For the following electrical circuit in R3 = 649ohm determine by the method of Superposition theorem: the electric current, Voltage and Power dissipated in the circuit

Q: (b) Find the 3-phase balanced fault current at bus 2 using Thevenin's method. 10/0² لمات J0.2 10.2 م…

A:

Q: Find the Thevenin and Norton equivalent circuits at terminals a-b of the following circuit 18 15V 5V…

A: The given circuit is shown below.We need to find the Thevenin and Norton equivalent circuits at…

Q: Which is correct in case of Computer controlled system?

A: Given Data:There are 4 statements regarding computer-controlled systems.Required Data:Here, we need…

Q: Consider the inverting amplifier shown in Figure Q1c. Initially R₁=10 ks, R₂=1 MS2 and R3 is a short…

A: The objective of the question is to calculate the output voltage of an inverting amplifier given the…

Q: How do you make this conversion?

A: The conversion of rectangular form into polar form needs to be briefed.

Q: Q2// For the three-phase power system shown in Fig. (1), the reactances of its elements are given in…

A: Find 3 phase symmetrical fault current = ?

Q: Consider the surface of a chip made of Au rectangular patterns spaced a few microns apart on a glass…

A: It is mentioned to consider the surface of a chip made of Au rectangular patterns spaced a few…

Q: Consider an LTI system for which the system function H(s) has the pole-zero pattern shown in Figure…

A: Given plot is,(a) Indicate all possible ROCs associated with pole zero plot,(b) System is stable…

Q: F (A,B,C,D) = draw EM (0,2,5,7,8, 10,11,15) take AD as control how can we represent this numbers in…

A: Given:A boolean function, we need to do:draw the k-map and find logical expression. Using A and D as…

Q: 2Α 1Α 2Ω 2Ω Fig 2.1 5Ω 10 V 2Ω www 3Ω Vs Rs Fi12.2 3Ω

A:

Q: For the op-amp circuit find Vo for t > 0 if v(0) = 4 across the capacitor.

A: For the given op-amp circuit:we need to find: output voltage  for  if v(0) = 4 across the capacitor.

Q: Let y[n] denote the convolution of h[n] and g[n], where h[n] = (1/2)^ u[n] and g[n] is a causal…

A: Given Data:Required Data:Here, we need to find the value of Here, we need to find the value of

Q: +10V find V₂ + VRI www 1kQ 1 ID - + VDI Si + VD2 V01, VD₂ Si 7 - VA1 14 1 + VR2 - w 2.2ΚΩ VAZ and ID

A:

Q: Q1/ Draw the Bode log-magnitude and phase plots for the system shown in figure below, where K=50,…

A: Given block diagram is,gain K=50we need to do,Draw the Bode log magnitude and phase plots for the…

Q: Mux 4x1 F(A,B,C,D)Draw of ∑m(0,2,6,8,10,14,15) take BC control draw with Carno of map

A:

Q: For the block diagram in the attached pdf. Find K, so that e=0.1 when r(t) = 4t. 2 SS Enter your…

A: The block diagram of a linear feedback system is given. To determine:value of K2 so that…

Q: The subtraction of your matrix is wrong. You should have (s-1), not just s. Could you please verify…

A: The state space representation of a system in terms of matrices is given byWe need to find the state…

Q: D. Consider the folowing circuit. Determine the following values if Vz-10v, Izx=2mA, PZM=250m Watt:…

A: In this question, we need to determine the Voltage across resistance Rs and supply voltage Vsource…

Q: A test voltage is applied to the input of an electrical network. v(t) = 1V sin(2π.5kHz. t) The input…

A:

Q: > Q. 6. The nomin I power of a shunt generator is 30 kW. The no output voltage of the generator is…

A: In this question, we need to determine the output power and efficiency of the DC generator.…

Q: and xc(t) 2) The baseband information signal x(t) whose frequency spectrum is shown in Fig. 2 will…

A: The objective of the question is to analyze the given narrowband and wideband FM signals, determine…

Q: x(t) = e(t - 3)

A: (3.54)(a)The given equation is

Q: SemilogPaper.pdf Draw the linear approximation to the log- magnitude on semilog paper for the open…

