for the following AC signal: x(t)=3cos(2000 t), the root mean square value is ************

Q: (c) A TV broadcast antenna transmits power of 3 kW at frequency of 200 MHz. The transmitter antenna…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Fig. Shows a parallel circuit. Determine the power absorbed by each load and the total complex…

A:

Q: A 6 V/2.5 mA relay is connected in output stage of a transistor. The coil is made of Aluminium of α…

A: We have relay with 6 V/2.5 mA with, α = 0.004 Temperature (T) = 32 °C Resistance at Temperature T…

Q: 22. This is the product of an applied force in a certain area of fluid. a. energy b. work c. power…

A: Force: Force is a physical quantity that can change the motion of an object. It is denoted by 'F'.…

Q: If the electric field strength associated with a plane wave is 20 V/m, then what will be the…

A: Given information: The electric field strength associated with a plane wave is given as E=20 V/m.…

Q: If the electric field strength associated with a plane wave is 2 V/m, then what will be the…

A: Given: Electric field strength, E=2V/m Speed of light, c=3×108 m/s

Q: In the figure, V1=1.55V, V2=2.02V and V3-3.49V. What is the value of Vout? Express your answer in…

A:

Q: 17. Given the first column for the Routh stability analysis, what is the minimum value of K that…

A:

Q: ompute the value of the apparent power, reactive power, real power and its power factor. 25-52 WWW.…

A: Given parameters: A Series RLC circuit, Resistor, R = 25 ohm Inductor, L = 0.08 H Capacitor, C = 42…

Q: A 380 V 50 Hz Y-connected synchronous motor has four poles. At full load, its eficiency is 94%.The…

A:

Q: Given the following transfer function for H(s), find the magnitude for H(jw) forw = 1 (use two d 13.…

A:

Q: The ratings of a 3-phase circuit breaker are 1500 A. 750 MVA, 66 kV, 3 seconds. Then find (1) Rated…

A: We have an specification of a 3-phase circuit breaker.   And we have been asked to find, Rated…

Q: Find F[e-t(sin wot)u(t)] Note: F.T(sin wot) = TU (8(w – wo) − 8(w + wo)) - - F.T(u(t))=π8 (w) +…

A: Given:  signal s(t)=e-t(sinw0t)u(t) we have to compute Fourier transform of the above signal. It can…

Q: In the circuit given below, C = C1 = C2. Find the gain of the multiple-feedback band-pass filter

A: Given circuit,

Q: A 50 kVA, 500 V, single phase alternator gives 700 V on open circuit at the field current of 15 A.…

A:

Q: 8. j¹⁰0/4+j12

A:

Q: 14. Find the total power.

A: The power is the ratio of square of voltage to the resistance and the unit of power is watts.

Q: • Show the voltage waveforms across each half of the secondary winding and across RL. • Find the…

A:

Q: 4. . Given the following transfer function for K. G(s)H(s), where is the break away point on the…

A:

Q: a) A unity feedback system is given as in Figure Q4 a). Determine: Damping ratio i. ii. iii. The…

A: Note: We can only answer up to 3 subparts at a time, kindly repost your question for the solution of…

Q: 9. [(2260)/(15Z-75)]+[(1.2+j1.2)/(4.2+j2.4)]

A:

Q: b) In Y-Y connected balanced system has Van 230.0 Estimate Vcb? 24

A: Given data, Circuit diagram is given as,

Q: Calculate the power dissipated by the voltmeter and by resistor R in Figure 10.9 when (a) R=250 ohm…

A: According to the question, following data is given Full scale division=200 VSensitivity=10 kΩ/VWe…

Q: 4. (a). (b). Operational amplifiers (op-amps) are used in integrated circuits for signal…

A: Given a circuit of an operational amplifier as shown below. Find State characteristic of the ideal…

Q: A 9V-battery is connected to a resistive strip that consists of three sections with the same…

A: Given  Xs = 8.00mm ρ3 = 3.00 × 10-7Ωm Area of cross section is same for all three sections ρ1 = ? ρ2…

Q: Find the L^-1 iNVERSE LAPLACE e.) X(S) = 1/s^2+4

A:

Q: A 1-phase half wave diode rectifier with R load, has input voltage of 240 V. The input power factor…

A: Given data, Input voltage Vs=240 V

Q: 955. Given a zero-centered delta function of area 36 volt-seconds. Evaluate the Fourier transform at…

A:

Q: Question # 4: A. Referring to the circuit in figure 3, if the voltage source provides 15 volts of…

A: Given circuit, VS=15 VI=1.58 mA

Q: The figure below shows three resistors (R- 13.5 0, R -7.95 0, and Ry- 12.5 0) and two batteries…

A: Given- Source voltage= 40 V and 22 V Resistance = 13.5 ohm, 7.95 ohm, 12.5 ohm To find- Current in…

Q: The Op-amp can amplify 1. a.c. signals only 2. d.c. signals only 3. both a.c. and d.c. signals 4.…

A: The operational Amplifiers are direct-coupled amplifiers. Here, the coupling between the stages of…

Q: Let u = (-1, 3), v = (2, 4), and w = (2, -5). Find the component form of the vector a) u + v b) u -…

A:

Q: Four rigid rods, OA, AB, BQ and CD are connected as shown in figure. All functions are movable C is…

A: Given: Angular velocity of rod OA is 60 rev/min. Length of the rod OA is 1m. Length of the rod AB is…

Q: Use Kirchhoff’s current law to determine the missing current in the circuit shown in the…

A: The circuit is shown below:  As per Kirchhoff’s current law, the incoming current and the outgoing…

Q: + (b). M R1 2 Ω V 20 V (i) m (ii) 13 ww R3 5 Ω R2 20 Ω Figure 2 ww R5 2 Ω Referring to Figure 2,…

A:

Q: 32. An ac voltage source of V max = 120 V is rectified using a full-wave bridge rectifier circuit,…

A:

Q: 8. `Given the following transfer function for H(s) where it is under damped, for a unit step input…

A:

Q: Calculate the voltage gain for the amplifier system shown in Figure (2), where an input signal Vin =…

A: Given data, Vin=7 mVV0=28 mV

Q: Determine the voltages 1 and 2 of the network in Fig. by nodal analysis, ΤΩ 1 2 3 ΤΑ {2Ω Μ 202 ΣΙΩ 2…

A: Given: Circuit diagram

Q: Given the cylindrical coordinates: A(5,30°, 6) and B(7, 60°, -3) C. Determine the vector that…

A:

Q: Ex For the circuit shown below; if the input voltage is a sinusoidal wave, sinusoidal wave, find the…

A:

Q: Calculate each of the circuit parameters for the provided circuit. RT(KQ) = Is(mA) = %3D V1(M = 1…

A: The given circuit diagram is shown below:

Q: . A linear sign-magnitude PCM code consists of a. all magnitude bits b. a sign bit and magnitude…

A: 11) A linear sign-magnitude PCM code consists of a sign bit and magnitude bits ( option B).

Q: A newly constructed wing of engg. college, has electrical installation with a surface conduit…

A:

Q: The following tests are performed on a 415 V, 950 rpm, 50 Hz three-phase induction motor WHICH s…

A:

Q: image

A: Given data: A cylindrical wire specifications are given below. ρ=2.15×10-7 Ω-ml=1 mr= 0.100…

Q: FIND THE TOTAL RESISTANCE OF THE CKT. • CONSIDER= 1.2. R RT R 73 R R R

A:

Q: If the electric field strength associated with a plane wave is 20 V/m, then what will be the…

A: The electric field strength associated with a plane wave in free space is given as E=20 V/m.  The…

Q: In a synchronous generator, a DC current is applied to the rotor winding List two advantages of this…

A: Synchronous generator:- A synchronous generator is a device that uses electromagnetic induction to…

Q: A three phase motor canbe regarded as Balanced "Wye " load. A three motor draws 6 KW when the…

A: