The cross section of a timber beam is 60 mm wide and 140 mm high. The vertical shear force acting on the section is 32 kN. Determine the shear stress at the neutral axis.

Q: A granular soil is subjected to a minor principal stress of 200 kN/m2. If the angle of internal…

A:

Q: B. Q): Compute the balanced axial load and moment capacity of the column shown in Figure below. Use…

A: Axial load carrying capacity of the column Pu=0.8*0.650.85 f'c Ac +As fy Ac=350*350-6*π4*202=…

Q: An undisturbed soil sample, 100 mm in diameter and 200 mm high, was tested in a triaxial machine.…

A: NoTE-  I already answered this question but again uploading with some changes.

Q: Determine the thrust, T (in Newtons), developed by each engine. Determine also the reaction at A.

A:

Q: embankment consists of clay fill for which c′ = 25 kN/m2 and φ = 27° (from consolidated undrained…

A:

Q: Plate #5 Spacing of Rivets Problem #1 The combination section shown consists of a wide flange and a…

A:

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

A:

Q: Situation 3: A steel plate is 300 mm wide and 10 mm thick with 4 bolts (22mm dia.) cut into the…

A:

Q: Q1:360 liters per second of water is flowing in a pipe. The pipe is bent by 120°. The pipe bend…

A:

Q: Question 2 The continuous beam shown in Figure Q2 is fixed at D and simply supported at A, B, and C.…

A:

Q: Problem 3. Object B weighs 100 lb. The brown cable that passes over pulley D and around pulley C…

A: Given ;

Q: An elevation must be established on a benchmark on an island that is 2536.98 ft from the nearest…

A:

Q: Determination of Discharge Thru a Siphon Vol . Q=AV ti P1 P2 +21=(√₂)² 29 + B2² + Z2 r Y Formula: Q=…

A: Given Data:h=83.5trail 1t=105v=490mltrail 2t=75v=340mltrail 3t=55v=250ml

Q: The three water-filled tanks shown are connected by pipes. Preliminary calculations and relevant…

A: Given data:- Elevation at A, ZA = 60 m Elevation at B, ZB = 20 m Elevation at C, ZC = 0 m Pipe 1…

Q: P8.11. Determine the horizontal and vertical deflection of joint C of the truss in Figure P8.11. In…

A: Deflection : In structural engineering, deflection is the diploma to which part of a structural…

Q: The cross-section notes shown below are for a ground excavation for a 8m wide roadway. STA 23+500…

A:

Q: Suppose you are a group of cadet engineers given by your department manager a "simple" task of…

A: The given data is shown below: Nominal diameter=6 inchesSchedule number=40Material of…

Q: Maximum Vertical Reaction at C in kN - Maximum Negative Shear at B in kN. - Maximum Positive Shear…

A:

Q: An oedometer test is performed on a 2 cm thick clay sample. After 5 minutes, 50% consolidation is…

A: Given: Hdr1 = 2cm, Hdr2 = 3.7m = 370cm, Double drainage conditions, t1 = 5min,  Find: t2 = ?

Q: A concentric hexagon and dodecagon have an apothem of 6ft and 7ft respectively. Determine the area…

A: We have;  Hexagon, with apothem = 6ft Dodecagon, with apothem = 7ft  Therefore side of hexagon;…

Q: In which part of Pennsylvania (eastern, central, or western) would the approach of using acid mine…

A: The mineralogy of the solid rock, as well as the access to water as well as oxygen, determines acid…

Q: Q1: (cont.) ) The shown rectangular and Wide-flange sections are considered for a simply supported…

A: As per the guidelines of Bartleby we are only supposed to answer one question if the questions are…

Q: Q8. What is liquid limit of soil.

A: To Determine What is liquid of soil.

Q: Civil Engineering ) The ordinates at 1-hr intervals of a 1-hr unit hydrograph are 15, 33, 56, 72,…

A: Given :- First runoff R1 = 2 mm Second Runoff R2 = 1 mm Third runoff R3 = 1.5 mm Determine:- The…

Q: A consolidated drained tri-axial test was conducted on normally consolidated clay. The results were:…

A:

Q: The distribution of 12 spot heights with a regular 15m spacing covering a square area which is to be…

A: Given -   The distribution of 12 spot heights with a regular 15m spacing covering a square area…

Q: loading w 1 The overhanging beam is supported at A and B and has a uniformly distributed 15.8 kN/m…

A: Maximum shear force can be determined from Shear force Diagram (SFD). Using method of section to…

Q: ass of plane: ension, T: 22,000 kg 400 N

A:

Q: loading loading M = 33 kNm at 1.5 m from en e bending moment at a section from out your answer as a…

A:

Q: A. Calculate the stress in the concrete at the top and bottom extreme fibers under a positive…

A: From the given problem, Positive Bending moment = 78kip f'c = 3200psi span  =26ft

Q: A saturated specimen of cohesionless sand was tested under drained conditions in a triaxial…

A:

Q: For the simply supported beam shown, a composite T-shaped section is to be used, shown below. Take…

A: The major stresses induced due to bending are normal stresses of tension and compression.

Q: The following data are from a direct shear test on an undisturbed soil sample. Represent the data by…

A:

Q: For the beam shown below, F = 50 kN and L= 10 m. a) Determine the reactions at the supports A, B and…

A:

Q: Using Station Average Method, find the average rainfall over a catchment with the following data:…

A: The rainfall over a catchment are 14.4mm, 32.2mm, 41.3mm, 10.4mm, 28.1mm, 21.2mm, 16.2mm

Q: P12.7. Load moves along girder BCDE. Draw the influence lines for the reactions at supports A and D,…

A: To draw influence line

Q: a smooth spacer DE. Determine the reactions at the smooth supports A and F, and also find the force…

A: Both are different questions. So I have solved only one question.

Q: discuss in deep ( Detailed explanation***)  the ways/ techniques to protect concrete, steel and…

A: The exterior protection of concrete building elements is required to safeguard the construction from…

Q: Determine the water content of soil Weight of water=21 g Weight of soil solid=45 g

A: Water content can be defined as amount or proportion of water present in Soil. In formula we…

Q: Moment of inertia of rectangular beam width 8 m and depth 6 m is

A: Given: Rectangular beam width, b=8 m and depth=6 m  To find: Moment of inertia     Since axis about…

Q: Find Internal External Find and draw SMT Diagrams

A:

Q: al curve is intended to connect grades of 4.3% and -3.5%. If this curve is to E cermine the minimum…

A:

Q: Fill in the blanks d: Determine the distance, d. VA = 40 m/s 30° A 5 d 1 - 1 attachment - B

A: Given Data:VA=40m/sθ=30°slope= 5:1

Q: The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 16+4400…

A:

Q: single-span which carries a uniform load of 26 kN/m applied on the narrow side of the beam has an…

A:

Q: Determine the division of flow and head loss from A to B, if the given c = 180 for all pipes. Note…

A:

Q: vertical reaction at support A = ? 2 kN/m A B 3.2 m 4 kN C

A: The length of beam, L=4mThe loads are 2KNm over the full length and 4KN at 0.8m from right support.

Q: test on an undisturbed soil sample. Represent the data by a Mohr Circle and compute the direction of…

A:

Q: 10-21. and D are pins. El is constant. Determine the reactions at the supports. Assume A 15 ft 20 ft…

A: Given :

Q: vertical reaction at support = ?

A: Given: Cantilever beam with loading:   To find: Vertical reaction at support