Identify which of the resistors in figure has the HIGHEST power loss or power across it 1η 10Ω 122092 13 30Ω -240V- O a. Voltage and Resistance values are needed O b. The smallest resistance

Q: 3 kVA, 50HZ, Single phase transformer, the primary voltage of the transformer is 110V. Req and Xeql…

A: Voltage regulation: It is the  change in percentage of output voltage from the no load to full load.…

Q: Please provide Handwritten answer. Electrical Engineering Two half-wave dipole antennas operating…

A: Given,Operating frequency, f=100 MHzDistance, R=25 kmTransmitted power, PT = 100 W

Q: transmision line

A:

Q: Compute for the value of Ix using nodal Analysis 0.51, V 452 www + 10/30° V +1 -j2 02: j3 Q

A: In this question we will find unknown current using nodal analysis......

Q: multiplexer contains. multiplexer contains.... select lines 4-1 4 O 20 8 O select lines 16-1 4 O 8 5…

A: In this question we need to choose a correct option

Q: 5. For the system shown in Figure 3, find the sensitivity of the steady- state error with respect to…

A: Steady state error:-  It is the difference between desired value and actual value when response…

Q: By Nodal Analysis, obtain I

A: The current through the resistor can be calculated by using the node voltage and the node voltage…

Q: Answer in detail: Consider that the SNR in dB is equal to 30 dB, what is the actual SNR value (not…

A:

Q: Question By using decoder, design a logic circuit to that can be used as code converter which…

A:

Q: A 4 pole lap connected shunt generator has 300 armature conductors and flux per pole of 0.1 wb. It…

A: Given data : poles of generator P=4 Armature conductors Z=300 Flux per pole ϕ=0.1wb Speed of…

Q: Example: A 100 hp, 250 V compounded dc motor with compensating windings has an internal resistance,…

A:

Q: the deviation d required amount. Example 10.4 A direct-FM transmitter has a varactor modulator with…

A: Given  Few parameters of frequency modulation.we need to determine the block diagram,and oscillator…

Q: KS ) For three input timing diagram shown below, do three of the following logic operations and draw…

A: Timing diagram is drawn for two cycles,as the given waveforms are periodic.for remaining cycles same…

Q: Draw the internal logic circuit for 3-8 decoder circuit with enable

A:

Q: + (a) Define external efficiency of an LED and how this efficiency can be increased. (b) With the…

A: Given  We need to enumerate about external efficiency of LED. Please find the below attachment for…

Q: Q1) A. Answer the following question: 1. What is the reciprocal of resistance? 2. An electric heater…

A:

Q: What are the W/L ratios for the transistors based on Fig. below ?of a three-input NAND gate +2.5 V Q…

A: Given: Consider the following figure: To find: What are the W/L ratios for the transistors based on…

Q: 10) The induced torque (Tind) in a machine was defined as the torque generated by the internal…

A:

Q: 03: if the input impedance and voltage gain of a voltage series feedback operational amplifier are…

A:

Q: 1. A series AC circuit consisting of L = 10 mH, R = 20 2, and C = 2 µF are connected across V = 10…

A:

Q: Using a vector model, sketch and show the effect of the following RF pulses on the thermal…

A: RF pulse means the radio frequency pulse it is technique the RF oscillation is gated at rate of…

Q: What is unit step signal

A:

Q: 1. Which of the following are the three main components of a simple circuit? A. battery,bulb, fuse…

A: As per Bartleby policy we can answer only three subparts. As you have not mentioned any part so I am…

Q: Q1:- Find i, (t) for t> 0 in the following network fig. (1): 4 kst www 2k12 2 kt 12 k 4 mA 100 μF,…

A:

Q: 4) For the circuit in the figure, find the mathematical expression for v₁ (t) in the interval Os…

A: It is given that:

Q: 4. The portion of the flux that goes through one of the transformer coils but not the other one is…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q1): For the circuit shown in fig.(1),there is no init transform method to find the currents i(t)…

A:

Q: A system is described by the differential equation below d²y(t) 5dy(t) dt dx(t) +8y(t) = -+ 7x(t).…

A: given here a differential equation and asked to find the system response.