A: Given

Q: Three single-phase step-up transformers rated at 50 MVA, 13.2 kV/80 kV are connected in delta-wye on…

A: The objective of the question is to calculate the secondary line voltage, the currents in the…

Q: For the attitude control satellite system if D(z)=1, K=1, and T=1 s, J=4, and H₂=1, the state space…

A:

Q: In a step-up transformer, the turn ratio is 1: 20. The resistance of 100 2 connected across the…

A: Given data:Required information:

Q: find the radiation efficiency

A: From the given question:Given data:

Q: Consider a system with the following A = [2 =3] - (i). Test the stability of the system and state…

A: Given Data:A system with,State matrix  To Find:Stability and the type of the damping.The damping…

Q: (a) Determine the modulation index. (b) Calculate the transmission efficiency. (c) Determine the…

A: Given Data:Required Data:Here, we need to determine the,Modulation index.Transmission…

Q: Q1/The complex magnetic field of a uniform plane wave is given by. 108 H (ax-jaz)ely 120m b) Find…

A: Complex electric field of uniform plane wave is given by a) Find the polarization of the wave.b)…

Q: Q. For the given circuit, assume the switch was closed for a long period before it opened at t=0.…

A: For the given circuit the value of the current through the inductor needs to be calculated and the…

Q: Q1: For the unity feedback system of figure shown below, 100 Where, G(s) = = s² (s+15) Find ess for…

A: Given a system, we are required to compute steady state error for unit step input and ramp input.

Q: Task 5: Lets observe a closed loop system below where we have controller C(s) and system G(s) 2014…

A: Given: a control system, with, we need to determine:a) The value of KI so that the controller…

Q: In the circuit shown below, Determine: • The equivalent capacitance Cea-(Hint: Ceq should be in…

A: The circuit diagram,

Q: H.W/A 300 m ring distributor has loads as shown in Figure below, where distanc are in meters. The…

A:

Q: 2.36 Find V, and V₂ in Fig. P2.36. 2 A V₂ 50 w tw 502 Figure P2.36 + 102 V/₁

A:

Q: 2) An IIR digital low-pass filter is required to meet the following specifications: Passband ripple…

A: An IIR digital low-pass filter is required to meet the following specifications: Passband ripple (or…

Q: The surge impedance of 500 miles long line is 4000. For a 100 miles length it will be:

A:

Q: Q1/ Draw the Bode log-magnitude and phase plots for the system shown in figure below, where K=50,…

A: Given:a control system, with K=50we need to do: draw the Bode log magnitude and phase plots for the…

Q: Question: 4 (Compulsory) a.) Find the value of i, and find the thevenin equivalent circuit.…

A: The given circuit isWe need to determine the current ix and the Thevenin's equivalent circuit at…

Q: The ratio of hole diffusion current to the electron diffusion current crossing the junction of an…

A: Given Data:The ratio of the hole diffusion current to the electron diffusion current is given as The…

Q: Given the voltage drop & current flowing through an element: (a) indicate whether the element is…

A: Calculate sine waveform  current into cosine form.If voltage and current are in phase with each…

Q: Sketch the block diagram of a continuous system in a closed-loop control with a discrete lead…

A: It is asked to sketch the block diagram of a continuous system in a closed-loop control with a…

Q: 1) The non-ideal DSB-SC AM signal, x, (t) = x(1) cos(2wfet +) with a phase shift , is applied to the…

A: The objective of the question is to find the autocorrelation function and power spectral density of…

Q: Consider the following R-25 DAC shown below. Apply the digital data to inputs A to D as specified in…

A: A converter (DAC) is a type of DAC architecture commonly used to convert digital signals into analog…

Q: The surge impedance of 500 miles long line is 4000. For a 100 miles length it will be:

A: Given data:Required information:

Q: Show ALL calculations for the following. a. Find the Norton equivalent circuit for the network…

A:

Q: Q4: A thermometer having first-order dynamics with a time constant of 1 min is placed in a…

A:

Q: Input and output signal pairs are listed below for several DTLTI systems. For each case, determine…

A:

Q: Assuming silicon with completely ionized dopants, compute n and p for the following case.

A: Given Data:Required Data: Here, we need to determine the electron and hole concentration. Here,…

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.