Answered: Given the following: Cost of borrow =…

Given the following: Cost of borrow = 500 pesos per cubic meter Cost of haul = 20 pesos per cubic meter / meter station Freehaul distance = 40 meters Solve for the length of economic haul.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter20: Engineering Economics

Section: Chapter Questions

Problem 19P

See similar textbooks

Related questions

Q: For the dam cross-section shown below, determine the minimum value of b such that the resultant…

A: dam : A dam is a structure that is built across a stream or river. Water collects at the back of the…

Q: Problem 5. A small river is in flood stage and you need to estimate the flow rate through it. The…

A: Q=1.49nAR23S12 Area of the channel A= 100*10+2*500= 2000 sq ft P= 10+100+8+500+2= 620 ft R= A/P=…

Q: Determine the equations of the elastic curve using the x1 and x2 coordinates. Use the method of…

A: To find equation of elastic curve

Q: 4) When the required torque has been achieved the tension control bolt splined end spins off? Tor F…

A: Torque- It tries to rotate a body about an axis.

Q: A 30-cm by 15-cm Venturi meter is mounted on a vertical pipe with the flow upward. One hundred…

Q: Determine the critical time te (days) for the DO of the river. Calculate the minimum DO…

Q: 1) Critical Path for this project 2) Total free slack times for each activity 3) Total completion…

A: As per our company guidelines we are supposed to answer only one question kindly Repost other…

Q: Almost every country in the world uses SI Units (metric system) except for the United States.…

A: Use of SI system is very famous and here are some reason why America should also use it .

Q: 4. A non-prismatic beam is loaded as shown in the figure. If the slope of point C is S/EI, what is…

A: Using moment area theorem 1. The slope at free end of cantilever is equal to the area under M/EI…

Q: 4) A simply supported reinforced concrete beam, 240 mm wide, carries inclusive loads as shown in the…

A: Reinforced concrete beam : Reinforced concrete beams are structural elements that are designed to…

Q: Determine the slope at D and the displacement at the end A of the beam. EI is constant. Use the…

A: Given - To Find - Determine the slope at D and the displacement at the end A of the beam. EI is…

Q: The force F in the figure is equal to 10 kN. Determine the following forces: 1. Forces at support BD…

Q: Discuss the factors accounted for by the modification factor K12 in the design of timber members.…

A: Permissible stress : Civil engineers utilize a design philosophy known as permissible stress design.…

Q: A rectangular beam 250 mm wide, 500 mm deep is reinforced at the bottom with 4-20-mm-diameter bars…

Q: Problem 5. A small river is in flood stage and you need to estimate the flow rate through it. The…

A: Q=1.49nAR23S12 A= 100*10+2*500= 2000 ft Sq P= 620 ft R= 3.226 ft Assuming S=0.001 By COX METHOD…

Q: Find the magnitude of the reaction at point C. See figure below. 20K -ax 8' F -Cx G' to ,81 cy dy

Q: Housing areas A3.0 acres Aso aeres Intel MH3 net A-40 neres Cemetery iet MHT Ditancs between M…

Q: For the built-up shape shown in the figure, determine: Situation 21. A. by = 200 mm ty = 10 mm h =…

A: We will calculate each according to axis and formulas

Q: The length of a beam is nine meters. From the left end, it carries a triangular load of 300N/m.…

Q: * Your answer is incorrect. For the cantilever steel beam [E = 230 GPa; I = 87x 10 mm*1, use the…

Q: в 5m 5 m 5 m 5 m 5 m As 5 m E C 5 m 30 kN 20 kN From the aiven truss, which member has an internal…

A: To find out the member force which has internal tension force of 57.7 KN

Q: The composite bar shown is firmly attached to unyielding supports. The bars are stress-free at 20…

A: ASKED: To determine stress on segment AB. Given, For segment AB, Length (L1) = 300 mm…

Q: Which of the following gives the reaction at F in the given beam? O 24 kN 10 kN/ m A F 20 kN. m B C…

Q: A block of wood that weighs 16lbf and of specific gravity with a relative density of 1213.6 lb/yard3…

Q: ep in digital format plea

Q: For the loading shown, use the double-integration method to determine (a) the equation of the…

Q: s an inlet time of 7 min. The coefficient of runoff for the 2 housing area 1 and 2 is 0.55 and area…

Q: Compute the axial force of column AB. * O a. 122.90 kN-m O b. 132.75 kN-m O c. 144.18 kN-m O d.…

A: First draw the FBD of whole structure and calculate the reaction at C by summing up moments at point…

Q: Four small spheres, each of which you can regard as a point of mass 0.400 kg, are arranged in a…

A: Given Data: m= 0.4kg L = 0.7m

Q: A pipe network consists of pipeline 1 from A to B then at B it is connected to pipelines 2 and 3,…

Q: The infiltration capacity in basin is represented by Horton’s equation as fp=5.0 + e-5t…

A: Using Horton's Equation

Q: A soil profile is shown in Figure 7.28. An embankment load of 500 kg/cm² is placed on the ground…

A: Given data h = 26ft p = 500kg/cm2 first change the units: 500X2048 = 1.06 X 106lb/ft2

Q: A rectangular beam 250 mm wide, 500 mm deep is reinforced at the bottom with 4-20-mm-diameter bars…

