Answered: Idea of Ocean thermal energy was given…

Engineering

Civil Engineering

Idea of Ocean thermal energy was given in 1981. Select one: True False

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter1: Energy Basics

Section: Chapter Questions

Problem 10P: The temperature of 1 m3 of water is decreased by 10C. If this thermal energy is used to lift the...

See similar textbooks

Related questions

Q: Water at a pressure of 200 kPa at street level flows into a house building at a velocity of 0.86 m/s…

Q: if reference point 1 is 19 m underwater in a pressure tank at 2 atm pressure and reference point 2…

Q: A typical ceiling of a house consists of items shown in the accompanying table. Assume an inside…

A: Given: The inside room temperature is 21oC. The attic air temperature is -10oC. The exposed area is…

Q: a. The velocity before the jump b. The depth after the jump c. The velocity after the jump d. The…

Q: Consider a steam turbine power plant operating near critical pressure, as shown in Fig. below. As a…

A: Given:- T1=700 C P1=P4=15MPa P2=P3=20kPa To find:- a) Isentropic Turbine efficiency b) Pump work…

Q: An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.1 m as shown in…

Q: Calculate the area in ft2 enclosed between pond and straight-line PV by offset method. Offset Point…

A: Step 1

Q: Activity 2. In the figure, the coefficients of friction are as follows: 0.25 between blocks, 0.20 at…

A: Draw the free-body diagram of the first block. Write the equation of the sum of horizontal force.…

Q: H.W.: Determine the natural frequency of the system shown in the figure. The beam is of negligible…

A: Mass = 25 kg

Q: Given data : Depth of flow=2 m Velocity of flow=3 m/s g=10 m/s2 Find specific energy

Q: In the figure, the pipe exit losses (1.5)v2/2g, where v is the exit velocity. What is the exit…

Q: loving to another question will save this response. con 37 A pressure gage 10.82 m. above the bottom…

A: Given data in question. Pressure Heigth above the base To find out Density of fluid Note…

Q: How high will liquid rise in the piezometers of shown in the figure if the pressure at M is liquid…

A: Given data in question Pressure at point M Specific gravity To find out Height h Note Acceleration…

Q: Moving Question 37 A pressure gage 10.82 m. above the bottom of a tank containing a liquid reads…

Q: 8.35 PLUS Oil with a kinematic viscosity of 4 X 10-6 m²/s flows through a smooth pipe 12 cm in…

A: Velocity is generally the rate at which the location differs. The average velocity is the…

Q: 2) From the figure shown below determine how many minutes would it take for the water surface in…

Q: 1. A slim-hole exploratory well was drilled to determine the thermal gradient of a given field. What…

Q: The pump in the figure discharges water at 45 lit/sec. Neglecting losses and elevation changes.…

Q: Problem 1: Water flows steadily from a tank, through a hose of diameter D = 40 cm, and exits to the…

Q: QI) If the system is in equilibrium, calculate the magnitude of F. F-100 KN 105

Q: Problem #3 (Evaporation): Evaporation from a lake can be obtained from the Penman equation. If the…

A: Given, Available energy at the Lake surface= 200 W/m2 Aerodynamic resistance= 30 s/m Air Specific…

Q: plot the relationship between the total energy line and hydraulic gradient line Vs distance from the…

Q: . If the temperature inside a class room is given by the function T = x² cos(9y) – z2 °C, determine…

Q: 4. BERNOULLI'S ENERGY EQUATION The radius of a water pipe decreases from 10 to 5 cm. If the average…

A: Given :- Radius, r1= 10cm r2= 5cm v1= 4m/s

Q: 10. How can we write energy using the MLT system? a) [M][L]?[T]? b) [M]°[L]?[T]1 c) [M][L]³[T]° d)…

A: Energy= Force × Displacement E= ( MLT^-2) × ( L) E= (M L^2T^-2 )

Q: , calculate the air velocity.

A: A pitot static tube is used to measure air velocity.

Q: Wet air out Water in Air in Air in Water out An cooling tower (see the figure above) is used to cool…

A: The given values are as follows,The water enterat rate of=117639kg/hThe dry air flows at rate…

Q: Figure provides steady-state operating data for a pump drawing water from a reservoir and delivering…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: Problem 1. A steel tape with a coefficient of thermal expansion of 0.0000116/°C is known to be 50 m…

Q: f the given system is released from rest in the position shown, calculate the velocity of B when it…

A: The values and diagram given in the question are as follows Weight of block A(WA)=6 N Weight of…

Q: Water flows in a 30 cm diameter cast iron pipe of relative roughness 0.0008. If the water flow rate…

Q: 1. If the atmospheric pressure at sea level is 7.5 N/cm2, determine the pressure at a height of…

A: Fluid mechanics is the discipline of physics that studies the mechanics of fluids (liquids, gases,…

Q: Hydrauli Distance Total from gradient line energy line referenc e line, m 1.85 1.86 0.2 1.842 1.862…

A: THE VARIATION BETWEEN DISTANCE FRON REFERENCE LINE vs HYDRAULIC GRADIENT LINE (HGL) AND TOTAL ENERGY…

Q: Given a system as shown in the following figure. Calculate the water level difference between two…

A: Given, Pipe length (L) = 15 m Diameter (D) = 30mm or 0.03m Volume flow rate (V˙) = 1 m3/h or…

Q: 4. A single well pumps water from a horizontally infinite confined aquifer at a rate of 6 m³/day…

A: Given data:- The given confined aquifer at the rate of flow is, Q=6 m3/day The aquifer has a…

Q: PROBLEM: In Lake Geneva (Switzerland), there is a water jet (called the Jet d'Eau) that is…

Q: Water flows at a uniform velocity of 3 m/s into a nozzle that reduce the diameter from 10 cm to 2…

A: The discharge will remain constant in the flow of water through the nozzle, as the quantity of water…

Q: An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.4 m as shown in…

Q: Estimate the discharge of a well pumping water from a confined aquifer of thickness 20 m with the…

A: The aquifer is a term applied to the upper layer of water, in which different layers of water have…

Q: An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.4 m as shown in…

Q: Given data Mass=8 kg Velocity=3 m/s Determine kinetic energy

A: Given data : The velocity of object=V V=3 m/s The mass of object=m m=8 kg

Q: 2) The temperature distribution in the square chimney is to be analyzed by the finite difference…

A: Cold forming has the effect of increasing the yield strength of steel, the increase being the…

Q: IFostatic pressure experiment 0: in the viscosity experiment we found the following data of sample :…

Q: A centrifugal pump is driven by a motor. The performance of the pump reveals the following…

A: Given:- Power input to the pump by the motor (kW):0.5, 0.7, 0.9, 1.0, 1.2Power input to the fluid by…

Q: 3. For an area latitude of 10°N the mean monthly temperatures are given. Calculate the PET of water…

A: Given data, Latitude = 10oN Types of crops = Wheat and rice

Q: Sunshine falls onto a large lake with a surface area of 300 km². If the water has an albedo of 0.2…

A: To determine the depth of evaporation for the lake. Given, Surface area of the lake, say A=300 km2…

Question

Idea of Ocean thermal energy was given in 1981.

Select one:

True

False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

at 38 degrees celsius and 218 kpa gage, the specific weight of a certain gas was 15.0 n/m^3. determine the gas constant of this gas in j/(kg-kelvin).
Civil engineering: Energy Please solve the problem clearly , don't use previously solved solutions. I am asking this for a second time. Hope you understand Question: The atmosphere is stable with a lapse rate of -0.2 degree C/100 m. The surfaces air temperature is 15 degree C. A parcel of air is released at the ground with a temperature of 25 degree C. Calculate the maximum mixing height, in m.
A 75 gal. electric hot water heater provides 9000 Watts of power to heat water. If the heater is filled with water at an initial temperature of 50ºF, how long will it take for the water to reach 140ºF? Assume that there are no heat losses.
The temperature of 1 m3 of water is decreased by 10C. If this thermal energy is used to lift the water vertically against gravity, what is the change in height of the center of mass?
Convert a pressure head of 10 m water column to kerosene of specific gravity equal to 0.8 and to Carbon tetrachloride of specific gravity 1.6
Solve the heat equation ut=cuxx on the domaion 0≤x≤2, t>0 subject to u(x,0)=x(x−2), u(0,t)=0,u(2,t)=0
A wooden shelter has walls constructed of wooden planks 1.00 cm thick. If the exterior temperature is -20.0°C and the interior is 5.00°C, find the rate of energy loss through a wall that has dimensions 1.95 m by 2.30 m.
What is the equivalent value of T58in degrees Fahrenheit, Rankine, and kelvin
The volume of atmospheric water is 12669km3. The evapotranspiration from land is 7200 km3 per month and from ocean is 505000 km3 per year. Estimate the residence time of water molecules in the atmosphere in a month.
Calculate the specific energy of 13 m3/s of water flowing with a velocity of 1.5 m/s in a rectangular channel 7.5 m wide. Find the depth of water in the channel when the specific energy would be minimum. What would be the value of critical velocity as well as minimum specific energy?
A coal-fired power plant discharges 1 m^3/s of cooling water into a river, which has a flow of 9 m^3/s and a temperature of 20 degree C. According to the regulation, the temperature in the river immediately below the discharge cannot be increased by higher than 1 degree C. Therefore, what is the highest temperature of the cooling water is allowed for discharge?
A 10-kg mass of superheated refrigerant-134a at 1.2 MPa and 70°C is cooled at constant pressure until it exists as a compressed liquid at 20°C. (a) Show the process on a T-v diagram with respect to saturation lines. (b) Determine the change in volume. (c) Find the change in total internal energy.