Gold 1 km Silver 2 km 1. A cylindrical conductor wire is made using gold (o = 4.1 × 107 S/m) and silver (o = 6.3 × 107 S/m) as shown in the figure. 1 km section of the cylindrical conductor is made of gold and 2 km section of the cylindrical conductor is made of silver. The radius of the cylinder is r = 4 mm. A DC current of 20 A is flowing through 3 km of this wire.

Gold 1 km Silver 2 km 1. A cylindrical conductor wire is made using gold (o = 4.1 × 107 S/m) and silver (o = 6.3 × 107 S/m) as shown in the figure. 1 km section of the cylindrical conductor is made of gold and 2 km section of the cylindrical conductor is made of silver. The radius of the cylinder is r = 4 mm. A DC current of 20 A is flowing through 3 km of this wire.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.12MCQ

See similar textbooks

Similar questions

The magnetic field intensities inside and outside of a long and smooth conductor with a cross section radius are as follows. Accordingly, find the current densities J inside and outside the conductor. (Hint: Use cylindrical coordinates)
Find the capacitance in picofarad between inner and outer curved conductor surfaces shown in the figure containing two dielectrics, εr1 = 4.9 and εr2 = 3.5. Here r1 = 39.4 mm, r2 = 64.4 mm, α1 = 19.7 degrees, α2 = 41.2 degrees and L = 158.6 mm.
A cylindrical conductor of radius 1 cm has an internal magnetic field ? = ?0 (?2−?20.03) ?Φ ?/?Find the total current carried by the cylindrical conductor.
3. As shown in the figure, a current of 3D204 flows through a long U-shaped (hairpin)-shaped conductor made by bending the conductor in a semicircle with a radius of R = 100mm. Point 6 is the middle of the straight part, very far in a semicircle, and the straight part can be approximated as an infinity line. Find the (a) magnitude and (b) direction of B at point a, respectively, and (c) magnitude and (d) | Find each direction.
: A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points Aand B are 15 cm and 5 cm from the center of the conductor, respectively. If a test charge, q = 25mC, is to bemoved from A to B, determine the following:a. The potential at A; b. The electric potential energy at B; c. The work done in moving the test charge; d. The rate of change of the potential with respect to length or displacement in the conductor Assuming the dielectric of each capacitor is air and the network is connected to Vab = 30V supply, calculate thefollowing:a. The equivalent capacitance between a and b. b. The charge on each capacitor. c. The potential difference on each capacitor d. Energy stored on each capacitor
As seen in Figure-2, the potential on an infinitely wide conductor plane measured. A point load of -3C was placed at (-5.6) and a point load of 4C was placed at (6.8) point. (-2,2) Calculate the potential value and the electric field created at the point. The energy stored in the system calculate. suvject is elctromagnetic field theory.
A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A and B are 15 cm and 5 cm from the center of the conductor, respectively. If a test charge, q = 25mC, is to be moved from A to B, determine the following: a. potential at A b. electrical potential energy at b c. work done in moving the test charge d. rate of change of the potential with respect to length or displacement in conductor
A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points Aand B are 15 cm and 5 cm from the center of the conductor, respectively. If a test charge, q = 25mC, is to bemoved from A to B, determine the following:
The inner conductor of a long coaxial cable has radius a. The inner radius of the outer conductor is b. Inner conductor V0, outer conductor at 0 potential. Determine the electric potential and electric field strength in the insulating material.
A 2a-part piece of wire was removed from the middle area of my upper edge, consisting of rectangular conductive wires with a long edge of 10a and a short edge of 4a, and replaced with a semicircular conductive wire with a radius. A constant I current passes through the closed ring in the way. What's the magnetic field vector at that point? (Get T=3).
A spherical conductor is known to have a radius and a total charge of 10 cm and 20uC. If points A and B are 15 cm and 5 cm from the center of the conductor, respectively. If a test charge, q = 25mC, is to be moved from A to B, determine the following: a. what is the work done in moving the test charge? b. what is the rate of change of the potential with respect to length or displacement in the conductor?
A long, solid, cylindrical wire of radius A has a current density given by j = j0r/A. Determine the magnetic field, within the wire, in terms of the total current "I" flowing through the wire.