h of the following quantifies the degree of completion of a certain reaction? O equilibrium constant O percent yield extent of reaction chemical potential ropanol to boil at a higher temperature than the normal boiling point, the pressure must be Lower than 1 atm Higher than 1 atm

Q: A triple effect standard vertical tube evaporator each effect of which has 140 m² of heating surface...

A:   a) Let  basis= Amount of feed of solution mf =100 kg enters in evaporator Feed containing 5% o...

Q: How old in years is a bottle of a solution if the deuterium 2H content is 67% that of a new wine? Th...

A: Given, half life=1 century=100 years For 1st order reaction, K=ln2t12=0.693100=0.00693 For CA=67%=0....

Q: Which selection from the section "Stronger Than Gravity" explains WHY you stay in your seat when rol...

A: It is asked the force dominating for free falling body when roller coaster fall upside down with ver...

Q: It is the relationship between chemical reactions and electricity. A Chemical Equilibrium Nuclear Ch...

A: To choose the correct option that describes the relation between chemical reactions and electricity

Q: The vapour pressure of benzene between 10°C and 30°C fits the expression log(p/Tor) = 7.960 – 1780/T...

A:

Q: A step change of magnitude 3 is introduced into the transfer function. Determine the response Y( t) ...

A:

Q: 12.7/ Determine the flow rate of air through an axial bush seal. The outer diameter of the inner cyl...

A:

Q: A new drier was tested by drying a wet material with 52.8% moisture (db). It was found that 561.85 k...

A: Given that, The moisture content in the wet material on dry basis MCdb = 0.528 The weight of dried m...

Q: Silicon tetrachloride (SİCI4 ) can be prepared by heating Si in chlorine gas: Si(s) + 2C12(g) -> SiC...

A:

Q: A plate of iron is exposed to a carburizing (carbon-rich) atmosphere on one side and a decarburizing...

A: Given, T=300oC The concentration of carbon at 0.003 m is 1.3 kg per meter cube. The concentration of...

Q: A saturated-liquid mixture of 70 mol% benzene and 30 mol% toluene, whose relative volatility is  2.5...

A: Hi and thanks for the question. Since you have posted a question with multiple subparts, we will ans...

Q: how to identify reagents needed to carry out reactions?

A: There are many Approach the identify reagents needed to carry out reactions are-  One of the Approac...

Q: Coal fired in a furnace analyzes 16.6% VCM, 16% ash, 61.4% FC, 6% M. 1.2%N and 1.8% S with a calorif...

A: Given the composition of coal and refuse, Let Refuse=R Kg Basis: 100 Kg of coal Applying Ash balance...

Q: Consider the following system at equilibrium where AH° = -198 kJ/mol, and K. = 34.5 , at 1150 K. 2 S...

A:

Q: Question 15 2 Points If a 136.51 g Al rod (c = 0.900 J/g°C) is at 100.0°C and placed into 250.0 g of...

A:

Q: For a diatomic gas (like oxygen), the value of Cv is 20.8 J/mol-K. What is the change in temperature...

A:

Q: Write the equilibrium constant expression, Kc, for the following reaction: Please enter the compound...

A:

Q: State 2 primary steps in diffusion process of phosphorus in p-type silicon wafer.

A: There are Many Primary Steps are Happening in diffusion process of phosphorus in p-type silicon wafe...

Q: 1-116E A water pipe is connected to a double-U manome- ter as shown in Fig. P1-116E at a location wh...

A: Given that :

Q: . Heat in the amount of 150 kJ is transferred directly from a hot reservoir at TH= 550 K to two cool...

A:

Q: wo kg of ammonia is isothermally compressed from an initial pressure of 2 bar to a final pressure of...

A:

Q: In a batch sedimentation test of calcium carbonate ,Predict the final height of settling zone D, If ...

A:

Q: You mixed 300kgs of Urea, 300 kgs of Ammophos, and 300 kgs of Complete. What is the total weights of...

A: To find the resulting fertilizer grade after mixing 300 kgs of Urea, 300kgs Ammophos, 300 kgs Comple...

Q: Calculate the total pressure and the composition of the vapours (mole %) in equilibrium at 60 °C wit...

A:

Q: 4. Adsorption isotherm (Freundlich isotherm) of powdered activated carbon (PAC) using for removing T...

