I want to design a superheterodyne receiver with an IF frequency of 10MHZ to receive a frequency band of 20MHZ to 40MHZ. (a)Find the frequency range of the receiver local oscillator (b)Find the video frequency when the carrier frequency is 40 MHz (c)Briefly describe how the video channel of the video frequency mentioned in (b) can be reduced or eliminated.

I want to design a superheterodyne receiver with an IF frequency of 10MHZ to receive a frequency band of 20MHZ to 40MHZ. (a)Find the frequency range of the receiver local oscillator (b)Find the video frequency when the carrier frequency is 40 MHz (c)Briefly describe how the video channel of the video frequency mentioned in (b) can be reduced or eliminated.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

With the aid of diagrams, show and explain how phase locking is used to demodulate a frequency-modulated (FM) signal.
determine the basic concept of radar transmission and detection of rf signal. Illustrate with labels
(a) Cell phone signals in the range of 1.8 to 2.0 GHz are mixed with a local oscillator to produce an output signal at 70 MHz. What is the rangeof local oscillator (LO) frequencies required if the LOis belowthe cell phone signal frequency? What is the frequency range of the unwanted output signals? (b) Repeat if the local oscillator signal is above the cell phone frequency? (c) Which choice of LO frequency seems most desirable?
With the aid of diagrams, show and explain how phase locking is used to: demodulate a frequency-modulated (FM) signal. generate a range of frequencies from a single stable frequency source. synchronise an undersampled signal to the carrier frequency.
A communication system uses a superheterodyne receiver with an intermediate frequency of 10.7 MHz. Suppose the receiver is to receive a transmitted signal with a center frequency of 89.7 MHz. Determine the frequency of the local oscillator at the superheterodyne receiver.
discuss how the information signal is recovered from an FM signal using slope detector
[Q2] Answer the following: (a) Explain the effect of the value of μ)(modltion index ) on the modulation quality of AM-DSB-LC . (b) Explain the frequency conversion of the carrier.
State how the frequency of a carrier varies in an FM system when the modulating signal amplitude and frequency change.
P2: An FM transmitter has a 220 MHz carrier frequency. Its modulation index is 3 with a 5 kHz modulating frequency. The total exit power is 100 w in a load de 50 ohms. A) What is the bandwidth of this signal considering the side bands with more than 1% of the signal voltage? B)What is the approximate bandwidth calculated by Carson's rule?
For an AM envelope with a maximum peak voltage of 52 V and a minimum peak to peak voltage of 24 V, determine the ff. a. Percent modulation = ________? b. Peak voltages of the carrier and side frequencies = ________? c. Maximum positive to negative envelope voltage = ________?
In layman's term, explain intermediate frequency and its importance. What is the use of intermediate frequency in superheterodyne receiver?
A 93.2 MHz carrier is frequency modulated by a 5-KHz sine wave. The resultant FM signal has a frequency deviation of 40 KHz. (a) Find the carrier swing of the FM signal. (b) Determine the highest and lowest frequencies attained by the modulated signal. (c) What is the modulation index of the FM wave (d) Calculate the percent modulation? (e) Determine the bandwidth using approximation method.