How DAB = D₂ Using volume r-radius N-Avogadro's constant, 6.0221x 10²3 T-temperature μ-viscosity DAB D₂ 9.96 x 10-16T μV³ 7.73 x 10-¹6T ur 4 V=Nr³

Q: In April 2010, the worst oil spill ever recorded occurred when an explosion and fire on the…

A:

Q: leaving the distillation column are at different temperatures. a) Determine the number of degrees of…

A: 1) feed mixer contains pure nbutane at temperature T which is only unknown so it's degrees of…

Q: in the production of ethanol by the hydrolysis of ethylene, diethyl ether is produced as a…

A:

Q: How many kilograms of ice at 0°C must be added to 0.6 kg of water at 100°C in an insulated 0.1-kg…

A: Mass of water, Mw = 0.6 kgtemperature of ice, Tice = 0 oCtemperature of water, Twater= 100 oCMass of…

Q: A liquid has a molar volume of 0.2 L/mol at 400 K and 4 bar. This liquid is compressed with a pump…

A: A. Work done by the pumpThe work done by the pump is given by the following formula:wheren is the…

Q: The deepest point in the oceans of the world is believed to be in the Marianas Trench, southeast of…

A: Given-The pressure is substantially higher at the ocean's depths than it is at the water's surface.…

Q: Find the volume of the plug flow reactor needed for 95% conversion of reactant A CAO Aqueous Feed…

A:

Q: The mole fraction of oxygen molecules in dry air is 0.186. What volume of dry air at 2.88 atm and…

A: Mole fraction of oxygen in the dry air = 0.186Temperature of dry air = 22.1 0CPressure of dry air =…

Q: Calculate the gauge pressure in mm Hg at the bottom of the container. i mm Hg

A:

Q: Estimate the thermal conductivity of benzene at 30C.

A: Temperature= 300CDensity of benzene at 300C ,d= 875 kg/m3Molar mass of benzene, M = 78specific heat…

Q: (vi) What will be the ratio of volume of mixed reactor to the volume of P.F.R. (for identical flow…

A: Note: Since you have posted multiple questions, we will provide the solution only to the first…

Q: (i) (ii) Measurement 1 2 3 4 5 6 Time (min) 10 20 30 40 50 60 Concentration (mol/L) 2.45 1.74 1.23…

A:

Q: Fifty moles per second of gas mixture analyzing 0.80 methane, 0.15 ethane, and 0.05 propane enters a…

A: A mixture of hydrocarbon gases is fed to a burner. The exhust gases from the burner are fed to a…

Q: Estimate the thermal conductivity of ethane at 1 bar and 450C

A: To find the approx values for the thermal conductivity of pure gases, up to moderate pressures we…

Q: After closing the chambers on analytical balance and pusing the tare button once, the students got…

A: The real value is 0 g +/- the smallest detectable mass of the analytical balance. The smallest…

Q: 9) A piston-cylinder contains 1 kg water at 20 °C with an absolute pressure of 101.3 kPa. The piston…

A: The problem provides information about a piston-cylinder system containing 1 kg of water at 20℃ with…

Q: 2. Sand was collected and processed using a sieve. The following results were recorded. The bulk…

A: Sieve is used for processing sand particles.Sand particles are assumed to be spherical.Bulk density…

Q: A closed 2 m3 chamber is half-filled with water containing sulphur dioxide anhydride (H₂S). Water…

A:

Q: Chemical Engineering Question

A: Colours of the object.

Q: Feed stream CAO? gmole L-¹ YAO = 0.5 Vo = 6L*s-1 nowns: CAO H V = V = ? L XA = T = 422.2 K P = 10…

A: First of all, you are heading in the right direction. The only thing you have to use is the value of…

Q: 3. The Vapair pressure of amorints 0.982 bar It 633.15 K. Molar mass à What fue heat consen b)…

A: The vapor pressure of mercury is given at two different temperatures as,At temperature, T1 = 628.15…

Q: Q.1 The dynamic behavior of a pressure sensor/transmitter can be expressed as a first-order…

A: (i) The transfer function for a first-order process can be derived from its differential equation.…

Q: given the following reaction with a feed rate of 10 kg/s of C2H6. C2H6 (g) --> C2H2 (g) + 2H2  If…

A: The feed rate of ethane , .The conversion of the reaction is 75%.The inlet temperature of water, The…

