Four very long, current-carrying wires in the same plane intersect to form a square with 40.0 cm each edge, as in the figure. Find out what the magnitude and direction of the current I should be so that the magnetic field is zero in the center of the square. I=? 10.0 A 40.0 cm 8.0 A 20.0 A |2 A 22 A 1. seçenek 3. seçenek

Q: An infinite straight filament is located at y axis and carrying a current of 40 A. The produced…

A: We will use following formula to find magnetic field intensity due to infinite current element.…

Q: A wire carries a steady current 7=0.75 A in Figure. The distances are d=0.5 m, b=0.9 m, =0.8 m. The…

A:

Q: 2.39x 106 Figure 4 shows a portion of a cylinder with radial magnetic field, H= -cosø â ¸ A/m,…

A: Flux passing through the surface = surface integration of magnetic flux density over the surface.

Q: 3. x* + y =4 circular loop is at (0,0,0) and (0,0,4). If the direct current of 5[A] flows in each…

A: The expression for the circular loop is given by: x2+y2=4x2+y2=22 From the expression, it is clear…

Q: Three long, parallel, straight wires each carrying a 8.0 A current pass through the vertices of an…

A: Given, Current through each wire, / = 8 A Length of the equilateral triangle, L = 8 cm = 0. 08 m The…

Q: Question 5 In a cartesian system, vector magnetic potential at a point (x,y,z) is defined as A =…

A:

Q: The the magnitude of the magnetic field density at point a is * h=6 A 2=3 A d= 10 m 6 mT 12 mT 18 mT…

A: We need to find out magnetic field at given point due to given current distribution.

Q: Three long, parallel, straight wires each carrying a 8.0 A current pass through the vertices of an…

A: Given three wire arrangement as, Each carrying current, I = 8 A Vertices of an equilateral…

Q: D.C. Power Supply 5) m A 60-cm long plastic rod is held in balance over a fulcrum. There is a 100-gr…

A: The free-body diagram of the above system is shown below:  Since the given system is in…

Q: A nonuniform magnetic fieldB inside a medium with magnetic susceptibility Xm = 16 is given as B = 3z…

A: In the question the Non uniform magnetic field B= 3z ax  Tesla  The magnetic Susceptibility  of the…

Q: * If the curl of the magnetic field is 2.0ax A/m^2, the current density is 20ax A/m^2 0.2ax A/m^2 O…

A: we need to find out the value of current density.

Q: 2) A wire carries a steady current =1.5 A in Figure. The distances are a=0.2 m, b=0.5 m, and c=0.4…

A: Force on a current carrying wire having length P and carry a current I and ina magnetic field B is ,…

Q: The segment of wire in the figure carries a current of I=3.00 A, where the radius of the circular…

A: Magnetic field is the vector field which describe the magnetic influences on a moving electric…

Q: A solenoid has 4000 turns over it with inductance of 0.126 H. The energy stored in the magnetic…

A: Given, A solenoid has 4000 turns over it with Inductance, L= 0.126 H Current, I= 2 A

Q: 6. A proton moving horizontally at 5.6 x 10^4 m/s enters a uniform magnetic field of 0.075 T…

A: The solution is given below

Q: An electron moves along the z-axis with vz = 4.7 × 107 m/s. As it passes the origin, what are the…

A: an electron moves along z axis with vz=4.7×107m/s as it passes the origin, what are the strength and…

Q: The magnetic field strength inside a certain solenoid is 0.025 T. If a 3.2 cm conducting strip,…

A: Given: Magnetic field strength, B=0.025 T Length of strip, L=3.2 cm Length is perpendicular to the…

Q: A long solenoid has 500 turns which is uniformly distributed over its length 0.6 m. It creates a…

A: The magnetic field = 0.25mT Length l= 0.6m Number of turns N= 500 Current in the solenoid I?

Q: A nonuniform magnetic field B inside a medium with magnetic susceptibility Xm = 4 is given as B = 3z…

A: In this question, choose the correct option What is magnetization current density?  All given…

Q: The first region defined as 3x+4y≥10 is the space. The second region defined as 3x+4y≤10 is the…

A: Given: The first region defined as 3x+4y≥10 is the space. The second region defined as 3x+4y≤10 is…

Q: A circular coil of wire with 7 loops and a radius of 0.041 m is placed inside a solenoid. The coil…

A: In the solution, since the cross-sectional area of the solenoid has not been given, it is being…

Q: 5. Considering Faraday's law and the definition of vector magnetic potential A the line integral of…

A:

Q: Problem # 2 A solenoid that is 100.0 cm long has a cross-sectional area of 10.0 cm². There are 500…

A: Given: A solenoid with Length, L=100.0 cm Cross sectional area, A=10.0 cm2 Turns, N=500 Current,…

Q: A wire carries a steady current l=2.5 A in Figure. The distances are a=0.3 m, b=0.7 m, and ==0.6 m.…

A: According to question: a) The magnetic force on each section of conductor is calculated as…

Q: The segment of wire in the figure carries a current of l-6.00 A, where the radius of the circular…

A: Magnetic field due to a current carrying conductor is given by- B=μoI4π∫dl×rr2 So, the magnetic…

Q: Three long, parallel, straight wires each carrying a 5.0 A current pass through the vertices of an…

A: Given three wire arrangement as, Each carrying current, I = 5 A Vertices of an equilateral…

Q: A rectangular loop (2cm X 4 cm) is placed in the X-Y plane and is submerged by a magnetic field that…

A: For the above given magnetic flux density and rectangular loop we need to calculate the value of…

Q: A nonuniform magnetic field B inside a medium with magnetic susceptibility Xm = 8 is given as B = 3z…

A: We know direct formula for magnetic current density .

Q: B y 450

A: Magnetic force: Whenever a current carrying conductor placed inside a magnetic field there will be a…

Q: A wire carries a steady current l=3 A in Figure. The distances are a=0.4 m, b=0.6 m, ar c=0.5 m. The…

A: Given data:

Q: Q2/ For two long wires as shown in the following figure I: = 6A Iz = 3A %3D B2 x [m] 1 2 3 4 The…

A:

Q: A 1.0 mm diameter copper wire(o=5.8x10) is shaped into a square loop of side 4.0 cm. It is placed in…

A:

Q: A solenoid of length 0.75 m produces a magnetic field of 7 T along its axis when its coils carry a…

A: We know the number turns formula for solenoid , from that formula we will calculate number of turns…

Q: Q4 - A magnetic circuit consisting of three parts in parallel : Part A is of length 80 mm and…

A:

Q: A long solenoid has 500 turns which is uniformly distributed over its length 0.6 m. It creates a…

A: B = u I N / L

Q: Q4: Cylidrical conductor of radius 2 cm currying a uniform current of 170 Amp. What is a magnitude…

A: Magnetic field due to cylindrical conductor           a) Magnetic field inside the cylindrical…

Q: A wire with length 1m moved with * velocity 0.5 m/s made angle 45 degree with x-axis, it is moved in…

A:

Q: A magnetic ring with a mean diameter of 25 cm and a cross sectional area of 5 cm? is wound with a…

A: A magnetic ring with a mean diameter of d=25 cm and a cross-sectional area of a=5 cm2 is wound with…

Q: Question 9 A nonuniform magnetic field B inside a medium with magnetic susceptibility Xm=2 is given…

A: The solution is given below

Q: Three long, parallel, straight wires each carrying a 8.0 A current pass through the vertices of an…

A: Given three wire arrangement as, Each carrying current, I = 8 A Vertices of an equilateral…

Q: 3- Find the magnetic field intensity at the radius of 6 cm of a coaxial cable with inner and outer…

A: We need to select the correct option as per the given condition.

Q: In the below magnetic circuit, the induction field in the air gap is desired to be \( 0.6 \) T.…

A:

Q: Four very long, current-carrying wires in the same plane intersect to form a square with 40.0 cm…

A:

Q: Two ant-parallel, semi-infinite, current-carrying wires of separationd are connected by a…

A: Given a two semi infinite anti parallel lines connected by a semi circle with a diameter d

Q: A magnetic circuit consists of silicon steel of 3000 permeability, of 0.093 m length and a…

A:

Q: One solenoid is inside the other solenoid. Both solenoids have length L and N turns. The radius of…

A: In this question we need to find a magnetic field for the given solenoid

Q: A sliding bar is moving to the left along a conductive rail in the presence of a magnetic field at…

A:

Q: A uniform thin rod PQ of length 'L' is moving in a uniform magnetic field Bo such that velocity of…

A:

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.