forces about point Oof the cases below

Q: The primary unbalanced force is maximum, when the crank position is

A: (a) The value of the primary force is maximum when the crank is perpendicular to the line of stroke.…

Q: force members in the bars and state the

A: Given: A struss To determine forces in all members

Q: If a heavy cargo is lifted using a ship's crane and the load remains suspended within the ship, what…

A: When the heavy cargo is lifted using a ship's crane and the load is still suspended within the ship,…

Q: Need asap in 30 min i will give like

A: Given,

Q: the largest internal normal force in

A: To find largest internal normal force in  the bar

Q: In figure 2 a) what is the total weight of all bodies? b) Which one of the following is the free…

A: Total weight will be the sum of weight of all bodies.

Q: ed with a horizontal 100 N force, At which

A: given:horizontal load P=100N

Q: 2) Write introduction and conclusion for Lift Mechanism Bucket Boom Shou Mou Base

A: Parts of lift mechanism is- Base Mount Boom Shoulder Bucket

Q: A frame is being raised on a pivot point. a crane lifts the frame and shows 315 165 at 45⁰. How much…

A:

Q: 300 lb B. Ao 20 in. 48 in.- 15 in.

A: Given dataLoad P = 300lb (vertically downwards)

Q: Q2. Draw isometric view of a cylinder with of base diameter 60mm and height 60mm.

A: As per company policy, we are restricted to solve one question at a time. Please ask other question…

Q: 2000 Ib 300 lb/ft 6 in, TI A 4 in. -3 ft- 3 ft-

A: Calculate the reaction at the support, Total load on beam is=300×6+2000…

Q: Define concentrated force.

A: A concentrated force acts along a single line in space. Concentrated forces are mathematical…

Q: M- mass that can what is the maximum mass be hung fremy the keep?

A:

Q: Explain by drawing a figure the recovery or capsizing (overturning) situation of a boat in the water…

A: Capsizing when a boat or ship is turned on its side or it is upside down in the water then…

Q: 7 - Which is not a type of freight car? A) safe

A: Option (e) is correct. high edged is not a type of freight car.

Q: le load it can take is (B) 33.48 KN

A:

Q: Explain about the Oblique point loads at the surface ?

A: given: Explain about the Oblique point loads at the surface ?

Q: weight % of C in

A: Given data; Atomic weight of Fe = 65And that of carbon C=14For the data given, Find the weight…

Q: Draw the free body diagram Always use 3 decimal place

A:

Q: The maximum radial load it can sustain to

A: Given data, Bearing capacity of dynamic load of 4208 bearing is,   F= 30 kNCalculate maximum radial…

Q: 50 lb A 3 in. C B D 4 in.- -6 in.-

A:

Q: A cylindrical can 76 mm in diameter and 152 mm high, weighing 1.11 N, contains water to depth of 76…

A:

Q: An elbow in a ventilation system duct is made of sheet metal of the same thickness. Find the center…

A:

Q: A. Which of the following gives the area in square meters. B. Which of the following gives the x…

A:

Q: The simplest type of balance for weighing is the___________.

A: To balance the weight, there are multiple possible lever arrangement. One such example is shown…

Q: What is the difference in pressure between points B and A? p. - 1000

A: Density of water, ρw=1000 kg/m3 Oil specific gravity, SGo=0.9 Specific gravity of Mercury, SGM=13.6…

Q: E, calculate the internal pressure

A:

Q: 1. A vessel has cargo hold capacity of 4312 m3 and shall load grain with SF 1.3 m3 /ton. How many…

A: Question 1: Volume capacity of cargo = V = 4312 m3 Stowage factor = SF = 1.3 m3/ton   To find the…

Q: The total length of a first class lever is 9.0 ft. This is used to move a load of 390 lbs, as…

A:

Q: Draw diagrams (this requires some thought) that show to lift a heavy box, a beam can be used as a:…

A: Solution:

Q: Calculate the forces on the rod by using the method of analytics

A: Data given-

Q: The magnitude of the load

A: Given; A horizontal plate has been joined to a vertical to a vertical post using four rivets…

Q: In a pressure regulator, the ________ is attached to one end of the poppet to provide a surface for…

A: Pressure Regulator, A pressure regulator is a device which controls the pressure of liquids or gases…

Q: a positive number if in tension, a negative number if

A: The power in the part is Zero   Explanation   Utilizing the free body chart of Joint I we can close…

Q: Derive an expression for the height of Proell governor.

A: The answer is in next step

Q: force Frequired to hold the plug in its position

A: Given; Consider a frictionless, massless and leak proof plug blocking a rectangular hole of…

Q: 12. How much wall thickness is there between the counterbore and the sides of the counterweight?

A: T=0.063 Answer

Q: Sinel the weight of the pully te Kep the system in quilibrium.

A: Note:As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: A horizontal force a

A: Work- 6.5J   Kindly refer below attachment for detailed solution.

Q: maximum eccentricity of the bush in mm will

A: Given;A brush was turned after mounting the same on a mandrel.The mandrel diameter=40-0.05+0.00…

Q: g has a diameter of de up of semicirc having reluctar

A:

Q: unt of work done by th

A: given: when a man put a bag on head and he is run than the amount of work done by the man?

Q: The maximum radial load it can sustain

A: Given; The dynamic laod capacity of 6306 bearing Load=20kNThe maximum radial load?Rotation=650…

Q: Q3: Calculate the applied force to move the process

A:

Q: A steel bar of c

A: 1.2125mm

Q: Differentiate enery and force

A: energy is defined as the amount of work that can be performed by force and units of the energy is…

Q: all at A and swings in a vertic wing that it can withstand a

A: given:

Q: tion.please explain prope

A:

Q: force (in newton) normal to the slider axis

A: Given; Primary inertia forces of the slider are partially balanced by a revolving mass,m= 6 kg…

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.