Q: What is 3 atm expressed as a head of mercury? 30986 mm Hg O 2280 mm Hg O219264 mm Hg O2.28 mm Hg

A: Pressure (P = 3 atm) is given in terms of atmospheric unit and it is to be converted into head of…

Q: accepted testable. Why is it important for scientific theories (claims and knowledge) to be testable…

A: Here are the answers to your questions:6 )Question Answer:Scientific theories are testable because…

Q: A gas-phase reaction is carried out in an unequally sized MFR followed by PFR. The reaction is 3A +…

A: To solve this problem, we need to set up and solve the material balance equations for both the MFR…

Q: a. Determine the distillate and bottoms flow rates (in moles). b. Determine the number of…

A:

Q: (c) 9 (d) 27 The feed to a binary distillation column has 40 mol% vapour and 60 mol% liquid. Then,…

A: GivenFraction of liquid = 60%                         = 0.60Fraction of vapor = 40%

Q: Consider a continuous stirred-tank reactor (CSTR) used for a first-order exothermic reaction. The…

A: A Continuous Stirred-Tank Reactor (CSTR) is commonly used in chemical engineering for carrying out…

Q: A reaction is to be carried out isothermally in a continuous flow reactor. The entering volumetric…

A:

Q: 3 A vessel of volume 1000 m³ contains air which is saturated with water vapour. The total pressure…

A: given data = Volume of vessel V = 1000 m3Total pressure P = 1000 kPaVapor pressure of water at 20oC(…

Q: The partial differential for the Gibbs energy of a substance can be written as: dGm = -SmdT + VmdP.…

A: Given equation for free energy :dGm=−SmdT+VmdPFrom plot of Gm against P, Vm(g), Vm(l) and Vm(s) are…

Q: Estimate the requirements of steam and heat transfer surface, and the evaporating temperatures in…

A: Mass balance (kg h-1)SolidsLiquidsTotalFeed(10% of total)50…

Q: Problem 1 Length Required for Cooling Coil A cooling coil made of copper tube is immersed in a…

A:

Q: Problem 1 Estimate the time required to evaporate 5% of a solid naphthalene sphere (moth ball)…

A:

Q: can you do part B

A: From the solution of a) and b) we get to know…

Q: A plate, which is moving with velocity 10 cm/s, is placed 0.5 cm apart from a fixed plate. What will…

A:

Q: An enclosure consists of two black surfaces formed by cutting off a 0.3 m diameter spherical shell…

A:

Q: 2. A partitioned tank as shown contains water and mercury (SG: 13.6). A=0.8m, B = 2.4m. The gauge…

A:

Q: NASA has designed a standard rocket engine to use on their new Mars lunar rover. The engine burns…

A:

Q: Consider the irreversible reaction below, which is shown to obey second-order kinetics. If the rate…

A: The reaction equation is:The rate law for a second-order reaction is:where r is the reaction rate.k…

Q: mole fraction). Calculate how much liquid should be provided at the top of the plate such that…

A:

Q: A liquid mixture containing 50 mole % each of benzene and toluene at 40 degrees Celsius is to be…

A: Flash vaporization is a process in which a liquid mixture is rapidly vaporized by decreasing its…

Q: Estimate the specific enthalpy of ethyl alcohol at 1 bar and 200°C, taking the datum temperature as…

A: As no data are given on the exact variation of the Cp of the liquid with temperature, use an…

Q: Acetone is to be recovered from an aqueous waste stream by continuous try distillation column. If…

A:

Q: 9. Calculate 15 2 Celculatie given, fro As sourrounding 49 0°c -20°C (50g) → 333 кј ку Latent heat…

A: The mass of the ice, Initial temperature of the ice, The final/surrounding temperature of water,

Q: A 70 W outdoor security light is illuminate, on average, 10 hours a day. A new bulb costs $5.00, and…

A: The power of the outdoor security light, The average time for which it is illuminated per day, The…

Q: Hw: 1 What is the half-life of a substance that decays to 25% of its original amount in 2. A given…

A: Q1) 25% of the substance is decays in 6 days.Q2)

Q: What are the vapor and liquid flowrates around the condenser and reboiler

A: To calculate the vapor and liquid flow rates around the condenser and reboiler in a distillation…

Q: A 'long' steel shaft of 10 cm diameter is austenised at 870°C and then quenched in a liquid at 30°C.…

A: