Answered: How to calculate to continues power of…

Engineering

Electrical Engineering

How to calculate to continues power of 500KVA generator at 60hz, 440v, pf

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.9P: For the circuit shown in Figure 2.24, compute the voltage across the load terminals.

See similar textbooks

Related questions

Q: 10.a. The type of stepper motor that has a pair of center-tapped windings is the A. closed-loop…

A: Motor: An electric motor is a device that converts electrical energy into mechanical power. In most…

Q: 5. What is the full-load current of a 230-volt, 3-phase, 125-horsepower synchronous motor when it is…

A: We need to find out the current for given circuit.

Q: 4. What are the minimum allowable ampacities of the phase conductors and the neutral conductor that…

A: Solution- It is a maximum current , if a conductor can bear continuously current without increasing…

Q: 0.1 vo 40 92 ww + is 20 Ω 50 µF 100 mH If is= 10cost(30t+20°) A, what is the value of vo(t)? USE…

Q: Find the currents i₁, 12, and i3 by using Mesh analysis 10 V 492 www 12 V 1₂2 652 13 1292

A: To find the currents i1, i2 and i3 using mesh analysis

Q: given the transfer function C(s) 36 T 2 R (s) 5² +4.25 +36 Find the following a damping ratio and…

A: Given closed-loop transfer function is CsRs=36s2+4.2s+36. We need to determine the damping, ratio,…

Q: rbs all the energy delivere- ime interval during which

A: Given as, Power, P= 120 V, Current, I= 2 A.

Q: Given the information appearing in Fig. 4.119, determin a. Ic. b. Rc. c. RB- 12 V d. VCE- RB IB = 40…

Q: 2% (2067 V 2. A short-circuit test when performed on the H.V. side of a 10 kVA, 2000/400 V…

Q: The diagram shown in figure has two three- phase loads that form part of a manufacturing plant. They…

A: Given: Load 1 power=1.5MVAload 2 power=2MWfeeder resistance=0.4+j0.8 Ω/phase

Q: 5. What is the full-load current of a 230-volt, 3-phase, 125-horsepower synchronous motor when it is…

A: DATA GIVEN IS 1. VL=230 V 2. POWER P=125 HP 3. POWER FACTOR=80%==0.8 DETERMINE FULL LOAD CURRENT OF…

Q: What are the differences between the Inverting and Non-Inverting comparator

A: The differences between the Inverting and Non-Inverting comparator are as follows. Please refer next…

Q: 7. What is the minimum conductor ampacity, overload protection, and dual-element fuse rating for a…

A: Conductor: A conductor, often known as an electrical conductor, is a substance or material that…

Q: Find I7 using Norton's Theorem

A: Given: Consider the given circuit: To find: The current I7 using Norton's Theorem.

Q: in 2's complement system.

A: Code convertors-These code converters are used for conversion of one type of binary code to another.…

Q: ş DC (6 amps) 8 ohms 4 ohms 15 www 6 ohms 5 volts W 2 ohms 10 volts 12 www 1 ohm ·+|+ 15 volts www 3…

Q: 4.a. An inverter can be programmed to stop an AC motor quickly by enabling A. DC voltage injection…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: controller of the entioned system 4 7 O O O

A: ASM basically stands for Algorithmic State Machine. It is nothing but the flowchart of the digital…

Q: Rs + Vz RL Vi PZM In the following circuit Vi = 24V, Rs = 6.7k, and R₁ = 9.5k. The Zener Diode is…

Q: A. Choose the most appropriate technology for each of the system constraints below from among FPGA,…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: I- For the circuit given below 2 ΚΩ I mA 2V 0.5V 0.85V- 0.25V- 1V 4V 4kQ 50K0 Vo 3V 2.7v VA VB IV…

A: According to guidelines, only the first question will be solved. For any other solution, please post…

Q: 1. What is the full-load current of a 500-volt, DC, 20-horsepower motor?

A: Given data Voltage V = 500 volt Power P = 20 horse power Full load current I = ?

Q: 5-horse- a nameplate full-load

A: Given as, Nameplate full-load current =185A Minimum capacity of the conductor is 125%. full load…

Q: What is the minimum conductor size, overload protection, and inverse-time circuit- breaker rating…

A: Conductor: A conductor, often known as an electrical conductor, is a substance or material that…

Q: Based on the circuit configuration, determine the following: a) Ceq b) qT c) V₁ d) Vs C1=5AF C4 = 8…

Q: nano materials have high surface area property because small size little atom in the surface have…

Q: P.2-36 Given the vector function A = a, sin (6/2), verify Stokes's theorem over the hemispherical…

A: Given, vector function A = aϕSinϕ2

Q: Electrical Engineering 7 Discuss what is meant by a solid termination and relate it to the concept…

A: In this solution we discuss about the concept of solid termination & reflected impedance.

Q: Determine the current of the circuit show below.

Q: Q4) For the Amplifier shown in Figure (2), Find V. in terms of V; and V₂. 2 Vb 4Q m 20 V1 Vo1 2kQ…

Q: 10. The 8051 stack is O O O a) auto-decrement during PUSH operations b) auto-increment during POP…

A: here we have to identify in 8051 stack is performing which operation.

Q: What is the minimum sum-of-products expression for the following Kmap? AB 00 01 11 10 0 1 0 0 1 1 0…

A: Shown K map solve by formation of group of zeros for sum of product form formation of group is…

Q: Write a short note on each of the following 1) Propagation constant 2) Phase constant 3)…

A: Transmission line connection between the transmitter and receiver to permit signal transmission.…

Q: The VRAM system has to be explained.

A: Types of RAM SPRAM ( Static RAM) DRAM ( Dyanmic RAM) SDRAM RDRAM DDR SDRAM DDR1 DDR2 DDR3 DDR4

Q: The instantaneous voltage and current for the network in series having a voltage and current…

Q: Connect H.A. with truth table by using NAND gates only and Nor gate only

A: here we have to connect half adder using NAND gates only and using NOR gates only.

Q: 19.a. The easiest place to install an ammeter into a stepper motor driver/motor circuit for system…

A: Given: The objective is to choose the option that represents the easiest place which is used to…

Q: Q) A 3-ph balance express feeder has an impedance of (6+j20)₪/ph. At the UP load end, the…

A: In case of three phase system, first we need to convert into per phase model. Convert line voltage…

Q: Q.1 A single phase load of 100kv is connected across lines b and c of a 3-phase supply of 3.3kv.

Q: i need the answer quickly

A: Here the concept related to the Algorithm State Machine Chart (ASM-Chart) is discussed.

Q: 2) What are the salient features of supply voltage control method?

A: Supply voltage control method : To understand the methods of voltage control in power systems, we…

Q: The VRAM system has to be explained

A: Introduction - VRAM - VRAM is stands for video random access memory. VRAM is a sort of random access…

Q: A 3-ph balance express feeder has an impedance of (6+j20)/ph. At the UP load end, the line-to-line…

A: Given data, Impedance of per phase Zph=6+j20 Ω/ph Line voltage VL=13.8 KV Absorbed power P = 1200 KW…

Q: How many basic input parameters are required

A: NOTE_ “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Please solve the current I1 in the given circuit using Norton's Theorem.

A: Given circuit :

Q: .a. The maximum number of lines of resolution of an encoder that’s used with a three-phase stepper…

A: These are the questions related to constructional details of the stepper motors. Stepper motors are…

Q: Instructions Perform the ff. functions: 1. Create the truth table for the Boolean expression F = (A…

A: here we have to create a truth table for the given expression and other is to reduce the k-map.

Q: Q5-(A)- The all-day efficiency 200 KVA transformer is 96% when it is loaded follows 12 hours 120 k w…

A: From the given data we only we only need data regarding to maximum efficiency of the transformer.…

Q: Differentiate apparent power from true power.

Q: Q4) For the Amplifier shown in Figure (2), Find V. in terms of V; and V.. 20 Vb 40 m V1 Va ww 1.0kQ…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

100%

How to calculate to continues power of 500KVA generator at 60hz, 440v, pf 0.8?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the circuit shown in Figure 2.24, compute the voltage across the load terminals.
What is the wind power of a wind pump having 6meter diameter rotor at a wind speed of 3 m/sec?
A 30kW series generator has an efficiency of 88% when operating at rated load. If the stray power loss is 15%of the full load losses, calculate the maximum efficiency of the generator. Assume that the stray power loss isconstant and the other losses vary as the square of the load,
A 25kW series generator has an efficiency of 85% when operating at ratedload. If the stray power loss is 20% of the full load loss, calculate theefficiency of the generator when it is delivering a load of 15kW.
How do we increase or decrease the generated voltage output in the operation of afactory finished Alternator? Explain briefly your answer in one(1) sentence.
The power input to an electric motor is 8.8kw when operating normally from 230 volt ac source. If the current is 45 amp under this condition. Calculate the power factor, reactive factor, and reactive volt amperes
How much work could be performed by a 5968 W (8 hp) motor in 9 hours? __________J
The efficiency of a dc generator is 84%, if all losses amount to 1200W, the power output is _____
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
Shown in the figure, ahydroelectric plant has two devices, a turbine and a generator. If the efficiency of the whole plat is are =80 % , the efficienty of the generator is =93 %, calculate the efficiency of the turbine _____%
A 500-KVA 1-pahse alternator has an efficiency of 90% at full-load. If the load power factor is 0.85 lagging, what will be the total losses (in kW)? A. 3.47KW B. 12.21kW C. 28.86kW D. 47.22kW
10 kW, 230 V, d.c shunt generator is operating at rated condition with 80% efficiency. Input power and the total loss are respectively