Q: Three 2.5 kVA single phase 415 V / 1000 V, 50 Hz transformer are connected in Delta-Star con-…

A: Given: Three 2.5 kVA single phase 415 V / 1000 V, 50 Hz transformers are connected in Delta-Star…

Q: Find the efficincy for short

A: Insulator in transmission line- The device used to protect transmission line and prevent the…

Q: 3. Write down the conditions for RTE = RTM = 0. Under these conditions, a. for RTE, state what it…

A: Solution (a) : for the reflection coefficients ra0,k⊥ of the slabs at zero-frequency (the terms with…

Q: Question Realize f(a,b,c,d) = 210./24 6. 7./6. 7/ 11. f3. 1 other gate far 14, 15) with a 4:1…

A: NOTE: as per our company guidelines we are supposed to answer only one question . kindly re-post…

Q: The magnetic field intensity is given in square region 0.5<x< 1 y=0,1<2<15 by H = 2ax + x³ ay + y²…

A:

Q: Τ ~ em 3772 P(me) R₁ (@-@rm)

A: Induction motor: It works on the induction principle. It is single-side exciting and runs less than…

Q: 3. For the circuit shown, determine the circuit impedance, all the currents, voltage drops and…

A: As per the guidelines given to us we can only provide the solution of first three subpart in multi…

Q: "In getting the Norton's equivalent current source, we assume all sources to be equal to zero…

A: In norton theorem circuit is replace by norton equivalent current source parallel with norton…

Q: - 4.5 The work done by the force F = 4a − 3a, + 2a. N in giving a 1 nC charge a displace ment of…

A: Given data, Force F=4ax-3ay+2az N Charge q=1 nC Displacement dl=10ax+2ay-7az

Q: Determine the stability of the closed loop transfer function. 10 T(s) = Using Routh-Hurwitz…

A:

Q: Construct the magnitude and phase plot for the following transfer functions 100(s +20) H(s) = s(s+…

A: By observing se can se that the system is single input single output. The order of the system can be…

Q: For the circuit in Fig. (b) Vo is high .(VH) VDD = 2.5 V VDD = 2.5 V ML ML Vo Ms C I UGS C Vo I

A: Answer:True

Q: B. What is the unknown quantities of the following circuits shown below? 150 परीक 80 36V Ww 20V 502…

A:

Q: Find V4 by using Superposition theorem R₁ R₁ Ron E₁12 V 3012 R. 1 +11 1241 E

A:

Q: 1. A given system has a sampling rate of 32000 Hz. Determine the corresponding normalized angular…

A: Given  Few parameters of a low pass filter.we need to determine the normalised frequency and…

Q: illustrate charging by conduction and induction. Describe your materials and how the demonstration…

A: Given  We need to explain charging by induction and conduction. Please find the below attachment for…

Q: CALCULATE THE LINE CURRENTS, PHASE CURRENTS AND THE TOTAL COMPLEX POWER ABSORBS BY THE LOADS. 5Ω Μ…

A: Given circuit is shown below. Covert delta to star connection

Q: The diameter of an ACSR conductor is 1.14323 inches. The steel core has strands of diameters of…

A:

Q: Calculate the current drawn from a 50 V, 60Hz supply by an 80 mH inductor? O 1.66kA O 1.66A O 166A O…

A: Given, Voltage, Vs = 50 V  Frequency, f = 60 Hz  Inductance, L = 80 mH

Q: gle-loop circuit consists of a 7.20 resistor, a 12.0 H inductor, and a 3.20 of capacitor. In…

A: Any closed passage that passes through circuit elements is referred to as a loop. To create a loop,…

Q: Q² For several system that relate the input x(n) to the output y(n). For each, determine whether the…

A:

Q: Example: A 100 hp, 250 V compounded de motor with compensating windings has an internal resistance,…

A: Given: A 100 hp, 250 V compounded dc motor with compensating windings has an internal resistance,…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.