Answered: How do the auto-transformer on no-load…

How do the auto-transformer on no-load and the unioaded voltage divider behave in relationship to each other ? Question 3:

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.15P: Rework Problem 3.14 if the transformer is delivering rated load at rated secondary voltage and at...

See similar textbooks

Related questions

Q: a R C The switch in the circuit above has been in position a for a long time. The variables in the…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: The length of one cycle of an electromagnetic wave in space is referred to as its wavelength. The…

Q: An NMOS has a substrate impurity doping concentration of Na =2 x 1016 cm3, a threshold voltage of…

A: NMOS(N-type metal-oxide-semiconductor logic): n-type MOSFETs (metal-oxide-semiconductor field-effect…

Q: 1. Sketch the output waveform of the given circuit in Figure 1. The peak voltage is 20V with 50HZ…

A: Given: V=20V

Q: Tind Vo FIND The therenin 8 Norton Equivalant + 2 ΚΩ 2000 Vx X + 6 kN Vo 4 ΚΩ +) 3 V 2 mA B

Q: An open delta three phase transformer system has one transformer center tapped to provide a neutral…

A: It is given that: voltage from line to center tap=277 V

Q: -than AC to DC Drives e) higher 6. The efficiency of DC to DC converter to drive de motor is- a)…

A: As per guidelines given to us , we can only provide the solution to one question in multiple type of…

Q: 4. Find the period, frequenay, and the amplitude of the current wave form shown below. 2 +t, ms 10…

A: We need to find out amplitude , frequency ,time period.

Q: 1. A controlling torque , in gravity controlled instruments. is attached to the moving system in…

Q: Determine the current flowing through resistor R2. (assume Zener voltage is 3 volts) * R2 1K R1 10V…

A: The solution is given below

Q: find the inductance at A and the resistance

Q: 300 V200 290 15 0 b 25 0 12 V후 18 Vệ 15 V 30 n 20 Ω 10 0 30 0 50 0 50 13 휴 14 V 80 8 V 15 0 ww

Q: Find V(t), t>0 12 N + v(t) 4 H 10 | 4Ω 24 V 6 Ω t = 0 %3D +1

Q: -- than AC to DC Drives e) higher 6. The efficiency of DC to DC converter to drive de motor is a)…

A: 6. The efficiency of DC to DC converter to drive DC motor is higher than AC to DC drives. Option…

Q: sing masan's formula Gro 412 Ga, RIS) O G13

Q: Determine the voltage across the resistor R1. (assume LED forward voltage is 2.1 volts and Diode…

A: In this question, We need to determine the voltage across the resistor R1. If LED forward…

Q: Consider the control circuits shown in Figure R1 R1 C2 R2 i, R2 i, iz V, Virtual Ground Virtual…

A: The solution is given below

Q: R C= The switch in the circuit above has been in position a for a long time. The variables in the…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: 1. Calculate D in rectangular coordinates at point PA(2, –3, 6)produced by a uniform line charge =…

Q: coil is connected to a 230 volt source. If the voltage across the inductor is 125v, and the power…

A: We need to find Current and power factor for given circuit .

Q: 3. The output frequency of a full wave rectifier is 50 Hz, what is its input frequency

A: We need to find input frequency for given output frequency

Q: What is the total inductive reactance of a 4 mH coil connected to a 1000 Hz source? 6. Your Answer:…

A: The solution is given below

Q: Give me a ece example project with 5 active component

A: Active components are components of electrical circuits, they depend on the electrical power for…

Q: Complete the table velues. 1.5k RED AGreen Taaneler Meating Si A 1.sks ww I, VI Ve V, V4

Q: Given the signal y(t) as below, y(t) If y(t)=-0.5x(-3t+2) i) Find and draw the odd component of y(t)…

Q: A 50 Hz, 4-pole, Y-connected synchronous generator is supplying a load with Vt = 220-V /phase at…

Q: A sinusoidal source is v(t)=2 sin 500t. Determine the Vmax. Determine the frequency. Determine the…

Q: Two vectors A = 4ax + 3ay and B = ax + 2ay + 2az , find (c) O AR between A and B O 56.3 degrees 48.2…

A: We need to find angle between given vectors .

Q: R5=1k Yb R7=1k R9=1k +YR5- R6 R8 V1 5V V2 10V 3.3k 3.3k Figure 5.2

A: The solution is given below

Q: How do modern wireless communication systems help deploy Smart Grid?

A: The smart grid is indeed a digitalized, intelligent energy network system that delivers electricity…

Q: C1 Vin 0.1pF 14 Vrms }60 Hz 0° SR1 D1 1N4001 1MQ Vout (+ 2

Q: 120 V 60 Hz 68 µF 2.2 k2 (b) FIGURE 4-40

A: Brief description : Full wave rectifier circuit is used to convert complete alternating voltage or…

Q: 15 D1 R1 5V 1K D2 KH Determine the current flowing through the LED. (assuming its forward voltage is…

A: The given circuit is:

Q: 2. In the fig. below, how large must R if the potential drop from A to B is 12 V. The current is 3.0…

A: 2.

Q: in +20V V in 500 2 out -20V Figure 1. Circuit for Question 1 and 2. 2. Sketch the output waveform if…

Q: Determine the current flowing through the LED. (assuming its forward voltage is 2.1 volts and diode…

Q: R= 180 2 120 V 30 mH 1000 Hz coil Solve for VR1 Copy paste these in as needed 2° (No phase angle…

A: The solution is given below

Q: 15. Find the Thévenin equivalent circuit for the network external to the resistor R for the network…

Q: 23 Determine the voltage across the resistor R1 if the Zener Voltage is 4.7 V * 6 R2 1K R1 5V D2 1K

Q: Near room temperature, the thermo- e.m.f of thermocouple is 30 µV/°C. What is the smallest…

Q: It's a low-frequency oscillator circuit that's relatively stable and easy to tune, and it's often…

A: The solution is given below

Q: P7.1 Research and identify the type of sensors used in the following applications. a. Kitchen oven…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q.32: The two-wattmeter method gives P1=1200W and P2=-400W for 3-Ph motor running on 240V line.…

A: The solution is given below

Q: 78A O 1182/8.1A

A: Solve the problem

Q: 4.22 A 50 KVA; 600/240-volt; 25 cycle transformer has a core loss of 200 watts of which 30% is eddy…

A: Given data, Rating of transformer 50 KVA, 600/240 V Core loss = 200 W. Full load copper loss = 650…

Q: When designing the MOSFET, the minimum feature size is the smallest dimension possible to…

A: Answer: True

Q: Discuss in detail about the PI and PID controller and derive an expression for the transfer function…

A: Proportional Integral (PI) Controller The output of the proportional-integral controller is the sum…

Q: A Si diode has a leakage current IS = 71 nA at room temperature (25°). The leakage current if the…

Q: 3 The maximum efficiency of a transforner occurs when theconstant core loss equals the variable…

Q: 4. Find the mesh current I, I, ans Iz in the circuit shown. 10 40 25 ww so Lo v 70 Lgyl 15 ww

A: The solution is given below

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider the oneline diagram shown in Figure 3.40. The three-phase transformer bank is made up of three identical single-phase transformers, each specified by X1=0.24 (on the low-voltage side), negligible resistance and magnetizing current, and turns ratio =N2/N1=10. The transformer bank is delivering 100 MW at 0.8 p.f. lagging to a substation bus whose voltage is 230 kV. (a) Determine the primary current magnitude, primary voltage (line-to-line) magnitude, and the three-phase complex power supplied by the generator. Choose the line-to-neutral voltage at the bus, Va as the reference Account for the phase shift, and assume positive-sequence operation. (b) Find the phase shift between the primary and secondary voltages.
In developing per-unit circuits of systems such as the one shown in Figure 3.10. when moving across a transformer, the voltage base is changed in proportion to the transformer voltage ratings. (a) True (b) False
The ratings of a three-phase, three-winding transformer are Primary: Y connected, 66kV,15MVA Secondary: Y connected, 13.2kV,10MVA Tertiary: connected, 2.3kV,5MVA Neglecting resistances and exciting current, the leakage reactances are: XPS=0.09 per unit on a 15-MVA,66-kV base XPT=0.08 per unit on a 15-MVA,66-kV base XST=0.05 per unit on a 10-MVA,13.2-kV base Determine the per-unit reactances of the per-phase equivalent circuit using a base of 15 MVA and 66 kV for the primary.
The ideal transformer windings are eliminated from the per-unit equivalent circuit of a transformer. (a) True (b) False
Consider Figure 3.4. For an ideal phase-shifting transformer, the imda nce is unchanged when it is referred from one side to the other. (a) True (b) False
A single-phase l0-kVA,2300/230-volt,60-Hz two-winding distribution transformer is connected as an autotransformer to step up the voltage from 2300 to 2530 volts (a) Draw a schematic diagram of this arrangement, showing all voltages and currents when delivering full load at rated voltage. (b) Find the permissible kVA rating of the autotransformer if the winding currents and voltages are not to exceed the rated values as a two-winding transformer. How much of this kVA rating is transformed by magnetic induction? (C) The following data are obtained from tests carried out on the transformer when it is connected as a two-winding transformer: Open-circuit test with the low-voltage terminals excited: Applied voltage =230V, input current =0.45A, input power =70W. Short-circuit test with the high-voltage terminals excited: Applied voltage =120, input current =4.5A, input power =240W. Based on the data, compute the efficiency of the autotransformer corresponding to full load, rated voltage, and 0.8 power factor lagging. Comment on why the efficiency is higher as an autotransformer than as a two-winding transformer.
Reconsider Problem 3.64 with the change that now Tb includes both a transformer of the same turns ratio as Ta and a regulating transformer with a 4 phase shift. On the base of Ta, the impedance of the two comp onents of Tb is jO.1 per unit. Determine the complex power in per unit transmitted to the load through each transformer. Comment on how the transformers share the real and reactive pors.
For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
Why is it important to reduce the moisture within a transformer to acceptable levels during transformer installation?
Rework Problem 3.14 if the transformer is delivering rated load at rated secondary voltage and at (a) unity power factor, (b) 0.8 power factor leading. Compare the results with those of Problem 3.14. -
The leakage reactance of a three-phase, 300-MVA,230Y/23-kV transformer is 0.06 per unit based on its own ratings. The Y winding has a solidly grounded neutral. Draw the per-unit equivalent circuit. Neglect the exciting admittance and assume the American Standard phase shift.
The per-unit equivalent circuit of two transformers Ta and Tb connected in parallel, with the same nominal voltage ratio and the same reactan of 0.1 per unit on the same base, is shown in Figure 3.43. Transformer Tb has a voltage-magnitude step-up toward the load of 1.05 times that of Ta (that is, the tap on the secondary winding of Tb is set to 1.05). The load is represented by 0.8+j0.6 per unit at a voltage V2=1.0/0 per unit. Determine the complex power in per unit transmitted to the load through each transformer, comment on how the transformers share the real and reactive powers.