Given that mu = 25Katm−1 for nitrogen, calculate the value of its isothermal Joule–Thomson coefficient. Calculate the energy that must be supplied as heat to maintain constant temperature when 15.0 mol N2 flows through a throttle in an isothermal Joule–Thomson experiment and the pressure drop is 75 atm.

Q: Exactly which job you are applying for O Beginning O Middle O Closing

A: At the starting, you have to mention in the letter for which job you are looking for.

Q: Calculate the molar flow of the stream labelled, n (n dot 1) in the diagram shown below. hi mol/s…

A:

Q: ) F +6B→2E +YC AH"= ? Jven 2D +YB>ZE A+B> 2C 2D+ 2A E me AH°=-3884)/mu AH°= -456 Kmal %3D

A: Write the given reactions as follows: 2D + 4B → 2E ;  ∆H = -101 kJ/mol      ......1

Q: 2. Illustrate the preparation of porous carbon materials using sugarcane biomass.

A: Porous carbon materials range from carbon blacks, activated carbon cloths, carbon molecular sieves,…

Q: 7. Why is porosity and permeability important?

A: Porosity is explained as the measure of the empty or void space inside the material. It is…

Q: There is a mixture of benzene (A) and toluene (B). When the total pressure is 760 mmHg and the gas…

A:

Q: Water flows over a waterfall 100 m in height. Take 1 kg of the water as the syste and assume that it…

A: Given, Height = 100 m

Q: 1-the reason of using heat plate exchanger for sterilization of milk in dairy industry .??? 2-the…

A: From many years heat exchangers have been widely used in dairy industry for various purposes…

Q: (a) Half-life of a compound decomposing in second order process only depends on the reaction rate…

A: Note: We are supposed to answer only 3 subparts of the questions as per our guidelines. please send…

Q: :- Find the mobilities, and resistivities of silicon samples at 300 K, for each of the following…

A: Use law of mass action

Q: Air conditioners dry the air while they cool the air. Suppose an air conditioner is used to cool a…

A: Write the ideal gas equation as follows: pwaterV = nRT         ......1

Q: A solution composed of 47% ethanol (EtOH), 13% methanol (MeOH), and the balance water (H20) is fed…

A: Given Data

Q: The enthalpy required to heat n moles of a gas from T1 to T2 can be found by integrating the heat…

A: Given data: The specific heat of CO2 at various temperature is given.

Q: Identify the process industries in Oman where these mass transfer operations are deployed and…

A: Introduction Some of the prominent chemical industrial complexes in Oman are Sohar International…

Q: Calculate the enthalpy change (J) for the isothermal compression of 1.5 mol He from 2 atm to 10 atm…

A: Write the expression for the Joule-Thomson coefficient in terms of enthalpy as follows: μ =…

Q: When all the products of hydrocarbon fuel ethane (C2H6) are in gaseous phase, the enthalpy of…

A:

Q: Give the IUPAC name for the following compound. ÇH3 OH CH3-C-CH2-CH-CH3 CH3 Spell out the IUPAC name…

A: Hello Subscriber! There are multiple questions posted.. As per our policy, we have solved the first…

Q: 19. The relationship between the change in Gibbs free energy and the emf of an electrochemical cell…

A: Given, Change in gibbs free energy=∆G and emf of cell=E

Q: The cost of grading and spreading gravel on a short rural road is expected to be $300,000. The road…

A:

Q: 1) A typical distillation column consists of several major parts. List all the major parts and the…

A: Dear User! As per our authoring guidelines, we have solved the first of the three independent…

Q: Which of the following organisms is the most resistant to chlorination disinfection? A. Shigella…

A: Chlorination disinfection:

Q: 32 kg/h of liquid methanol is burned with 10% excess air. The flue gases exit at 787 mmHg. What is…

A:

Q: Ammonia is formed in a reactor according to the reaction in the presence of excess nitrogen. If 34…

A:

Q: Exactly 100 pounds of cane sugar (CuH2On) is accidentally discharged into a small stream. If the…

A: Note: As per our guidelines we are supposed to answer only one question at a time. Kindly repost the…

Q: A two-stage, double-acting compressor is to deliver 90 lb/min of air from 14.3 psia and 90 ̊F to a…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: In an experiment to determine its enthalpy of vaporization, liquid tetrachloromethane, CCI4, was…

