From the following circuit, determine the load impedance ?? necessary to ensure that the load receives maximum power and calculates the maximum power to the load

Q: Determine V, for the network Si 4.7 ΚΩ +12 V o V₂₁ GaAs 3.3 ΚΩ - 10 V

A:

Q: A pattern detector which gives 1 at its 1-bit output when the last four values of its 1-bit input…

A: Given: A pattern detector that gives 1 at its 1-bit output when the last four values of its 1-bit…

Q: A wired baseband digital communications system uses a 100 metres long cable to connect the…

A: Distributed resistance = 1ohm/m Distributed capacitance =100pF/m Frequency response equivalent…

Q: Sketch v, for the network Vi 20 V -20 V [ Vo 91Ω V₂ = 8 V 0.22 ΚΩ

A: We need to find out the output voltage for given circuit

Q: 1. The magnitude of various voltage drops that occur in an altemator, depends on...... load current…

A: In this question, we have to do fill in blanks,   (1) The magnitude of various voltage drops that…

Q: Determine the charging current (Ic) at 50 Hz of a single-conductor EHV transmission line having…

A:

Q: What is the minimum sum-of-products expression for the following Kmap?

A:

Q: Q2/A Shunt motor having a field resistance of 50 and an armature resistance of 0.5 is connected to a…

A:

Q: B/A 50 KVA, 2300/230 V, 60 11z transformer has a high voltage winding resistance of 0.6502 and a…

A:

Q: B2 Derive the Thevenin equivalent circuit for the given network. a) R1 R3 200 .Ω 5002 R Load E 24 V…

A:

Q: b) What are the equivalent ac circuit models of an ideal DC voltage and current source?

A: We need to tell about the ac equivalent circuit for DC sources

Q: A SUBSTATION RATED 1250 KVA IS OPERATING AT FULL LOAD AT 0.8 PF LAGGING AND TO CARRY AN ADDITIONAL…

A: Methods to improve power factor Adding shunt Capacitor Phase advancer Synchronous condenser ( Motor…

Q: 2. The Illogic Company has developed a new logic family which has the following characteristics: VOH…

A: A group of logic circuits built with power supply and compatible logic levels known as a Logic…

Q: 9. A 3-phase A connected generator feeds a A connected load consisting of 3 legs of 10 in series…

A:

Q: The shaft torque of a diesel motor driving a 100V dc shunt-wound generator is 25Nm. The armature…

A:

Q: H. Find the branch currents of the networks ins figure below, by using Mesh analysis:- in R₂=62 R3…

A:

Q: Explain about time graded and current graded system?

A:

Q: The n-channel JFET and the D-MOSFET have very similar I-V output  characteristics. Which of these…

A: JFET - Junction Field Effect Transistor It is a three terminal semiconductor device. The three…

Q: Determine the following for the network shown below: a. gm ZIAMP b. c. ZOAMP d. Given parameters: R…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: Q2: An AM modulator shown in figure below: a) Sketch the amplitude spectrum of Þ(t). b) Find the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The Synchronizing pulses are transmitted to keep the camera and the picture tube beams in step?…

A: In a monochrome television transmitter, the synchronizing pulses are transmitted to keep the camera…

Q: The input voltage of a Boost converter is 10V, the duty cycle of the boost converter is 0.25. What…

A:

Q: design a uncontrolled and controlled single phase rectifier

A: Rectifier is device that convert an two direction AC to single DC . it is used in power application…

Q: b) A transmitter is designed to transmit a signal S(t) Shown below, D=9 B/2 D/2 D B=2 -B/2 1. Give a…

A: SNR: It is the strength of the signal that is desired to background signal that is undesired signal.…

Q: interrupts. O O C _setting this bit enables mask able overflow flag.a interrupt-enable flag b sign…

A: Sign flag: It is set if the MSB bit is 1. For signed operations, such a number is treated as…

Q: Find the total energy stored in the circuit of Figure below 6Ω ww 4₁ = 2mH 301 42- <= 4 mH C₁ = 20…

A: We need to find out the energy stored for given circuit

Q: A 1.5 KVA 50 Hz single-phase transformer has turns ratio 40/50. The primary winding is connected to…

A: Given data, A single phase transformer has S=1.5 kVAf=50 HzN1N2=4050V1=230 V

Q: What is the flux produced when a 2.5 A current flows through 500 turns coil wound in nonmagnetic…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: At what rate the flux must be varied to measure 12 V across the terminal of 300 turns coil?

