PLEASE ANSWER ASAP Get the inverse Laplace of s/(s^4 - 5s2+ 4).(e*(4t)+e*(-41)- et- e/6(e(21)+e"(-21)- et- e(-0)/5(e*(21)+e*(-21)- e(31)- e"(-31)/6O (e(30)+e*(31)- e*t e*/6(e*(21)+e*(-21)- e*t- e/6(e(31)+e"(31)- e*t e*ysO(e*(21)+e*(-21)- e(31)- e"(-31))/5O (e(21)+e*(-21)- e(41)- e"(-41)/5

5th option is correct Given rational function can be simplified and write in partial fraction…

Get the inverse Laplace of s/(s*4 - Ss2 + 4). O (e*(4t)ee"(-41)- e*t-ep/6 O (e*(21)+e"(20)- et-e-1)/5 O (e(20)+e"(-20)- e(3- e(-31)/6 O (e(3)+e"(31)- et eq6 O (e(21)+e"(21)- e*t- e/6 O (e(31)+e(31)- et e/s O (e*(21)+e"(-21)- e(31)- e(31))/5 O (e(21)+e"(-21)- e(41)- e"(-41)/5

Get the inverse Laplace of s/(s4 - Ss2 + 4). O (e(4t)ee"(-41)- et-ep/6 O (e(21)+e"(20)- et-e-1)/5 O (e(20)+e"(-20)- e(3- e(-31)/6 O (e(3)+e"(31)- et eq6 O (e(21)+e"(21)- et- e/6 O (e(31)+e(31)- et e/s O (e(21)+e"(-21)- e(31)- e(31))/5 O (e(21)+e"(-21)- e(41)- e"(-41)/5

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Why half-wave rectifier is generally not used in DC power supply

A: Why half wave rectifier is generally not used in DC power supply

Q: What is the mass of an electron?

A: What is the mass of an electron?

Q: Q4/ The average time between the two scattering events is denoted by:

A: Given: Average time between two scattering events

Q: Why is it necessary to conduct polarity tests on transformers?

A: Polarity test: It is a test conducted on primary and secondary winding of a transformer and to know...

Q: The circuit below has the following conditions: a. diodes are Silicon with voltage across each diode...

Q: Consider a silicon pn junction at T= 300 K with acceptor doping concentrations of 101 cm and donor d...

Q: 4. Calculate the working values of the following circuits from the parameters in the given table. pa...

Q: Compute a single equivalent impedance for this circuit for a source frequency of f = 60 Hz. Express ...

A: Solution Given that f=60HZ

Q: With suitable illustrations explain the principle of operation and working of Moving Iron instrument...

A: Moving iron instruments In moving iron instruments, deflecting torque is proportional to the square ...

Q: DATE: 5

Q: Consider a silicon pn junction at T = 300 K. Assume the doping concentration in the n region is 1020...

A: We need to find out the minorities carrier density for given diode .

Q: 4Z - 3Z* = (1 - 18j)/(2 - j). What is the value of Z in rectangular form? note that Z* is the conjug...

A: Assume z = x+iy. Z*= x-iy Substitute in above equation , solve for x and y . Substitute x and y in ...

Q: Describe how duty cycle is generated by saw-tooth and sinusoidal modulating signal and compare their...

A: Duty Cycle- Duty Cycle is a ratio of a circuit to which it is ON to the time period when the circuit...

Q: Q9/ The theory that describes the conduction in semiconductors, metals and insulators is called........

Q: Perform the indicated operation and write your answer in rectangular and polar form

Q: Q6/ The first scientist who discovered the nucleus of the atom is: *

A: Ernest Rutherford discovered the atomic nucleus in the year 1911. He bombarded a beam of alpha parti...

Q: R1 750 R2 1250 R3 200 0 ww 10 O v1 = 2.8 V2 = 4V V3 = 3.2V O v1 = 1.11 V2 = 2.22 V3 = 1.66 O v1 = 1....

Q: 1. Assume that a set of currents given by the equations below will be applied to the stator containi...

A: Here is your answer! I hope this will help you.

Q: Determine IR (in mA). Rs 220 2 IR Vz = 10 V Pz. 20 V VL = 400 mW Zmax 470 N.

A: This question belongs to analog electronics . It is based on the concept of zener diode as a voltage...

Q: Q8/ The resistance of space charge region can be neglected if the applied voltage is high enough *

A: The resistance of space charge region can be neglected if the applied voltage is high enough.....

Q: Determine the current I3 in the circuit below in polar form. Write the magnitude only in four decima...

A: The solution is given below

Q: Give at least 3 important specifications of a rectifier circuit. For every specification, explain wh...

A: To convert Alternating supply to Direct supply DC, Rectifiers are used. It can controlled as well as...

Q: An autotransformer having a transformation ratio of 0.62 supplies a load of 2 kW. The power transfer...

Q: Figure Q1(b) shows a negative feedback system. The amplifiers' open loop gains are given as follow: ...

A: It is given that: A1f=251+jf5000A2f=181+jf5000A3f=201+jf5000

Q: PR1 + REF1 V 2 R1 V1 1k2 | 2V 1kHz 0° С1 REF1 1000F 1. (+

Q: An inductance of 0.106 Henry is connected to a 120-volt 60-cycle source. Calculate (a) the inductive...

A: As per our guidelines we are supposed to be answer only the first 3 questions. Kindly repost the oth...

Q: Identify the corresponding transfer function of the state-space equation below. 1 0 u (t) 1 -18 -21 ...

Q: x(t) = 4 Sinc(8t)cos(10t). a) What is the mathematical representation of X(@)? Sketch it. b) Compute...

