For the formula: kinematic viscosity (v) equals absolute viscosity (u) divided by density (p) v = u/p Show how the SI units for this relationship are derived by reducing them to the basic length, time, mass and presenting them for each variable.

For the formula: kinematic viscosity (v) equals absolute viscosity (u) divided by density (p) v = u/p Show how the SI units for this relationship are derived by reducing them to the basic length, time, mass and presenting them for each variable.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.13P: 5.13 The torque due to the frictional resistance of the oil film between a rotating shaft and its...

See similar textbooks

Related questions

Q: er is the working fluid in a supercritical ideal reheat cycle. Steam enters the first-stage turbine…

A: Given:Pressure and temperature at turbine inlet, T1=640°C P1=320 barTemperature at the outlet of…

Q: thickness=0.23 in. allowable normal stress B=56⁰ inside diameter = 66 in. perpendicular to the weld…

A: Given:β=56°Inside diameter, d=66 inwall thickness, t=0.23 inAllowable normal stress, σallow=10.1…

Q: Q20. The 74-kg man pushes on the 134-kg crate with a horizontal force F. If the coefficient of…

A: Given that: Mass of the man is 74 kg Mass of the crate is 134 kg Coefficient of kinetic friction…

Q: Q22. The 25-kg, uniform crate starts from rest to slide down the inclined surface. If the…

Q: Find the allowable range for 0₂ for the particle to remain in static equilibrium, if F1, F2, and F3…

Q: both cables have a diameter of 5 mm, find : The normal strain for both wires using both the small…

Q: A hot 5x5-cm² surface at base temperature Tb = 100°C is to be cooled by attaching 3-cm-long pin fins…

Q: nextensible massless string goes over a frictionless pulley. Two weights of 100 N and 200 N are…

A: Given:Weight of the first block, W1=100 NWeight of the second block, W2=200 N

Q: 1. Pick up 2 types of pneumatic actuator given in the lesson. Explain the actual application of the…

A: Since you have asked two questions, as per our honor code we have to answer only first unless…

Q: An annular aluminum fin of rectangular profile is attached to a circular tube having an outside…

A: Introduction The fins are used to increase the heat transfer when the convection heat transfer…

Q: Why is it important to understand the load factor and how it affects when a wing stalls? Give an…

A: Load factor is an important parameter for the safety of the air craft. If we cannot understand this…

Q: 1. DETERMINE THE MAGNITUDE OF FORCE F1 AND ITS ANGLE FOR EQUILIBRIUM OF THE MEMBERS OF THE TRUSS…

A: Given:F2=15 kNF3=16 kNF4=17 kN

Q: In the setup seen in the image, an oil tank's central circular opening is sealed off by a solid…

A: For solution refer below images.

Q: ( Use nomograph AND the formula) Size a pipe that will not exceed 48' of HL in 6000 feet of pipe at…

A: Given data: Head loss, HL = head loss due to friction, Hf= 48 ft Length of the pipe, L = 6000 ft…

Q: nside a large container filled with glycerin at rest, which has a density ? = 1260 kg/m3 and…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: An insulated, rigid tank has two compartments, one 8 times as large as than the other, divided by a…

A: Part (A): Write the given data. For smaller side,m1=4 kgP1=200 kPaT1=90 °CFor surrounding,Psurr=100…

Q: The control knob of a window air-conditioning unit has four settings. The knobis turned from the OFF…

A: Write the given data. Curve length from OFF to HI COOL,L=916 inDiameter of knob,D=34 in

Q: show complete solution with free body diagram The frame in the figure supports the 50-kg cylinder.…

Q: Classify structure shown in Figure as statically determinate, statically indeterminate, or unstable.…

A: Find the structure is statically determinate, statically indeterminate or unstable. Compare with…

Q: weights of 4N 9N 15N and 12N are hung from an 18N uniform 12 m long rod distances 3m 5m 7m and 11m…

Q: Consider a pumping system used in a cooling water loop. Water is drawn from a tank, which maintains…

Q: A pump is used to circulate hot water in a home heating system. Water enters the well-insulated pump…