A:

Q: Q15: A given voltage signal f(t) = 4cos²20rt+2cos30nt across 102. (a) Determine PSD of f(t). (b)…

A: We need to find out the power and power spectral density of given signal

Q: Design a sequential circuit with two JK flip-flops, A and B, and two inputs, E and x. If E = 0, the…

A: A sequential circuit is a circuit with a set of inputs and outputs. The prior output is used to…

Q: An impedance coil having a 0.2 lagging pf is connected in series with a 300 W lamp in order to…

A:

Q: ✓5- Compare between the power transmitted in the (DSB-SC (DSB) if modulation index m-1.

A:

Q: When setting the Q-point of a JFET amplifier why is the bias circuit shown in Figure 3.1 (b) used…

A: Given  Two biasing circuits of JFET.we need to discuss which one is better. Please find the below…

Q: show your detailed solution

A: Resistance in parallel- 1/Req=1/R1+1/R2+1/R3+...........   Resistance in series-…

Q: The electro-dynamometer type wattmeter is shown below and assuming the diode to be ideal, the…

A: Given circuit, Primary side supply voltage, Vs=200 V (rms) Secondary side peak voltage, Vm=1002 V

Q: ower plant has a capacity factor of 40.9% and a plant use factor of 45.2%. How many hours per year…

A: A power is a place where electrical power is produced to supply the demand of its customers.

Q: Use the voltage-division principle to find the voltages labeled in Figure 2.14. R-5Q www +91 R₂-100…

A:

Q: The box in this figure contains an unknown network. When a load resistor of value R₁ = 280 2 is…

A: Given, For RL=280 Ω voltage drop across load VL=134.4 V For RL=380 Ω voltage drop across load…

Q: The shaft torque of a diesel motor driving a 100V dc shunt-wound generator is 25Nm. The armature…

A:

Q: 10-10.  A 12-bit linear PCM code is digitally compressed into eight bits. The resolution = 0.03 V.…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Determine the current flowing through an element if the charge flow is given by (a) q(t) = (3t+ 8)…

A: In this question we will find current I with related to given charge..... Note :- as per our…

Q: Determine the values of i2, 14, V2, V3. and V6 in Fig.(2). 12 A 14 " JA Fig(2)

A: In this question we need to find unknown voltage and current shown in the circuit.

Q: A dc series motor drives a load a 30revs and takes a current of 10A when the supply voltage is 400V.…

A:

Q: Determine Vce in the given circuit if VBB = 10V, VCC = 15V, RB = 10kΩ and RC = 110 Ω. Assume β = 100

A:

Q: 4.2 Please execute the Fourier transform of the following rectangular wave and figure out the…

A: We need to find out the Fourier transform of given signal

Q: how did you know the medium is a good conductor? The question gives us the conductivity but we…

A: Note: Please note that here student is having only doubt about the permittivity which is known as…

Q: A series motor has an armature resistance of 0.2Ω and a series field resistance of 0.3Ω. It is…

A: In this question we need to find speed of the motor when the load is changed such that the current…

Q: Example 7.33. Two coils of inductances 4 and 6 henry are connected in parallel. If their mutual…

A: Given two coil inductance are connected in parallel, First Coil inductance, L1=4 H Second coil…

Q: The flux linking to 200 turns coil changes from 2 mWb to 5 mWb in 1ms to 3 ms. Determine the induced…

A: