H.W: For the following Gravity Dam, Yw=10 KN/m³, Y.-24 KN/m³,q= 1400 KN/m² and μ= 0.7.a. Calculate the uplift force acting on the base of the dam.b. Check whether the section is safe against sliding.c. Check whether the section is safe against overturning.d. Determine the maximum vertical stress at the toe of the dam.e. Determine the maximum vertical stress at the heelDetermine the Principal stress at the toe of the dam.g. Determine the Principal stress at the heel of the damh. Determine the shear stress at the heel of the dam.i. Determine the shear stress at the Toe of the dam.зт6mT10m27m017520m

if solution is helpful please share valuable rating thank you

Answered: H.W: For the following Gravity Dam,…

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter16: Lateral Earth Pressure

Section: Chapter Questions

Problem 16.5P

See similar textbooks

Similar questions

A braced wall is shown in Figure 14.20. Given: H = 7 m, naH = 2.8 m, =30, =20, = 18 kN/m3, and c = 0. Determine the active thrust, Pa, on the wall using the general wedge theory. Figure 14.20
The cross section of a braced cut supporting a sheet pile installation in a clay soil is shown in Figure 14.22. Given: H = 12 m, clay = 17.9 kN/m3, = 0, c = 75 kN/m2, and the center-to-center spacing of struts in plan view, s = 3 m. a. Using Pecks empirical pressure diagrams, draw the earth-pressure envelope. b. Determine the strut loads at levels A, B, and C.
A concrete gravity dam with a trapezoidal section is holding water as shown in the figure. A distance of 15 meters from the toe, a drain is located. The drain has a pressure due to uplift of zero and increasing uniformly to full hydrostatic at the heel. Upstream face 1H:5V, while downstream face is inclined 1H:2V. Which of the ff nearly gives the maximum foundation pressure on the base of the dam in kilopascal ? Assume 23.54 kN/m3 for the unit weight of concrete. a. 3114 b. 1095 c. 4115 d. 964 e. 680
A concrete gravity dam has the following data: Maximum water level = 300.00 m Bed level = 220.00 m R.L top of dam = 304.00 m %3D The d/s slope of 0.67:1 starts at RL of 295.00 m U/s face is vertical. Center line of the drainage gallery = 8.0 m from u/s face. Consider only weight of dam, water pressure and uplift pressure. Calculate only the normal stresses at the toe and heel of the dam, assuming 100% uplift pressure at the h eel and 50% at the gallery and zero at the toe.
A retaining wall 8 m high supports a cohesionless soil having a dry density of 1600 kg/m^3, angle of shearing resistance is 33 degrees and void ratio of 0.68. The surface of the soil is horizontal and level with top of the wall. Neglect wall friction and use Rankine’s formula for active pressure of a cohesionless soil. Determine the value of earth thrust on the wall per meter length if the soil is dry. a. 121 kN b. 186 kN c. 148 kN d. 137 kN determine the value of earth thrust on the wall if water level is 3.5 m below the surface. a. 230 kN b. 250 kN c. 180 kN d. 210 kN find the height above the base of the wall where the thrust acts during the water logged condition. a. 3.50 m b. 2.67 m c. 1.75 m d. 2.25 m
Refer to Figure P6.3. Determine the vertical stress increase Δσ at point A with the values q1 = 90 kN/m, q2 = 325 kN/m, x1 = 4 m, x2 = 2.5 m, and z = 3 m.
A damn having a triangular section has a vertical face 24 m high and base 12 m wide. Use sg=2.4 a. determine the height of water that could rise on the vertical side of the dam so that the maximum intensity of pressure at the toe is twice the average pressure at the base. Neglect hydrostatic uplift. b. What is the shearing stress at the base?
A concrete dam is triangular in cross section and (30+0.314)m high from the horizontal base. If water reaches a depth of (27+0.314)m on the vertical face, what is the minimum length of the base of the dam such that the resultant will intersect the base within the middle third? What minimum coefficient of friction is required to prevent sliding ? Determine the pressure distribution along the base. If the uplift pressure varies from half full hydrostatic at the heel to zero at the toe.
45.) A retaining wall supports a horizontal backfill that is composed of two types of soil. First layer: 5.91 meters high, Unit weight of 17.26 kN/m3, coefficient of active pressure of 0.291 Second layer: 5.36 meters high, Unit weight of 18.85 kN/m3, coefficient of active pressure of 0.301 Determine the distance of the total active force measured from the bottom of the wall. Round off to three decimal places.
A retaining wall 6 m high supports cohesionless soil having a dry density of 1600 kg/m³, angle of resistance 32 and void ratio of 0.68. The surface of the soil is horizontal and level with the top of the wall. Neglecting wall friction and using Rankine’s formula for active pressure of a cohesionless soil. 1. Determine the nearest value of the total earth thrust on the wall in KN per lineal meter if the soil is dry. a. 73.1 b. 86.7 c. 62.4 d. 98.1 2. Find the nearest value of the thrust on the wall in KN per lineal meter if owing to inadequate drainage, it is waterlogged to a level of 3.5 m below the surface. a. 112 b. 171 c. 147 d. 153 3. Find at what height above the base of the wall the thrust acts during the waterlogged condition. a. 2.21 m b. 2.00 m c. 1.74 m d. 1.42 m
A concrete dam retaining water is shown. If the specific weight of the concrete is 23.54 kN/m3, find the maximum pressure on the base. Assume there is no hydrostatic uplift and that the coefficient of friction between dam and foundation soil is 0.48. Y = 5.6 m B = 3.2 m W = 1.6 h = 4.8
A vertical retaining wall 6 m. high retains a soil having the following properties. Unit weight of cohesionless soil = 19.2 kN/m3, angle of internal friction = 30°. The ground surface behind the wall is inclined at a slope of 3 horizontal and 1 vertical and the wall has moved sufficiently to developthe active condition.• Compute the Rankine’s coefficient of active earth pressure.• Compute the normal force acting on the back of the wall using Rankine’s theory.• Compute the vertical component of the force acting on the back of the wall using Rankine’s Theory.

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Principles of Geotechnical Engineering (MindTap C…

Civil Engineering

ISBN:

9781305970939

Author:

Braja M. Das, Khaled Sobhan

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781305081550

Author:

Braja M. Das

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Principles of Geotechnical Engineering (MindTap C…

Civil Engineering

ISBN:

9781305970939

Author:

Braja M. Das, Khaled Sobhan

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781305081550

Author:

Braja M. Das

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS