for the FM system, the carrier Signal fraquency is (25 MH2)and the information signal frequencgia( 400 H2). if the carrier Signalamplitude is (4V) and the frequenry deviation is (1o kH2):[13 write the general equation of the FM signal.(1 Stetch the time domaia FM wave.[3) Fad the FM signal Power.

Answered: Image /qna-images/answer/988af22a-ffeb-4972-bfef-ea320fbe9cbb.jpg

for the FM system, the carrier Signal fraquency is (25 MH2) and the information signal froquencyis( 400 H2). if the carrier Signal amplitude is (4v) and the frequeury devintion is ( to kH2): [3 write the general equation of the FM signal. (1 Stetch the time doain FM waE. (3) Fad the FM signal power.

for the FM system, the carrier Signal fraquency is (25 MH2) and the information signal froquencyis( 400 H2). if the carrier Signal amplitude is (4v) and the frequeury devintion is ( to kH2): [3 write the general equation of the FM signal. (1 Stetch the time doain FM waE. (3) Fad the FM signal power.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 162-MHz carrier is deviated by 12 kHz by a 2-kHz modulating signal. The maximum deviation of an FM carrier with a 2.5-kHz signal is 4 kHz. Compute the bandwidth occupied by the signal, by using the conventional method and Carson’s rule. Sketch the spectrum of each signal, showing all significant sidebands and their exact amplitude.
Calculate the frequency deviation and the carrier swing of a frequency- modulated wave which was produced by modulating a 50.4 MHz carrier. The highest frequency reached by the FM wave is 50.415 MHz. Then calculate the lowest frequency reached by the FM wave. If the frequency of the modulating signal is 5 KHz, what is the bandwidth of the FM wave?
2 (AM) A 10 V amplitude sinusoidal signal is used as a modulating signal to generate an AM signal with modulation index 0.8. What is the amplitude of the carrier? What is the power of the side bands? What is the efficiency of the modulated signal?
H.W A) An amplitude modulated signal has a carrier frequency 10KHZ. The upper sideband is transmitted at 11KHZ. plot the frequency spectrum and determine the Bandwidth required for the AM signal? B) compute the Signal Energy
please find enclosed spot of our general expression in our frequency modulation. And in this frequency modulation instantaneous frequency is given as: fi(t)=fc+400cos(2π100t) a)Here carrier frequency is fc, message signal is fm,so please calculate kf ,β(modulation indicator) ve maximum frequency deviation ∆f ? b)Write the simplest form of the FM modular signal by writing the parameters instead. c)Calculate the average power that the FM modulated signal will create on a 1 ohm resistor.
A. How many numbers of constellation points exist in phase for 3bit ASK? B. What happens to the radio wave propagation when the frequency is below critical angle? C. If the mark frequency and space frequency are same then what happens to FSK? D. What is the Carson’s rule? E. What is the Maximum data rate in a minimum channel bandwidth is ? F. What is radio horizon and where is it used? G. What are the phase angle limitations of a BPSK? H. What is the change in channel capacity when two number of bits are increased?
5. The following data is available: fc= carrier frequency = 750kHz, Ac= maximum amplitude of the unmodulated carrier = 10V fm= modulator frequency = 300Hz-8kHz modulation index m=0.5 a) What is the frequency of the upper sideband? b) What is the frequency of the lower sideband? c) What is the amplitude of the modulating signal? d) What is the maximum amplitude of the envelope of the modulated signal? e) What is the minimum amplitude of the envelope of the modulated signal? f) What is the bandwidth of the modulated wave? g) Write an expression for the modulated wave
Let the center frequency of the wireless link be 901 MHz.(a) If the distance between Tx and Rx radios and reflectors around them is up to 10m, what is the maximum propagation delay tmax?(b) Let Rb = 5000 bits/s (chips/s). Under these conditions, are reflection paths resolvable?
Given the following FM modulator, if the modulating signal m(t) is given below:(a) Sketch the input message signal m(t).(b) Determine the FM modulated output signal yFM(t) for 0 ≤ t < 3. Given that the frequency sensitivitykf and the carrier frequency fc of the FM modulator are 5Hz/volt and 20Hz respectively.(c) What is the maximum frequency deviation (change of the carrier frequency) of the modulator?
An Amplitude Modulation (AM DSBFC) radio broadcasting station with its carrier frequency of 750 kHz is amplitude-modulated by a 4 kHz audio signal to produce an AM envelope. The maximum and minimum peaks voltages of the envelope are 180Vp and 70Vp respectively. The equivalent resistance of the transmitting antenna is 60 Ω. Determine: (i) The peak amplitudes of the audio, carrier sideband voltages and modulation index. (ii) Using the above results, write the complete AM mathematical representation to express the waveform, showing its carrier, lower sideband and upper sideband parameters. (iii) The power of the carrier signal, total sidebands power and the bandwidth of the modulated signal. Then sketch and label the power spectrum of the modulated ( i v ) If the transmission is changed to Single-Side Band Suppressed Carrier (SSBSC), calculate the percentage power saving in comparison to the original AM DSBFC
A 4 GHz carrier is DSB-SC modulated by a low pass message signal with maximum frequency of 2 MHz . the resultant signal is to be ideally sampled. The minimum frequency is?
(a) What is the frequency deviation and carrier swing necessary to provide 75% modulation in theFM broadcast band? (b) Repeat for an FM signal serving as audio portion of a TV broadcast.