗА

A: We first find the initial and final values. Let us say that the voltage across the capacitor is v(t)...

Q: A 3-phase line 3 km long delivers 3000 kW at a p.f. 0·8 lagging to a load. The resistance and reacta...

A: Click to see the answer

Q: e lar Cov depemaent Source loiC나 VTR 3 /2 3另

A: Follow below steps to obtain the result: -Apply Kirchhoff’s voltage law in the loop and solve as bel...

Q: 93uF 7 L 301 3302 5 Pa ssband ain190 vj İVJ I got the exact ftsl98.0549Hz- vil is the Voltage gan Va...

A: Write the expression to find exact value of lower cutoff frequency for the given circuit as follows:

Q: o dem JL ЗА No

A: Part (a): Refer to Figure as shown in the part (a) of the given question.According to the Maximum po...

Q: The circuit in the attached image has voltage gain |VL|/|Vi|=170 What is the voltage gain |VL|/|Vi| ...

A: The voltage gain for given circuit needs to be determined.

Q: Find in e rut 3 2 12A T.F

A: Since, the given circuit diagram is as shown in the figure 1:

Q: Figure 3.60 For Prob. 3.11. 3.12 Using nodal analysis, determine V, in the circuit in Fig. 3.61. 40 ...

A: Nodal analysis depends primarity on the application of Kirchoff's Voltage Law (KVL). The circuit men...

Q: 15.3 Determine the erection sag and tension of a transmission line at 65°C in still air. The line ha...

A: It is given that:

Q: i Gu Pevse use Modol or mesn 10 A 2 Thearen 2Ω 12 10

A: Let us apply supernode at nodes 1 and 2:

Q: 1. FIGURE 52 shows the one-line diagram of a simple three-bus power system with generation at bus I....

A: Convert the line impedances into admittances, using Y=1/Z 

Q: Three conductors of a 3-phase overhead line are arranged in a horizontal plane 6 m apart. The diamet...

A: The capacitance of each conductor to neutral per 100 km of the line should be calculated as: -

Q: The switch in the circuit seen in fig. p7.52 has been in position a for a long time. At t=0, the swi...

A: Figure 1 shows the modified circuit when t < 0.

Q: A substation receives 6000 kVA at 6 kV, 0.8 p.f. lagging on low voltage side of a transformer from a...

A: The single line diagram of the system is shown below:

Q: 2Ω 4Ω 1H3%(t)に0 - 2A

A: When t < 0, the inductor acts as a short circuit. Let us say that current through the inductor is...

Q: Find i(t) and v(t) for t >0 in the circuit in the figure attached.

A: Write the general expression for unit step function,

Q: A single phase transmission line is delivering 500 kVA load at 2 kV. Its resistance is 0·2 Ω and ind...

A: Given,The inductive reactance is,

Q: 1 99% 7:50 PM l Verizon LTE Done 12- Find i(t) and v(t) in the following circuit. You may employ any...

A: Figure 1 shows the modified circuit when t < 0.

Q: Electrical Engineering Question

A: Part (A):Given data,

Q: please could you help me to find the solution of  question (b)

A: The output of each meter should be determined.

Q: Use source transformation to find vo in the circuit below. (Circuit is displayed in attached picture...

A: Consider the circuit diagram given, we can transform the voltage source with series resistor into an...

Q: Show that the system shown in the figure below oscillates at a frequency of 1 rad/sec.

A: This is a unity negative feedback system. For this system to oscillate at some frequency, we need tw...

Q: Examiner lecturer: Hawraa Qasim Date: 16/4/2018 unleridtions&Measurements Division: Electrical Engin...

A: (a) Dynamometer:This is type of measurement device that is used to measure voltage, current, and pow...

Q: Q1: a) Discuss the effect of earth on the capacitance of a line : b) Derive in expression for the ca...

A: (a) The earth can be considered as a conducting infinite equipotential plane. The electric flux line...

Q: 11- Find i (t) in the following circuit. You may employ any method you wish t = 0 22 22 24 V (t)

A: First calculate the current just after the switch is closed.Capacitor behaves as a short circuit jus...