A: We need to find out the Fourier transform of given signal and its sampled signal and energy for the ...

Q: Parameter Minimum Typical Maximum Units de supply voltages Vs Input offset voltage Vos Thermal drift...

Q: 12–7. A particle moves along a straight line such that its position is defined by s = (² – 6t + 5) m...

Q: R1 R4 3.0 kn 1.5 kn +10V +V R2 R3 2.5 kn 7.5 kn Figure 4.5

Q: 102 (†)4mA is

Q: Design a Digital Cellular system, if the total number of available channels is 270 and 80K subscribe...

A: Cellular network A cellular network, also known as a mobile network, is a network of mobile base sta...

Q: A 2300/230-volt distribution transformer is tested for polarity. If 118 volts is impressed across hi...

Q: Q.3 Find the technique (2TF RIS) Ha RLS), és)

A: Transfer function: It shows the relation between output and input of the system.

Q: A synchronous motor absorbing 60 kW is connected in parallel with a factory load of 240kW having a l...

Q: Ri is Ohmic but R2 is not. The current in R1 is h. The potential difference between A and B: O a. De...

A: for ohmic resistor current is directly proportional to voltage Whereas In non ohmic resistors there ...

Q: A synchronous generator with 6 magnetic poles supplies an induction threephase motor. Considering th...

A: Pole: This is placed at the stator and on this winding will be done. With the help of the pole magne...

Q: 8Ω + 5A 12Ω

Q: The voltage applied to a purely inductive coil of self-inductance 15.9 mH is given by the equation v...

Q: three phase inverter

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is revers...

Q: 1. If the current in the 6-ohm resistor is 18 amperes, determine the voltage E and the following cur...

Q: shunt generator delivers 100 A at terminal voltage of 250 V. The armature resistance and shunt field...

Q: A power conversion system having an impulse response h[n]={1,-1} accepts the input x[n]={1,-2,2, 1,3...

A: Overlap save method:

Q: 1- Find phase margin, gain margin, gain crossover frequency, phase Crossover frequency, delay margin...

A: The stability of the system can be calculated by using the bode plot. The Gain margin and Phase marg...

Q: A discrete time signal x[n]= {a+4, a+4, a-0, a-2} is applied to a 4-bit microprocessor to compute th...

A: Given, x[n] ={a+4,a+4,a-0,a-2}

Q: foo 3.

Q: The periodic signal X(t) is shown ih thế föl repeated every 4 seconds. ing figure. It is a rectangul...

A: We need to represent the given waveform and we need to find Fourier transform of given signal

Q: H(s)

A: It is given that:

Q: The input and output of an electronic system are governed by the following ODE: d²y dt2 dy 4- + 4- +...

Question

PLEASE ANSWER ASAP

Get the inverse Laplace of s/(s^4 - 5s2+ 4).
(e*(4t)+e*(-41)- et- e/6
(e(21)+e"(-21)- et- e(-0)/5
(e*(21)+e*(-21)- e(31)- e"(-31)/6
O (e(30)+e*(31)- e*t e*/6
(e*(21)+e*(-21)- e*t- e/6
(e(31)+e"(31)- e*t e*ys
O
(e*(21)+e*(-21)- e(31)- e"(-31))/5
O (e(21)+e*(-21)- e(41)- e"(-41)/5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please Obtain LAPLACE Domain Represtation and equation of current and voltage and Daw SFG .
Please write the state-space equation by first finding the Laplace domain equation. Thanks!
Please provide step by step explanation for the answer. Thank you. Explain and describe and discuss Poisson and Laplace equations. Suggest methods for solving them in one, two, or three-dimensional problems.
Vc(0)=3V Ir=? Solve with Laplace
Find v0(t) for t>=0 when vc(0-)=0V r1=1ohm r2=2ohm C=1F rm=2 e(t)=30u(t)V but do not use laplace use the compute the valuea at certain amounts of time and use the general equation to find it
Problem 1. Which gives the Laplace transforms of the given time-domain function? Let a = 2 pi - 2arctan (s/6) pi - 2arctan (2s/3) pi - 2arctan (s/3) (1/2)pi - 2arctan (s/3)
Using Laplace find out ZI response and ZS response for following system described in DE:(D 2 +3D+2)y(t)=Dx(t), when the initial conditions are Y0(0)=0 and y’0(0)=-5
can you explain the Frequency shift and time shift properties of laplace by doing a step by step soluation of diffrental equations. please explain each step so I can grasp the concepts. thank you & god bless
Solve correctly please both parts. Will provide helpful ratings for correct answer. ( 1) Solving the differential equation X(0)= X(0)=0 by Laplace measurement for initial dt dt conditions 2) Find the roots and coefficients of the Laplaced function by factoring it, and then find ft by taking the inverse Laplace urgent please) Note: Refer equation in image
LaplaceTransform[Piecewise[{{t, 0 ≤ t < 1}, {E^t, t >= 1}}, 0] convert it in first laplace equation , i dont need solution or answer, just convert it into equation
Problem 2 Networks. Suppose that the currents i1, i2 of an electrical network with an inductor, a resistor, and a capacitor were governed by the system of first-order differential equations:Li'1+ Ri2 = E(t), RCi'2 + i2-i1 = 0. Solve the system under the conditions E(t) = 60V L = 1H , R = 50Ohm C = 10-4F and the currents i1 and i2 are initially zero. Using Laplace transforms
Solve the following using the Laplace definition only, do not use shortcuts/given properties 1. L[t^3] 2. L[t^n]