For the signal shown, find: 1- The total average power. 2- The average power in the fundamental frequency. 3- The average power in the first five harmonics. 4- The de power. 5- The ratio of average power in the frequency range (0→ 3kHz) to the total average power. fit) msec

For the signal shown, find: 1- The total average power. 2- The average power in the fundamental frequency. 3- The average power in the first five harmonics. 4- The de power. 5- The ratio of average power in the frequency range (0→ 3kHz) to the total average power. fit) msec

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A 105.2 KW FM transmitter with carrier frequency of 100 MHz and signal tone modulation of f m =1 KHz…

A: Given fc=100 MHzfm=1 kHzTransmitter power Ac22=105.2 KWAc2=210.4 KWthird side band power=14 KW

Q: if the antenna impedance is 730, while the characteristics impedance of the transmission line is 50…

Q: Sketch the line (magnitude and phase ) spectra for the first three harmonic of the EFS (i.e. for n=…

Q: signal of frequency, fm with the modulation index of 1.5. Sketch the frequency spectrum of the FM…

Q: The power spectral density shows how the power is distributed over the frequencies included in a…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: What is the value of carrier frequency in the following equation for the FM signal? v(t)= 5…

A: Given ; V(t) = 5 cos ( 6600t + 12sin 2500t ) Solution Fm signal representation or equation is…

Q: For a FM system, if the expression of the modulated wave is x(t)=5cos(2000t+5.5sin100t) V, then…

Q: Calculate the maximum frequency deviation for the FM signal v(t) = 10 cos (6000t+ 5sin2200t)

A: The expression of the FM signal is given as vt=10cos6000t+5sin2200t

Q: 0 1. Sketch the output V and determine the DC level of the output signal for the given network…

A: The diode will conduct only during the forward bias and it will not conduct during reverse bias. The…

Q: 3 An FM station, following FM broadcast standards, broadcasts at 105MHZ. Determine the modulation…

A: a). Given Information: The value of the modulation index of FM signal is determined as follows:

Q: For the signal shown, find: 1- The total average power.

A: As per instructions we can solve only first part Formula to calculate power is…

Q: Find the average power of the signal:

Q: A 105.2 KW FM transmitter with carrier frequency of 100 MHz and signal tone modulation of fm = 1…

A: Given fc=100 MHzfm=1 kHzTransmitter power Ac22=105.2 KWAc2=210.4 KWthird side band power=14 KW

Q: What is the value of carrier frequency in the following equation for the FM signal? v(t)= 5…

Q: What is the value of carrier frequency in the following equation for the FM signal? v(t)= 5 sin[…

Q: What is the value of carrier frequency in the following equation for the FM signal? v(t)= 5…

A: The expression of the FM signal is given as vt=5cos6600t+12sin2500t. The value of the carrier…

Q: Suppose that the modulating signal m (t) is sinusoid of the form m (t) = 10 COS ( 2π103t) and the…

Q: Which of the following quantity remains constant in a frequency modulated (FM) signal? a. phase b.…

A: When carrier signal and modulated signal are combined then frequency modulated signal will produce…

Q: For the signal shown, find: 1- The total average power. 2- The average power in the fundamental…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: A frequency modulated signal is generated by modulating the carrier signal c(t) = 40 cos(2pi fc t),…

Q: Consider an FM signal f(t)=cos[2nfct+B1 sin2nfjt+B2sin2nfzt].The maximum deviation of the…

A: Given: Fm signal f(t)=cos[2πfct+β1sin2πf1t+β2sin2πf2t] Maximum deviation=?

Q: E G Suppose that a massage m(t) = 3 cos (300 ū+) + 2 Cos (500 ut) is AM modulated by using a carrier…

Q: Q7: A given FM transmitter is modulated with a single sinusoid. The output for no modulation is 200…

Q: x(t) = 10cos (2π × 10°t + 3 cos (2π × 100t)) ) Determine fi(t), the instantaneous frequency of the…

Q: : Suppose you have the following information signal i(t) = 4sin(4000nt + 90) modulates with the…

A: We need to find out time domain expression for frequency modulated signal and we also need to find…

Q: Q7: A given FM transmitter is modulated with a single sinusoid. The output for no modulation is 200…

Q: For an FM signal, 1000 kHz is known to be the total available bandwidth, with baseband frequency of…

Q: A carrier (fc = 100MHZ, A. = 25V) is frequency modulated by the sine wave (fm = 8kHz, Am = 3V) using…

Q: by using Fourier Transfor m Determin volt) in the cct. shown below if vit) = 1o ULt). V 4 VOG) vict)

Q: The FM signal is given as s(t) = 3 cos(27500t + 0.1 cos(27400t)) + 4 sin(2-500t + 0.3 cos(2r800t))…

A: Given: s(t)=3 cos2π500t+0.1 cos2π400t+4sin2π500t+0.3cos2π800t Here ,fmax=800Hz a) instantaneous…

Q: For a FM signal v(t) = 25 cos (100 10t + 10 sin 2000t), calculate maximum frequency deviation and…

