For the following reaction: 2N203 (g) N204(g) + 2NO (g), Ke is 0.21 at 250°C. R = 0.0821 atm.L/mol.K. a. Temperature (K) = K b. An (gas) = c. Kp equation is d. Calculated Kp =

Q: The feed to a distillation column is separated into net overhead product containing nothing with a…

A: Given Distillation gives distillate and bottom products. Distillate-No n-butane and n-pentane,…

Q: Eхаmple 6: The vessel (0.2m diameter, 2 m length) has been used as an reactor on the assumption of…

A:

Q: 7.3. Estimate the entropy change of vaporization of benzene at 50°C. The vapor pressure of benzene…

A:

Q: The wall of a furnace is made up of 9.5 in. firebrick (k=0.72 Btu/hr-ft-'F) 5.3 in. of insulating…

A: Given that, The thickness of firebrick L1 = 9.5 in = 0.792 ft The thermal conductivity of firebrick…

Q: A plug flow reactor of volume 2 m' is being used for the first order liquid phase reaction of…

A: Given that, Volume V = 2 m3 The feed rate of A FAo = 0.2 kmol/s The initial concentration of A CAo =…

Q: 2. 6 The diameter of a cylindrical core sample is 2. 5 cm, its length is 6. 0 cm. Under a pressure…

A: Given data: Diameter of cylindrical core = 2.5 cm Length of core = 6 cm Pressure difference = 0.3…

Q: 13. An orifice meter is used to measure the rate of flow of a fluid in pipes. The flow rateis…

A:

Q: Saturated water at 310K is being pumped from a tank to an elevated tank at the rate of 7L/s. All of…

A: Given data: Saturated water is being pumped from point 1 to 2 by a pump. Number of 90 0 elbows…

Q: Q/ Three chemical engineers (Mohammed, Ahmed and Ali) discussed about the effect of the pressure…

A: We are asked to find the answer for the efficicency of the Rankine cycle with the pressure of the…

Q: The following information are provided Sulfur dioxide, Temperature = 600 K and pressure is 300 bar.…

A: Note:  we are supposed to answer only three subparts of a question. please send the other questions…

Q: H.W) How much heat energy is needed to raise the temperature by 15°C of: (1)25 g water (µ=4.148 J/(g…

A: Given  Temperature difference (dT) = 15 0C. Heat Energy (Q)= mass(m) × specific heat (u) ×…

Q: Methane (CH4) at 298 K, 1 atm enters a furnace operating at steady state and burns completely with…

A: Write the reaction for the combustion of methane as follows: CH4 + 2O2  →CO2 + 2H2O   One mole of…

Q: Ethane will be used as a fuel for boiling a water. a.) How much volume of water will a 7.5 L of…

A: Given that T = 25 cP =0.95  bar λ=1560 KJmol

Q: Calculate the steric parameter for polystyrene if the volume occupied by one molecule of polystyrene…

A: Given data: Molecular weight of one molecule of polystyrene = 10 × 10-16 cm3 Carbon-carbon bond…

Q: Write the formula of an alkene containing 12 carbon atoms. Answer:

A: Given  Number of carbon atoms = 12 General formula of alkene = CnH2n

Q: 2. A composite furnace wall is made up of a 14 in. lining of magnetite refractory brick, a 5.3 in.…

A: Given that composite wall lining with magnetite =LA= 14 in = 1.166 Ft magnesia lining = 5.3 in…

Q: Methanol (SG = 0.8335, viscosity is equal to that of water) is being transported from a very large…

A: Given data: Standards of pipe = 1.25 in S 40  pipe Inlet pressure = 14.7 psia Length of pipe = 1450…

Q: These data are given: w = 250 lb/min; density = 62.5 lb/ft3;V1 = 4 ft3:V2 = 5 ft3,V3 = 6 ft3; Cp = 1…

A: A transfer function is also known as a network function or system function. These functions are…

Q: Choose the true statement from the following regarding batch distillation: a) The exact…

A:

Q: For the reaction Cu(s) = Cu(g) AH° = 81,730 – 0.47T – 0.731x10³T² AS° = 34.94 – 1.08 log10T – 1.46 x…

A:

Q: Estimate the effective diffusivity of thiophene (molecular weight 84) in hydrogen at 660K and 30…

A:

Q: Ke is 2.2 x 104 for the reaction equation below: 2H2S (g) 2H2 (g) + S2 (g) Choose one correct answer…

A: Given that Kc = 2.2 x 10-42H2S  ⇔ 2H2 +S2

Q: An uninsulated steam pipe passes through a room in which the air and walls are at 28°C. The outside…

A: An uninsulated steam pipe passes through a room in which the air and walls are at 28°C. The outside…

Q: In the aqueous phase, reactant A is fed to a batch reactor with an initial concentration of 1 mol /…

A:

Q: Three reversible paths are shown for a closed system. Which path requires the largest amount of heat…

A:

Q: Find the density in pound per cubic feet of ammonia gas at 100C when confined by a pressure of 1600…

A: Find the density ? Molecular weight of ammonia is 17 g/mol.