A: Given data: Current = 0.933 Amp Voltage = 24 V Time = 30 s Amount of tetrachloromethane = 3.45 g

Q: Q-24: Design a circular primary settling tank for a sewage treatment plant. Given data are: Flow…

A: The reaming design parameters needed for the tank are the diameter and horizontal velocity of flow.…

Q: A body cooling rate can be expressed following Equation 1. dT = -k(T – Ta) dt (Eq. 1) where T=…

A:

Q: Derive an expression for the isothermal compressibility of a gas that obeys the Dieterici EOS. The…

A:

Q: Q13. The wear resistance of a steel gear is to be improved by hardening its surface. This is to be…

A: Given data: Pre-exponential factor = 2.3 ×10–5 m2/s Activation energy = 148 kJ/mol Initial…

Q: What horsepower is required to isothermally compress 800 ft3of air per minute from 14.7 psia to 120…

A: Given:  P1 = 14.7 Psia   P2 = 120 psia  V1 = 800 ft3/min  we know that,  W =  P1V1 ln(P1P2)

Q: A water bath is laboratory equipment made from a container filled with heated water. It is used to…

A: Given Initial pressure of gas =33 bars Initial volume of gas = 10 m3    The gas expands isothermally…

Q: a. Reduce the general differential equation for mass transfer to write the specific differential…

A:

Q: (a) Half-life of a compound decomposing in second order process only depends on the reaction rate…

A: Note: We are supposed to answer only 3 subparts of the questions as per the fuidelines. please send…

Q: Precipitated silver chloride should not be left for a long time in the atmosphere. Why?

A: To answer why precipitated silver chloride should not be left for a long time in the atmosphere.

Q: J is the nucleation rate, solve this; 1.0086 = exp (-J (0.2) )

A: Given, the expression for nucleation rate is 1.0086 = exp-J0.2

Q: 2._C,H,(g) O(g) CO.(g) + H,O)

A: Given: C2H4(g)+O2(g)→CO2(g)+H2O(g) Now let us balance the reaction The Number of atoms in reactants…

Q: 7. For each given set of starting materials, write a complete balanced equation with chemical…

A: NOTE: as per our guidelines we are supposed to answer only first three sub- parts when multiple…

Q: for a feed rate to the process of 1200 kg/h, based on the flow chart below help me to determine the…

A: The production ate and percent recovery of ethanol is to be determined.

Q: A right 10-L tank initially contains a mixture of liquid water and vapor at 120°c with 20 percent…

A: Given Data Volume of the tank (V) = 10 L Temperature of liquid water and vapour (T1) = 1200C = 393 K…

Q: Calculate the heat absorbed for isothermal reaction, C4H10 (g) →C2H4 (g) + C¿H6 (g); at 298 K and 1…

A:

Q: Explain how to determine the theoretical singularity using the McCabe-Thiele method in continuous…

A:

Q: long pipe of diameter 9-in. at the rate of 125 kg/min. Determine the following if both pipes are…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: The following information is given for mercury at 1 atm: AHp (356.60°C) = 295.6 J/g Alla(-39.00°C) -…

A:

Q: b) Determine the standard enthalpy change and std. Gibbs free energy change of | reaction at 400 k…

A: Given: CO+2H2→CH3OH The enthalpy of formation and Gibbs energy formation at 298.15 K is given as…

Q: 3. These equilibrium constant are measured in the reaction below at 300 K: [Cu = 0.148 M, [Sn-lF…

A: The equation is balanced before obtaining an equilibrium concentration. The equilibrium constant at…

Q: (a) Half-life of a compound decomposing in second order process only depends on the reaction rate…

A: Note: We are supposed to answer only 3 subparts of the questions. please send the other questions as…

Q: Whaich of the following pressure-tap arrangements will be able to measure the minimum pressure of…

A:

Q: A first-order reaction has rate constants of 4.6 x 102s and 8.1 x 102 s1 at 0°C and 20.°C,…

A:

Q: BME 101 Introduction to Biomedical Engineering Shown here is the Hawking equation that describes…

A: Write the Hawing equation as follows: S = πAkc32hG       ......1   Given the units of each variable…