A:

Q: Benzene CsHo is converted to cyclohexane C&H12 by direct reaction with t2. The fresh feed to the pro...

A: given: the fresh feed to the process contains 260 L/min benzene and 950 L/min hydrogen temperature=1...

Q: Calculate the normality of a solution containing 229 grams of CaCO3 in 2001 ml of solution? (Atomic ...

A:

Q: Ammonia is manufactured by the Haber Process. Calculate the atom economy for this process. N2 + 3H, ...

A: Haber process is also known as nitrogen fixation process. The pressure for this process is above hun...

Q: The pH of a 0.195 M solution of a weak acid, HB, is 2.52. What is Ka for the weak acid?

A:

Q: All of the following are true about a balanced equation EXCEPT A It is a useful method for describin...

A: Introduction The representation of a chemical reaction in the form of substances is known as a chemi...

Q: Water is heated from 25°C to 100°C. By how much does its chemical potential change? Answer= 5.2 kJ/m...

A: Given data T1= 250 C = (25 +273) K =298 K T2 =1000 C = (100 + 273 ) K = 373 K

Q: What is the mass in grams of potassium dichromate(K2Cr207) are required to prepare a 350 cm³ solutio...

A:

Q: You mixed 300kgs of Urea, 300 kgs of Ammophos, and 300 kgs of Complete. What is the resulting fertil...

A: To find the resulting fertilizer grade after mixing 300 kgs of Urea, 300kgs Ammophos, 300 kgs Comple...

Q: A) Choose the correct answer: 1) Pick the odd one in the following terms a) Isomorphous alloy b) Ter...

A: A.1 Pick the odd one in the following term a) isomorphous alloy :- The term isomorphous refers to me...

Q: Find the roots of the following set of linear equations using the Gauss elimination method ; x + 3y...

A:

Q: 184-7. Effect of Feed Temperature on Evaporating an NaOH Solution. A single-effect evaporator is con...

A: A single effect evaporator Feed rate=9072 kg/h Pressure of saturated steam=42kPa(gage) Pressure in v...

Q: Use the References to access important values if needed for this question. Vrite a balanced nuclear ...

A:

Q: A large tank initially contains 500 liters of brine in which 100 grams of salt is dissolved. Brine c...

A: Given data: Volume of brine = 500 L Initial amount of salt in brine = 100 g concentration of brine e...

Q: What is the product of this reaction? [H+] H20 none of these and но. он но осн HO. OCH3 H3CO.

A:

Q: Calculate the theoretical %Cl' if 12.5 g of NaCl is dissolved in 200-mL of distilled water. MM NaCI ...

A:

Q: State 2 primary steps in diffusion process of phosphorus in p-type silicon wafer.

A: Introduction Diffusion is the movement of impurity atoms in a semiconductor material at high tempera...

Q: 2) Determine the minimum mass of ethylene glycol (C2H6O2) that must be dissolved in 14500 g water to...

A:

Q: What is the composition of the mixture represented by point M after being mixed and allowed to settl...

A: It is required to determine the composition of the mixture represented by point M.

Q: The vapour pressure of the ketone carvone (M=150.2 g mol'), a component of oil of spearmint, is as f...

A:

Q: A solution of sucrose (molecular weight = 342) is prepared by dissolving 68.4 g of it in 1000 g of w...

A: A solution of sucrose+water Mass of sucrose ms=68.4g Mass of water mw=1000g M.W of sucrose MWs=342 ...

Q: The equilibrium constant, Ke, for the following reaction is 1.20×10-² at 500 K. PCI5(g) PC3(g) + Cl2...

A:

Q: strong acid HCN weak acid HNO3 strong base NH3 weak base HCI soluble salt HBr insoluble salt

A: Strong acid/Base: It completely dissociates or ionized in an aqueous solution   Weak acid/Base: Do n...

Q: Air at 100℉ flows, isothermally through a 4 inches -diameter pipe. Pressures at sections 1 and 2 ar...

A: Weight of fluid passes through a section of pipe in unit time is called weight flow rate of the flui...

Q: The stoichiometric combustion of a fuel in air produces many flue gases that depend on the fuel chem...

A:

Q: Boiling Points in a Triple-Effect Evaporator. A solution with a negligible boiling- point rise is be...

A: Given that, The temperature of saturated steam Ts = 121.1oC The pressure in the vapor of the last ef...