Host A sends a packet of size L bits to Host B. (a) Express dprop and drans in terms of the given parameters. (b) Suppose host A begins to transmit the packet at time t = 0. At time t = drans, wh is the last bit of the packet? (c) Suppose dprop > dtrans. At timet = drans, where is the first bit of the packet? (d) Suppose dprop < dtrans- At time t = dırans, where is the first bit of the packet? 108 100

Q: C Fill in the following blanks with appropriate answers (Choose Five Only) 1. A data communication…

A: Following are the solutions to the given problems along with explanation.

Q: (-100)10 - (+120)10 = (?)2 numbers are 8 bits, and subtraction is done by using the methods of…

A:

Q: Non Return to Zero encoding is the most bandwidth efficient. Select one: O True O False Check A…

A: Answer :- Yes  Explanation :- Non return to zero (NRZ) is most efficient bandwidth than RZ…

Q: A path in a digital switched network has a data rate of I Mbps. The exchange of 1,000 bits is…

A:

Q: In a 3-to-8 line decoder, the output corresponding to minterm D6 is described by the expression. *…

A: Truth table for a 3-8 line decoder is shown below :-Inputs…

Q: Assume a digital communication system with the following specifications: Pbe=0.05, (n,k) block…

A: It is defined as a element of a standardized Code or Protocol. Each code word is assembled in…

Q: c. Construct the truth table and then determine the Minterms and Maxterms for a given system after…

A:

Q: Show that the original voice signal m(t) may be recovered from y(t) by using an unscrambler that is…

A: The given system is shown below

Q: 9. For the following M-ary message, a) What is the value of M? b) Represent the data by binary…

A: Binary values are usually represented by two digits, the digits are 1,0. Where M-ary message M…

Q: 4) By using MUX and DEMUX, how many data transmission lines are required to improve the efficiency…

A:

Q: Given that the Hamming (7,4) code has 1 word at a distance 7, 7 words at a distance 3 and 7 words at…

A: The Hamming codes were originally designed with dmin=3 which means that they can detect up to two…

Q: Z1 A16 A Yo O + ROMCS* RAMCS Y,O Y2 O A17 + RESM* 22 Y3 23 24 A Yo O YO PIACS Y2 O Y3 O A6 RESP* A7…

A: the access time of the devices on the asynchronous bus must be atmost,

Q: Question 4 ( A voice-grade telephone line with bandwidth of 4 kHz (0- 4kHz) is to be used in…

A: Given,Bandwidth is,BW=4kHzFrequency deviation is,∆f=100 Hzandd=0

Q: Assume a digital communication system with the following specifications: the channel Pe=0.05, and…

A: Solution : Given ; Bit error probablility Pbe=0.05 Block code can connect maximum upto 3 bitsso,…

Q: Problem 6. A certain binary PCM system transmits the two binary states X = +1, and X = -1 with equal…

A: Given: A certain binary PCM system transmits the two binary states X=+1 and X=-1 with equal…

Q: Q1. Consider a (7,4) linear block code defined by the parity check matrix as [1 1 1 0 1 1 H = 0 1 1…

A:

Q: Design a 3x8 decoder by using 1x2 DEMUXes.

A: According to the question we have to design a 3x8 decoder by using 1x2 DEMUXes.

Q: Binary data is to be sent at the rate R, = 100 K bits/s over a channel with 40dB transmission loss…

A:

Q: For M equally likely messages, M>>1, if the rate of information R s C, the probability of error is…

A:

Q: Assume that there are N stations. Stations transmit without sensing the channel. Under what…

A: the transmission techniques used for transmission of data from multiple station is called multiple…

Q: In your own words, explain the importance of line coder in digital communication. In…

A: Line coding  Line coding also known as digital baseband modulation or digital baseband transmission…

Q: With a 1-MHz carrier, if the LSB extends down to 990 kHz, then the USB will extend up to.

A: Given with a 1 MHz carrier , if the LSB extends down to 990 KHz , then we have to determine the the…

Q: 6.40 The V.32 modem standard with nonredundant coding uses a rectangular 16-QAM con- stellation. The…

A: Rectangular 16-QAM constellationfc=1800HzSymbol rate=2400 baudsAverage…

Q: Calculate the checksum for the following data block. Show your work. 10100101 01010110 11001111…

A: Given: 4 Data blocks of 8 bits Using  1’s complement checksum scheme, we have to find the checksum…

Q: Exercise (4): Consider One file of K>>1 bits must be sent from A to C. The file is decomposed into…

A: Solution : 1) Given :K=500 BytesK=500×8 BitsK=4000 Bits  Bit requirement for each packet :Bit…

Q: A communication system using a special version of phase modulation which is 8 PSK have a symbol rate…

A: Given data,

Q: A network operator has asked you to design a point-to-point optical link for short reach (2 km)…

A: GIVEN data:

Q: *6. Consider a message source that generates one of five messages randomly every 0.01 millisecond.…

A:

Q: mov a,___ ;-1- mov r0,___ ;-2-…

A: Given Assembly language code is                                mov a,___          ;-1-…

Q: Problem 4 Consider a communication system that transmits data packets of 16 bits. Each bit can be in…

A:

Q: For a 8051 system of 11.0592 MHz, Find how long it takes to execute following instructions : DEC R3,…

A: We have an 8051 system with 11.0592 MHz crystal frequency. Crystal Frequency = 11.0592 MHz = 11.0592…

Q: H.W. For the circuit shown below: Find the port address , type of decoding & interfacing technique…

A: Given

Q: Sequence detection for the sequence ( 11001)

A:

Q: A communication system using a special version of phase modulation which is 32 PSK has a bit rate of…

A:

Q: A binary communication system has the logic "I" represented by 5V while the logic "0" represented by…

A: A binary communication system has the logic "1" represented by 5 V while the logic "0" is…

Q: QUESTİON 1 : a) How many bits are required to numerically represent temperatures between 0 °C and…

A:

Q: b) Consider the below figure in which three hosts, with private IP addresses 10.0.1.12, 10.0.1.15,…

A: The given figure is shown below:

Q: Serial transmission have one wire and sends one bit at a time True False

A: Serial Transmission :- In this method data is sent or received using a single wire or single…

Q: Assume a digital communication system with the following specifications: P 0.05, (n, k) block coding…

A: It is defined as a element of a standardized Code or Protocol. Each code word is assembled in…

Q: Homework: Determine the Y-parameters from the Z-parameters?

A:

Q: You have a 100 Mbit / s Ethernet that uses full duplex. How big are the smallest packages used?…

A:

Q: Q3) For the following 8-bit Transmitter-Receiver system; write a VHDL code to check received vector…

A: Q3 VHDL Transmitter code: library ieee;use ieee.std_logic_1164.all;entity UART_Transmitter…

Q: odulating signal f(t) has a maximum uency of 18 kHz and peak e of 3volt, this signal is encoded usir…

A:

Q: 05] Assume a digital communication system with the following specifications: Pbe=0.05, (n,k) block…

A: to find     The average number of errors in every transmitted codeword.             (b) The number…

Q: Consider a binary symmetric communication channel, whose input source is the alphabet X = {0,1} with…

A:

Q: In an asenkron transmission a character size is 6 bits. When 1700 characters are transmitted, if…

A:

Q: A CRC implementation uses a generating polynomial of the form G(x) = x² + 1. The message polynomial…

A: First 2 zeros are padded to the message signal before dividing. Modulo 2 addition is followed in in…

Q: network operator has asked you to design a point-to-point optical link for short reach (2 km)…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.