Heat transferred from the higher and lower temperature reservoirs are and , respectively. Select the coefficient of performance for a heat pump___________ A.0.67 B.0.5 C.1.5 D.2.0 QUESTION 15=Heat transferred from the higher and lower temperature reservoirs are Q=600kJ and Q₁-200k/, respectively. Select the coefficient of performanceHLCOPHPfor a heat pump_O A. 0.67B. 0.5O C. 1.5O D.2.0

Answered: Image /qna-images/answer/bdd5eb1a-3d6d-4ef2-bb34-ef6e344daa8c.jpg

Answered: Heat transferred from the higher and…

Heat transferred from the higher and lower temperature reservoirs are and , respectively. Select the coefficient of performance for a heat pump___________

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter8: Natural Convection

Section: Chapter Questions

Problem 8.46P

See similar textbooks

Similar questions

The operating condition for the single compressor in a household refrigerator is the lowest box temperature, which is typically A. 0F B. -20F C. 20F D. 40F
RESENDING QT - NEED ANSWERS TO REMAINING 3 QTS 1.4, 1.5, 1.6 1.1 Determine the electrical power supplied to a boiler when the temperature of the entering water is 20 C and the exiting temperature is 89 C. The flow of.the pressured water is 2 Kg/s. There is a negligible pressure drop through this boiler and it operates at a constant pressure of 3 bars. The specific heat is c = 4,370 J/(Kg K). There is a 1.5(105 ) W rate of heat loss from the boiler during this process to a surrounding at 293.2 k. Consider steady state conditions. 1.2 Calculate the total rate of entropy production in Problem 1.1. 1.3 Calculate the total rate of exergy destruction (W) in Problem 1.1. The dead state temperature is 293.2 K and pressure is 1 bar. 1.4 Calculate the mass flowrate of fuel (natural gas, CH4) required to heat the water flow to the conditions of problem 1.1 if the electrical heating device is replaced with a gas fired boiler. The high heating value (HHV) of the fuel is 50.02 MJ/kg 1.5 Calculate…
HVAC UPVOTE WILL BE GIVEN. ANSWERS ARE GIVEN ALREADY. PLEASE WRITE THE COMPLETE SOLUTIONS. 2. A room being air conditioned is held at 25°C db & 50% RH. A flow rate of 5m³/s of supply air at 15°C db & 80% RH is being delivered to the room to maintain steady condition at 100 kpa. What is the sensible heat absorbed from the room air in kw? 2. A room being air conditioned is held at 25°C db & 50% RH. A flow rate of 5m³/s of supply air at 15°C db & 80% RH is being delivered to the room to maintain steady condition at lookpa. What is the sensible heat absorbed from the room air in kw? a) 50.8 b) 60.8 c) 40.5 d) 70.9 c)40.5 d) 70.9
An ammonia compressor operates on an evaporator pressure of 291.57 kPa and a condenser pressure of 1557 kPa. A Heat Exchanger is installed thus superheating the refrigerant by 100C and a subcooling by 50 C. The system is used to cool water at 2 kg/s from 250 C to 150 C. Given: h1=1476 kJ/kg , h2=1752 kJ/kg . Determine the ff: a.) mass flow of reffrigerant. kg/s b.) compressor work. kw c.) mass flow of cooling water needed in the condenser for a temp. drop of 180F. kg/s
AC/ pump analysis System 2 tons operating steadily to maintain 60 F inside. Temperature outside: 30 F Assume 10 degree temp difference between the refrigerant R-134a and the two thermal reservoirs with which the refrigerant exchanges heat. COP = 9.0 Determine: compressor efficiency (%), condenser pressure (psia), evaporator pressure (psia), mass flow rate of R-134a (lb/sec)
A single-acting, single-cylinder air compressor is rated at 4.25 m3/min of air. The suction conditions are 1 atm and 27 C and discharge pressure is 1034 kPa. The compression process follows the equation PV1.35 = A. Determine the power, in kW, required to compress the air. B.)what is the engine kW power needed to drive the unit if the combined engine-compressor efficiency is 84%? C.)if the compressor is to run two-stage at optimum intercooler pressure with perfect intercooling, what will be percentage of power saved?
Subject : Thermofluid A well-sealed house left alone during the midday heat was found to be at 35oC. He turns on the air conditioner, which cools the entire house to 24oC in 30 min. If the COP of the air-conditioning system is 2.6, determine the power drawn by the air conditioner. An estimated of 750 kg of air is within the house for which cv = 0.72 kJ/kg·oC and cp = 1.0 kJ/kg·oC.
1.1 Determine the electrical power supplied to a boiler when the temperature of the enteringwater is 20 C and the exiting temperature is 89 C. The flow of.the pressured water is 2 Kg/s. There is anegligible pressure drop through this boiler and it operates at a constant pressure of 3 bars. The specificheat is c = 4,370 J/(Kg K). There is a 1.5(105) W rate of heat loss from the boiler during this process to asurrounding at 293.2 k. Consider steady state conditions.1.2 Calculate the total rate of entropy production in Problem 1.1.1.3 Calculate the total rate of exergy destruction (W) in Problem 1.1. The dead statetemperature is 293.2 K and pressure is 1 bar.1.4 Calculate the mass flowrate of fuel (natural gas, CH4) required to heat the water flow to theconditions of problem 1.1 if the electrical heating device is replaced with a gas fired boiler. The highheating value (HHV) of the fuel is 50.02 MJ/kg.1.5 Calculate the exergy destroyed in the process described by problem 1.4. The exergy…
1.1 Determine the electrical power supplied to a boiler when the temperature of the enteringwater is 20 C and the exiting temperature is 89 C. The flow of.the pressured water is 2 Kg/s. There is anegligible pressure drop through this boiler and it operates at a constant pressure of 3 bars. The specificheat is c = 4,370 J/(Kg K). There is a 1.5(105) W rate of heat loss from the boiler during this process to asurrounding at 293.2 k. Consider steady state conditions.1.2 Calculate the total rate of entropy production in Problem 1.1.1.3 Calculate the total rate of exergy destruction (W) in Problem 1.1. The dead statetemperature is 293.2 K and pressure is 1 bar.1.4 Calculate the mass flowrate of fuel (natural gas, CH4) required to heat the water flow to theconditions of problem 1.1 if the electrical heating device is replaced with a gas fired boiler. The highheating value (HHV) of the fuel is 50.02 MJ/kg.1.5 Calculate the exergy destroyed in the process described by problem 1.4. The exergy…
A Carnot engine using air receives heat at 300°C and rejects heat at 60°C. The pressure and volume at the start of the heat addition process are 5 MPaa and 0.9 L respectively, at the end of the process the pressure drops by 45%. Determine: • Work net • Heat added • Heat rejected • Thermal Efficiency
Define the second-law efficiency.
In a refrigeration cycle, the refrigerant gains heat in the evaporator and in thesuction line. In a certain refrigeration system, R-134a gains 67.8 Britishthermal units per pound (Btu/lb) in the evaporator. It then gains 2.5 Btu/lb inthe suction line. Find in Btu/lb the total heat gained by the R-134a.