For the circuit shown in below figure, find v and the power absorbed by the resistor? 15 mA a. 90 V and 675 mW b. 45 V and 675 mW c. 5 V and 675 W Od. 45 mV and 675 mW 3 kn

Q: a) reduce the block diagram into a unity feedback system configuration as shown in Figure 1(the 2nd…

A:

Q: Find the complex Fourier series and the THD of the signal of a half-wave rectification with…

A:

Q: 5. What is the electric fiel F=(3.07-3.97)×10 N

A: Given data, Force is given F=3i-3.9j×10-3 N. Charge is given q=1.25 μC.

Q: Construction, Operation & E... The relative speed of rotor with respect to stator magnetic field of…

A: Given- 3-phase induction motor, Frequency f=50 Hz, Number of poles P=4, Slip S=0.05, To Find- The…

Q: G₁-2; G₂-7; G₂-6; G₁−3; G₂=2; G=3; Gy=6; Gg=5; H,−0.7; H₂−0.1; H₂=0.3; H₂=0.5; !!! Not: Her bir…

A:

Q: 9V In the circuit shown in Figure R₁ 1.50 R₂ 30 40-2A ↓ K(C) L 0.2 H a. find current i(t) for t≥ 0.…

A:

Q: Determine the voltage gain of the OTA in Figure 14-56. Assume K = 16 μS/μA for the graph in Figure…

A:

Q: ауа А здокаже, 5 ир, 208V, 4- pole, бона, Дм Subjected to No-load test at 60 Hz and The results was:…

A:

Q: The value of Z in Figure, which is most appropriate to cause parallel resonance at 500 Hz, is 592 ww…

A: Given circuit- In parallel resonance frequency, f = 500 Hz.   To find- The value of Z.

Q: II. Design and plot the circuit diagram of the oscillator indicating all components values. Given…

A: ii) The Generalized circuit of the LC oscillator can be drawn as…

Q: Let m(t) is sinusoidal Wave form mct) = Am cos Wmt Determine The frequency Spectrum modulation…

A:

Q: (a) A series RLC tuning circuit is excited at its resonant frequency of 50 MHz by 10V peak…

A: Quality factor of series RLC circuit is given by Q=(1/R) sqrt(L/C). If the internal resistance is…

Q: What is the frequency of a waveform that has a period of 8 ms? A) 1.25 KHz B) 12.5 Hz C) 1.25 Hz D)…

A: Given: In this question, the given details are, The given period of time is 8 ms. To find value of…

Q: esday Determine the Laplace Transform of the folling Signals: a) Cos (3t) u(t) -lot u(t) c) etas(2E)…

A: “Since you have posted multiple sub parts,we will provide the solution only to the first three sub…

Q: Can you receive an analog input from a digital pin?

A: The digital pin in particular accepts any kind of input, but gives the true output only for digital…

Q: نلا - ot =) 2-26 (ع) (1 - 2) UUe).

A: Given the signal d= x1(t)=e-10tcos(3t-1)u(t) Find Laplace Transform L[x(t)]↔X(s) L[e-ctx(t)]↔X(s+c)…

Q: 220 kV, 50 Hz, 200 km line has its conductors on the corners of a triangle with sides 6 m. 6 m and…

A:

Q: ge Aşağıdaki denklemlerden doğru olanları ve yanlış olanları yanlarına belirtiniz. Please indicate…

A: In this question We need to choose the correct option.  Check the Given equations are incorrect or…

Q: A galvanometer with a full scale current of 10 mA has a resistance of 1000 Ω. The multiplying power…

A: Given: A galvanometer with a full scale current, Im = 10 mA. Meter resistance, Rm=1000 Ω Shunt…

Q: Evaluate the controllability and observability of the following systems by making appropriate…

A:

Q: An alternator rated for 490 kVA, 3.3kV, 10 poles, 3 phase, 50 Hz, Delta connected has 182 term per…

A:

Q: Determine the trigger points for the Schmitt trigger in Figure 14-59.

A:

Q: 2. A charge of -0.3 µC is located at A (25,-30, 15) cm, and a second charge of 0.5 µC at B (-10, 8,…

A:

Q: Find VC(s) using partial fractions.

A:

Q: a. Determine the low cutoff frequency for the overall cct. b. Determine the High cutoff frequency…

A: The frequency response of the amplifier circuit can be calculated by using the DC and AC analysis of…

Q: A center-tapped transformer full-wave rectifier has a secondary voltage of 30 Vp. If the diodes used…

A: Given: Secondary Voltage, Vm= 30 V Load Resistance= 500Ω Internal Resistance = 1Ω

Q: 1 Construct a table similar to Table 16.2 for a 4-bit A/D converter if Va = 5 V with a reference…

A: Given, 4-bit ADC is We need to design the successive approximation table for the input analog value…

Q: Select the transfer function gain (M)

A:

Q: Which of the following can be the value of A for the regular plane wave, whose mathematical…

A: We need to find out the value of unknown for given waveform for given polarization .

Q: (b) In Figure 1.2, calculate (i) the current IS when the switch SW is open,  (ii) the current IS…

A: The required parameters can be calculated by using the resistance reduction techniques, ohms law and…

Q: Aluminum has a resistivity of 10.6×108 Om at 20°C. What will the resistivity of Aluminum when then…

A:

Q: 1. Calculate 202 16. 202 W 202 202 3Ω 2Α 3Ω 3Ω 3Ω

A:

Q: Question 5. A digital system has Z transfer function G(z) The input signal {un), n ≥ 0, is un =…

A: The given problem is from z transform. The detailed solution is given in the next steps

Q: . Find the dynamic error coefficient of the unity feedback system whose forward transfer function is…

A: Given: Gs=20ss+5     where input is 4t2 or  8t22.

Q: 1) (a) amplitude, (b) wavelength, and (c) frequency, given that its phase velocity is 6m/s? to…

A: Given: Waveform,

Q: 9V ImA 1002 ↑ +1 85022 loks 8505 IMS 25002 VI

A:

Q: (c) For the circuit in Figure 4.3, convert the voltage source to a current source and  sketch the…

A: It is given that:

Q: The capacitance of the capacitor formed by two parallel plates, each 100 cm in area separated by a…

A: Capacitor Capacitors, along with resistors and inductors, are one of three fundamental electronic…

Q: A 1000 μF capacitor is charged at a constant current of 1 mA. The final voltage across the capacitor…

A: it is asked to find the charge and time required from given values of capacitance, current and final…

Q: Consider a second order system whose state space representation is of the form *= Ax+ Bu. Where B =…

A:

Q: Describe the voltage across and the current through the inductor combination in both charging and…

A: Given: the circuit diagram consists dc source, resistor, and capacitor I) when the source is…

Q: Use of computers in digital control systems is particularly valuable for a number of reasons,…

A: Use of computers in digital control systems is particularly valuable for a number of reasons,…

Q: The value of Z in Figure, which is most appropriate to cause parallel resonance at 500 Hz, is

A: It is given that: f=500 Hz

Q: 1_ To obtain equal currents between the resistors, what do we do? 2_When a certain resistance is…

A: To find: a) How to obtain equal currents between resistors? b) what happens to the circuit when a…

Q: Design a counter that counts in the sequence: 000001010 011101-111 Use clocked T flip-flops

A:

Q: 3) A 555 timer is connected in the stable mode as shown in the figure below. Determine the frequency…

A: Given data A 555 timer is shown in the figure which is in stable mode.  We need to find the…

Q: Aif we have pil3, 30, 45) find the point pin Cartesian and Cylindrical systes.

A:

Q: ei C )Find the transfer function of the following op-amp circuit R₂ www R₁ ww a. Solve it manually A…

A: Given:Op-amp circuit:

Q: Q4 A- Illustrator the rotor of the following Motors? 1- Control Differential (CD) Synchro motor. 2-…

A: Q4) A)

Q: An analog voltage in the range 0 to 10.8 V is divided in 16 equal intervals for conversion to 4-bit…

A: Given : Analog voltage, Vp-p=10.8V n=4

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.