A: Ans:- [ 0.6006 ] °R

Q: 3. A pair of bevel gear have a 1:1 velocity ratio, a pitch diameter of 8 in, a face of 1 % in and…

Q: Problem 2-48 For the tank shown in the figure, compute the pressure at points B, C, D, and E in kPa.…

A: Given: We have to neglect the unit weight of the air. And specific gravity of oil→S=0.9 So the…

Q: Kutzbach Equation

A: Since there are multiple parts in the question, as per our honor code we have to answer first three…

Q: A square body of side L=1 with one vertex on origin is in static equilibrium. It is subjected to…

Q: 24.:Block A in Fig 2 weighs 50 N and block B weighs 35 N. The blocks are onnected by a flexible…

Q: Water is the working fluid in a regenerative Rankine cycle with one open feedwater heater. Steam…

Q: wall thickness=0.23 in. allowable normal stress B=56⁰ inside diameter = 66 in. perpendicular to the…

A: The given information in the problem is listed in the following attached image:

Q: All the nearby buildings' heating is provided by saturated steam generated at a nearby steam plant…

Q: Water cooled steam condenser receives exhaust from multi-stage turbine at saturation temperature of…

Q: Is there a two extreme position on this diagram? This diagram makes complete revolution. Also, what…

A: Shortest link=5=s Longest link=20=l P=10 Q=15

Q: 4: For the system shown below, calculate the tension in cable BC and the reactions at A to support…

Q: • (c) Derive the transfer function for (). my b₁ H ww k₂ No friction m₂ No friction

A: Given Data: Mass damping System shown in figure below Find: (a) Differential Equation of the System…

Q: Calculate the experimental value of the frequency f for each hanging mass and the corresponding…

Q: wall thickness = 8.6 mm. B=61⁰ inside diameter = 890 mm gage pressure -1.24 MPa, Determine the…

Q: Consider a pumping system used in a cooling water loop. Water is drawn from a tank, which maintains…

Q: Carbon dioxide gas enters a water-cooled compressor at the initial conditions P₁ = 1.0 bar and T₂ =…

A: Given data: P1=1.0 barT2=284.15 KP2=35.8 barTs=366.15 Kv1=6 m/sH1=714 KJ/KgH2=768 KJ/KgV1=0.5774…

Q: Starting from first principles, show that the general equation for conduction in a solid in…

A: In the case of steady-state heat conduction, the temperature ceases to be a function of time as well…

Q: Recommended Weight Limit (RWL) is a load value that most healthy people could lift for a substantial…

A: RWL: Almost all healthy workers should be able to lift the Recommended Weight Limit (RWL) over the…

Q: 8. DRAW THE FBD AND DETERMINE THE REACTIONS AT THE SUPPORTS FOR THE TRUSS SHOWN IN FIGURE 8. 2m 30°…

Q: acting along cable AC (In vectol and the angle between them b B FAB

A: To find magnitude of force FAB

Q: A hollow tube constructed of metal is subjected to five torques acting in the directions shown in…

A: Introduction Whenever the circular shaft is subjected to rotation the shear stress is developed to…

Q: Q6/ A. Show how the precipitation heat treatment of precipitation hardenable alloys differs from…

A: Solution: Given Data:

Q: You have a container like the one shown in figure 1 from which you want to extract liquid with the…

A: Dear student, According to the guidelines, I am allowed to answer only three…

Q: 18 m³ of water are contained in a 2-m wide open rectangular tank that is 5 meters long and 3 meters…

Q: The displacement of a particle is given by s=3t³-57t² = 114t-44 where s is in feet and it is in…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: When a human is standing stationary in anatomical position, is their center of pressure and center…

A: Introduction: The centre of mass of a body or system of particles is defined as a location at which…

Q: Briefly discuss about the necessity of pressure pick, check amplifier in an I.C engine.

A: Write the necessity of Pressure Pick in an IC engine.

Q: Determine the indices for the directions shown in the following cubic unit cell.