Q: Maximum Deflection

Q: 96 mm 96 mm 66 mm

Q: From the figure shown, Determine: The plastic section modulus about the horizontal axis. x10^6 mm^3…

Q: A horizontal tension member is to be constructed of two pieces of plastic glued along the incline pq…

A: Given data, Inclination angle with horizontal = 30° Tensions stress = 5 Mpa Shear stress = 3 MPa…

Q: Find the valur of force applied if work done is 320 J and displacement is 23 m

A: Introduction : The given question is related with mechanics . In this question we are provided with…

Q: Problem 8: A-C fc=4500 psi 2 in Grade 60 #6 bars - # 4 stirrups 1.5 in. clear cover 3/4 in. max.…

A: Given data: f'c=4500psi=31Mpafy=Grade 60=415Mpaeffective depth=d=20in=508mmMaximum depth ofneutral…

Q: A Channel runs along almost parallel to a river ,and they are 2000 ft apart. The water level in the…

Q: 4) A simply supported reinforced concrete beam, 240 mm wide, carries inclusive loads as shown in the…

A: Effective depth The distance between the extreme compressive concrete fiber and the centroid of…

Q: Explain and elaborate the significance of determining the specific gravity of liquids in hydraulics.

A: The expression "Specific Gravity" (SG) is utilized to characterize the weight or density of a fluid…

Q: 12 kN 3 m 3m C 4 m 8 m 15 kN 4 m 20 kN/m B Refer to the figure, what is the moment reaction at…

A: A loaded frame structure is given and it has been asked to determine support reactions at A. Please…

Q: k with hexagonal cross-section shown is fabricated from dinal stress along the thickness caused by…

Q: The simply supported beam consists of a W21 x 44 structural steel wide-flange shape [E = 29,000 ksi;…

Q: Eg = 40(10), Eb = 980(10*), ɛc = 330(10*) 1) Calculate the strain %3D %3D %3D

Q: A rectangular beam 350mm wide is to be designed for an ultimate moment of 750kN.m with f’c=28MPa and…

A: As in question design code is not mention but by seeing the all parameters unit ,I assumed that IS…

Q: A rectangular beam 250mm wide, 500 mm deep is reinforced at the bottom with 4-20-mm-diameter bars…

Q: A steel rod of 20mm diameter is used as a tie member in the roof bracing system, and may be…

A: Given: Diameter of steel rod, D = 20 mm

Q: Determine: The plastic moment with bending about the vertical axis if Fy = 345 MPa. kN-m (rounded…

Question

Given the following:

Cost of borrow = 500 pesos per cubic meter

Cost of haul = 20 pesos per cubic meter / meter station

Freehaul distance = 40 meters

Solve for the length of economic haul.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Service Output MethodGiven:FC = 800,000.00 pesosSV = 200,000.00 pesosn = 5 yearsOutput in year 1 = 300 unitsTotal output in 5 yrs = 1000 unitsa. Depreciation per unit = ?b. BV1 = ?
as per the guideline of bartle the tutor may should have to solve 1 quetion and or three sub part of that question plzz solve the both parts of question 1need urgentl plzz
b) For the selected site, how much profit can be made if it is paid P362.25 per cubic meter delivered to the job site? Sol’n to bREVENUE = ?PROFIT = ?
A silo consists of a right circular cylinder surmounted by a hemisphere. Find themost economical proportions for the silo, if the walls cost Php 3/sq in, the floorcosts Php 9 /sq in and the roof costs Php 12/sq in.
Compute the Following: a. length of economic haul.b. the overhaul volume.c. the volume of borrow.d. the volume of waste.
Compute the initial value of the money if the barrower needs deposit the accumulated amount of P59,137 to the bank after 8 months and 24 days if the money has the interest rate of 19% per annum.
A man bought an equipment which cost P520,000.00. Freight and installation expenses cost him 31,000.00. If the life of the equipment is 15 years with an estimated salvage value of P120,000.00, find its book value after 8 years.
Please help me asap. A silo consists of a right circular cylinder surmounted by a hemisphere. Find the most economical proportions for the silo, if the walls cost Php 5/sq in, the floor costs Php10 /sq in and the roof costs Php 15/sq in.
On a road project, cost of borrow is 407.33 in pesos and cost of hauling is 38.89 pesos in meters of station. if the lenght of the free haul distance is 56 m, detrmine the lenght of economic haul in meters if stationing is standard at 20m.
A dam is designed for a return period of (30) years. It will require (5) years to complete the construction of the dam, Find: 1) Theriskthatthedammaygetwashedawayduringconstruction. 2) Iftheriskisexpectedtobeonly(6%),whatwillbethereturnperiodforwhichthedam should be designed?
Economics Calculate the Capital cost of a project that has an initial cost of P3,000.00 and an additional investment cost of P1,000,000.00. at the end of every ten years. The annual operating cost will be P100,000.00at the end of every year for the first four years and P160,000.00 thereafter. In addition, there is expected to be recurring major network cost P300,000.00 every 13 years. Assume i=15%.
Engineer Layla purchased a dump truck worth P850,000. She added P50,000for the delivery and other expenses. The said equipment is expected to be useful for 10 years. At the end of its life, it will cost x% of the first cost. Using SLM, its book value at year 5 is P517,500. What is the value of x?