A: As we knows that the standard frequency modulated signal (FM) for singke tone's expression is :-…

Q: For the signal shown, find: 1- The total average power. 2- The average power in the fundamental…

A: Since we only answer up to 3 sub-parts, we’ll answer the first3. Please resubmit the question and…

Q: What are two of the most common GPS frequency bands? Give their correct values

A: The word GPS stands for Global Positioning System. It is a satellite based navigation and…

Q: A 1000KHz carrier is simultaneously AM modulated by sinusoidal signals of frequencies 2, 6 and 8 KHz…

A: We know that,Pt=Pc1+μ122+μ222+μ322Pc=250 W (assume)Radiated…

Q: The maximum frequency deviation for the FM signal v(t)= 10 cos(6000t+ 10sin2200t) is

Q: In What is the frequency AC signal with a period of 59.74327 milliseconds? rad/s of an

Q: 1. a) Consider a signal, x(t), with average value, Xa2 and average power, P.-3. Find the average…

A: Signals

Q: Q15: A given voltage signal f(t) = 4cos²20nt + 2cos30nt across 12. (a) Determine PSD of f(t). (b)…

A: Questions 15

Q: H.W: For the signal shown, find: 1- The total average power. 2- The average power in the fundamental…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: For the signal shown, find: 1- The total average power. 2- The average power in the fundamental…

A: For the signal shown below;Find; The total average power The average power in fundamental…

Q: What percentage of the total power in an AM signal is in the carrier, one sideband, and both…

A: The total power in an AM signal is in the carrier is 66.4%, The total power in an AM signal is in…

Q: (Difficulty: *) Consider the magnitude DTFTS |X(ej")| and Y(ej")| shown below, where vertical lines…

A: X(jw)=a1δw+a2δw-π6+a3δw-π3+a4δw-π2+…

Q: (b) A periodic composite signal is composed of 2 sine raves(S1,S2). The frequency (f) and maximum…

Q: a. For a FM signal v(t) = 30 cos ( 10 *108 t + 20 sin 3000t), (i) calculate the power dissipated by…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: frequency and how many harmonics

A: Frequency and Harmonics

Q: 01: Suppose you have the following information signal i(t) = 4sin(4000nt + %3D 90) modulates with…

A: We will find out frequency modulated signal and bandwidth for frequency modulation .

Q: A500W, 100KHZ carrier is modulated to a depth of 60% by modulating frequency of 1KHZ. Calculate the…

A: A message signal is transferred from the sender to the receiver end. The signal is transmitted…

Question

H.W:
For the signal shown, find:
1- The total average power.
2- The average power in the fundamental frequency.
3- The average power in the first five harmonics.
4- The de power.
5- The ratio of average power in the frequency range (0- 3kHz) to the total
average power.
fit)
-2
msec
-1
1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the frequency in rad/s of an AC signal with a period of 52.18985 milliseconds? Do not round off the answer
Apply the one-sided and double-sided spectral amplitude and phase on a given practical signal of
What is the frequency in rad/s of an AC signal with a period of 61.79347 milliseconds?
assume that the voltage drop across the resistor, ER, is 78v, that the voltage drop across the inductor, EL is 104v and the circuit has a toatl impedance Z of 20 ohmas. the frequency of the ac voltage is 60HZ,
A carrier (fc = 100 MHZ, A, = 25V) is frequency modulated by the sine wave (fm = 8 kHz, Am = 3V) using a frequency modulator with frequency deviation of 58kHz. Determine: (a) Carrier swing frequency of the output FM signal. (b) Highest and lowest sidebands' frequencies generated by the modulated signal. (c) The bandwidth of the FM signal. (d) The transmitted power through a 502 load. Ignore UnB < 0.1
A sinusoidal carrier voltage of frequency 1 MHz and amplitude 100 volts is amplitude modulated by the sinusoidal voltage of frequency 5 kHz producing 50% modulation. Calculate the frequency and amplitude of lower and upper sideband terms. Draw the AM Spectrum.
Q2 (B) Given m(t) = sin 2000 πt, kf = 200,000π, and kp = 8000 π.Find frequency deviation, Δf, for(i) Frequency Modulated (FM) signal(ii) Phase Modulated (PM) signal.
An AM system for a simple audio tone contains 200W in each of its sidebands. If it is modulated at 90% determine the power on the carrier frequency and the total power
Find the average value (DC)
For a function shown in the image, draw the spectrum in frequency so that the 5 harmonics are shown and indicate the value of said harmonics
A sequence of alternating 1s and 0s is transmitted as a square wave. What is the fundamentalfrequency and how many harmonics can be used if the available BW is 100 MHz and a data rate of 56Mbps is desired? Express the signal as a mathematical function of time (s(t)) and sketch the resultingsignal in both the time and frequency domains. Is this a “good enough” representation of the squarewave? Why or why not?
Frequency bands: What are low and medium frequency bands? What are the difference of the 2 and what are they used for?