Question

For the formula: kinematic viscosity (v) equals absolute viscosity (u) divided by density (p)
v = u/p
Show how the SI units for this relationship are derived by reducing them to the basic length, time, mass
and presenting them for each variable.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A differential equation is d2ydt2=Ay2+Byt where y represents a distance and t is time. Determine the dimensions of constants A and B for which the equation will be dimensionally homogeneous.
The Ekman number, Ek, arises in geophysical fluiddynamics. It is a dimensionless parameter combining seawaterdensity ρ , a characteristic length L , seawaterviscosity μ , and the Coriolis frequency Ω sin φ , where Ωis the rotation rate of the earth and φ is the latitude angle.Determine the correct form of Ek if the viscosity is in thenumerator.
SAE 10W30 motor oil has a dynamic viscosity of 0.21 kilograms per meter second and a specific gravity of 0.896 (a) What is the density of the motor oil in units of kilograms per cubic meter?
Books on porous media and atomization claim that the viscosityμ and surface tension Y of a fl uid can be combinedwith a characteristic velocity U to form an important dimensionlessparameter. ( a ) Verify that this is so. ( b ) Evaluatethis parameter for water at 20°C and a velocity of3.5 cm/s. Note: You get extra credit if you know the nameof this parameter.
The kinematic viscosity of a liquid is 0.058 cm^2/s and has a density of 500 kg/m^3. What is the absolute viscosity in poise
The kinematic viscosity of and specific gravity of a liquid are 3.5 x 10-4 m^2 /s and 0.79, respectively. What is the dynamic viscosity of the liquid in N-s/m^2?
η =2gr^2(ps−pl)/ 9v State the value of the viscosity and error on the value obtained in your experiments. Youshould show the formula derived for calculating the error on viscosity. pl (density of liquid)= 1294.164 ps ( density of solid sphere)= 8404 kg/m^3 v= 0.0479 +- 1.16x10^-3 m/s r= 0.0024325m error for radius is 1.65 x 10^-3 all values are in si units.
The thrust force, F generated by a propeller is found to depend on the followingparameters: diameter D, forward velocity u, density ρ, viscosity µ and rotationalspeed N. Determine the dimensionless parameters to correlate the phenomenon
The power P required to drive a propeller is known to depend on the diameter of the propeller D, the density of fluid ρ, the speed of sound a, the angular velocity of the propeller ω, the freestream velocity V , and the viscosity of the fluid µ. (a) How many dimensionless groups characterize this problem? (b) If the effects of viscosity are neglected, and if the speed of sound is not an important variable, express the relationship between power and the other variables in nondimensional form. (c) A one-half scale model of a propeller is built, and it uses Pm horsepower when running at a speed ωm. If the full-scale propeller in the same fluid runs at ωm/2, what is its power consumption in terms of Pm if the functional dependence found in part (b) holds? What freestream velocity should be used for the model test?
Please answer only when you are sure and give correct answer Thedensity of an oil at 23°C is 750kg / (m ^ 3) Find its relative density and kinematic viscosity if the dynamic viscosity is 5 * 10 ^ - 3 * kg / m * s .
A- Womersley number (a) of a human aorta is 20 and for the rabbit aorta is 17, the blood density is approximately the same across the species. The values of viscosity were 0.0035 Ns/m² for the human and 0.0040 Ns/m² for the rabbit. The diameter of the aorta is 2.0 cm for the man, and 0.7 cm for the rabbit, estimate the heart rate beats per minute (bpm) for both species
A liquid of density ? and viscosity ? flows by gravity through a hole of diameter d in the bottom of a tank of diameter DFig. . At the start of the experiment, the liquid surface is at height h above the bottom of the tank, as sketched. The liquid exits the tank as a jet with average velocity V straight down as also sketched. Using dimensional analysis, generate a dimensionless relationship for V as a function of the other parameters in the problem. Identify any established nondimensional parameters that appear in your result. (Hint: There are three length scales in this problem. For consistency, choose h as your length scale.) except for a different dependent parameter, namely, the time required to empty the tank tempty. Generate a dimensionless relationship for tempty as a function of the following independent parameters: hole diameter d, tank diameter D, density ? , viscosity ? , initial liquid surface height h, and gravitational acceleration g.