Q: The weight of a clean sand core sample in the air is 27.76g. When saturated with kerosene, it…

A: Given data:  The weight of a clean sand core sample in the air (Wsand )= 27.76g When the core sample…

Q: • Gases A and B are diffusing towards each other at steady state by equimolar counter diffusion…

A: The case is diffusion through variable cross section area. The flux would change but rate of mass…

Q: 4. Calculate the heat loss per linear foot from a 10.3 in. nominal pipe (outside diameter=10.75 in.)…

A: Given that  pipe diameter inner = din = 10.3 in pipe diameter outer = do = 10.75 in insulation 1…

Q: A +B the equilibrium conversion is 0.8 at 127°C and 0.5 at 227°C. What is the heat of reaction?

A:

Q: Question 1 An 8.01 g sample of Glaucosil is studied by N; adsorption at -195.8°C. The following data…

A: A sample m=8.01g T= -195.8C Studied by N2 Adsorption and data is  Partial pressers (p) Of N2 (mm…

Q: 2. Csugar 5 wt % V,=5 It/min. Total volume of tank=200 liters initially contains 50 Its solution…

A: 4.38 kg is the answer

Q: The vapor pressures of the pure liquids A and B are 72.020 and 54.538 kPa respectively at 313.406 K.…

A:

Q: Find the following for the given image in terms of number of links and the Kuhn steps (x). (Ar)

A: We are given a polymer molecule of random configuration whose total number of monomer (links) is N…

Q: XPERIMENT: SIMPLE BATCH DISTILLATION I want theory background for this experiment ( with details and…

A: Batch is a process in which feed is charged once, then we have unit operation and/or unit processes.…

Q: Consider the titration of 50.0 mL of 0.0500 M NaCI with 0.100 M AGNO3. Calculate pCl at various…

A:

Q: Calculate the change in entropy when 50 g of water at 80oC is poured into 100 g of water at 10oC in…

A: Given:  Temperature of water of 50 g = T1 = 80 C = (80 +273) K = 353 K  Temperature of water of 100…

Q: What is the most proper name of this structure? SH O (S)-4-mercapto-2-methylhexane…

A: To determine the name of the compound follow the nomenclature rules:

Q: Obtain the pressure in SI (Pa) necessary for shrinking the volume of water by 1% at normal…

A:

Q: For 14 Bravais lattice, there is no B face centered tetragonal lattice. Prove the lack of B face…

A: Bravais Lattices are defined on the basis of symmetry not in the terms of unit cell shapes and size

Q: A well-mixed continuous stirred tank reactor is to be used for the decomposition of an ester (E) by…

A:

Q: B The isomerization of butane C,H10 -C,H was carried out in the liquid phase. The data for this…

A: Given data: Conversion versus rate for the isomerization reaction of butane is given.

Q: A filtration is carried out for 10 min at a constant rate in a leaf filter and there after it is…

A:

Q: Reversible reaction is done in an isothermal constant -volume batch reactor: A(1) + B (1) It is…

A:

Q: P5-12, The elementary gas-phase reaction (CH3),COOC(CH;),→C,H6 + 2CH;COCH, is carried out…

A: Given, Activation energy ,E = 85 kJ/mole

Q: 4. A bilayer polymer slab (1.2m long, 1.4m wide, 5 cm thick) is placed on a hot plate, which keeps…

A: Given that, The length of the slab L = 1.2 m The width of the slab w = 1.4 m The thickness of the…

Q: For the reaction A à B, the process flow diagram is shown in figure.1.The fresh feed of A contains…

A:

Q: 2. A vapor-compression refrigeration system operates on throttling expansion. The refrigerant is…

A: The refrigeration system flow diagram is obtained. This system contains a condenser, compressor,…

Q: How does heat transfer work in the chemical industry? Explain each step of the heat transfer process…

A: Introduction The transfer of heat from one fluid to another is an essential component of all…

Q: Gold nanoparticles find applications in photothermal therapy. Their optical properties lead to…

A: we have to asnwer the wavelength values for the absorbance in photothermal therapy using gold…