H|HO Circuit #2 1. Set the battery voltage to 12 V, and the value of one resistor to 10 ohms (R₁) and another to 20 ohms (R₂). What is the sum of two resistances? Is the current flow the same value through both resistors? What is the value? Must this same current flow through the entire circuit? Why is this so? Using the value for current flow and Ohm's law, calculate the equivalent resistance, REQ of the circuit. How does this value compare with the sum of the two resistors?

H|HO Circuit #2 1. Set the battery voltage to 12 V, and the value of one resistor to 10 ohms (R₁) and another to 20 ohms (R₂). What is the sum of two resistances? Is the current flow the same value through both resistors? What is the value? Must this same current flow through the entire circuit? Why is this so? Using the value for current flow and Ohm's law, calculate the equivalent resistance, REQ of the circuit. How does this value compare with the sum of the two resistors?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter19: Special-purpose Outlets-water Pump, Water Heater

Section19.2: Water Heater Branch Circuit

Problem 14R

See similar textbooks

Similar questions

answer the question brielfy 1.) What are the types of Cells and its definition.2.) Draw/ Illustrate the grouping of cells in series, parallel and combination of series-parallel.3.) What are the types of Batteries and its definition.4.) What are the parts of a battery5.) What is ampere-hour and ampere-hour efficiency?6.) What is watt-hour and watt-hour efficiency?
4S LiPo • 5100 mAh • charge rate 1-3C • discharge rate: 35C Complete the following questions as given. Show all computation work and your final answer. Remember to include proper units with your answer. Q1. What is the nominal voltage of this pack? Q2. What is the expected fully charged voltage of this pack? Q3. What is its capacity in Watt-hours? Q4. What is the maximum safe discharge rate for this pack? Q5. What is the maximum charge rate setting on a charger? Q6. What is the maximum recharge time, a) @ 1C? b) @ 2C? Q7. For a battery with a measured charge at 40%, a) how much mAh has been discharged? b) how long will it take to recharge to 100% at 2C? Q8. How long will a fully charged pack run a motor, a) @ 100A? b) @ 200A?
Given: Vbatt is 14.5V to avoid overcharging the battery. Vbatt falls to 11.4V due to discharge at night. Question: If VA = 11.2V and the minimum current needed for Va is 0.2mA, what should be the maximum resistance value for RA? (in Ohms)?
3.Question (a) Look up the definition of unit for clothing insulation, called “clo” value. Convert 1.5 clo to a value with an unit in international standard. (b) In the winter, people wear more cloth to keep themselves warm. You have the option of wearing 2 jackets that are 0.3 cm thick or 1 jacket that is 0.6 cm. Assume they are made of the same material and neglect any effect from cloth openings. Which option should you choose to keep you warm? Draw a thermal circuit to help with your discussion.
Based on the given picture below, answer the following questions. a. What is the maximum voltage where you should connect its socket? b. How much voltage is produced by this charger in a laptop battery? c. How much resistance is offered by the charger itself? d. What is the power of the charger in kW? e. If you will use the charger for 3 hours, how much energy is consumed in Joules?
Please answer this and show the correct answer and solution: A copper bar has a length of 20 ft. width of 4 inches and thickness of 0.5 inch. If the resistivity of copper is 10.37 Ω-cm/ft, what is the resistance of the bar? Group of answer choices: a. 0.0816m Ohms b. 0.0820m Ohms c. 0.0814m Ohms d. 0.0815m Ohms
According to Ohm's law, it gives the ratio of voltage to current in a......... closed circuit.What should come in the blank?Please choose one: a: Earnings b. Strength c. Loss d Resistance E. Capacities
- What is the output voltage vo in volts? - What is the voltage v2 across R2 in volts? - What is the current i3 through R3 in amperes? - What is the power dissipated by R4 in mW (milliwatt)?
Give the color bands of the following resistors with 10% tolerance: 1. 1k Ohms2. 220 Ohms3. 1.5 MOhms4. 100 Ohms5. 500 KOhms
In your own analysis what will happen to the capacity charge of the battery if it is connected in more load? Explain
Given:Vb = 100 voltsR = 10000 ohmsC = 200 μFAssuming that after a long period of time, the switch is flipped from position "A" to position "B" at t=0. Calculate the voltage across the resistor after 3 TC.
Determine the current I in the 5-ohm resistor. please show complete and detailed solution. thank you!