if a solar thermal electric plant generates 100 X 10^6 watts (100 MWe) of electric power, how much revenue is lost if the power plant shuts down for 5 hours. Assume that the cost of electricity in the state is $0.1/kWh.

if a solar thermal electric plant generates 100 X 10^6 watts (100 MWe) of electric power, how much revenue is lost if the power plant shuts down for 5 hours. Assume that the cost of electricity in the state is $0.1/kWh.

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter2: Basic Electricity

Section: Chapter Questions

Problem 34RQ: What is the Btu/hour output of an electric heater rated at 15 kilowatts? a. 51.15 Btu/hour b. 51,150...

See similar textbooks

Related questions

Q: Q1: Calculate Io in the circuit of Fig. (1) 24 V + Μ Μ 20 Ω 40 Ω Μ 10 Ω 20 Ω Μ Figure (1) Μ Μ 60 Ω…

A: The circuit diagram,

Q: Use mesh analysis to determine current in the circuit below

A: In the given circuit the value of unknown current Io needs to be calculated by using the mesh…

Q: The correct order in which the following modulation schemes can be assigned, from greater than Lower…

A: here we have to give bandwidth relation between the AM, DSB, SSB, VSB.

Q: Question 6 Vx www. R1 Ω Click here for image R20 ww R4 Ω www Gm Vx R3 Ω Find the current I, shown in…

Q: B: Tikrit University has been established its electrical distribution system in a special method…

A: VA=230 Volts,VB=225 Volts.

Q: Why is the feedback present loop present in most amplifier configurations?

A: In the amplifier, the negative feedback loop is present in most of the circuits. This is because the…

Q: Any overload current is sensed by the:

Q: Find the height of an infinitely long conductor from point P which is carrying current of 6.28A and…

A: Current is given I=6.28 A Field intensity is given H = 0.5 unit.

Q: 1- What is the transducer and what is used for? 2 What is the difference between temperature…

A: The importance of the transducer needs to be explained and the difference between the temperature…

Q: A resistor of 4 ohms and an inductive reactance of 3 ohms are connected in series across a 25 V AC…

A: Resistance R=4 Ω. Inductive reactance XL=3 Ω. Voltage supply V = 25 V.

Q: antum Adder: a) Draw the quantum circuit for the Full Adder shown below: (label gates by name to…

Q: What are the advantages and disadvantages of a conventional AM system with respect to DSB-SC?

A: Step-1-> Here are the advantages and disadvantages of a conventional AM system with respect to…

Q: Problem 1 - For the circuit below: (a) Identify and label all distinct nodes. (b) Which of those…

A: given here a circuit and asked to identify the nodes and extraordinarry nodes and series and…

Q: A band limited signal has the following Fourier series representation: is (t) = 10+ 6cos(2nt +30°)+…

A: The circuit diagram,

Q: (b) Series Resistors Circuit - KVL = (i) For the circuit of Figure 2.1a, assume the source-voltage,…

A: supply voltage E = 15 V resistances are R1 = 3.3 KΩ R2 = 2.2 KΩ R3 = 1 KΩ measurement of voltage…

Q: Write in detail the difference between T1, T2, T2* and PD?

A: Step-1-> T1, T2, T2*, and PD are different types of MRI sequences that are used to create images…

Q: 10V 10 V -15 V O 15 V -20 V IKQ -10 V 2V Please calculate the open circuit Thevenin voltage (VAB)…

Q: 2Ω 2 Ω 2 Ω M 6V 1ΩΣ V - 4A 12 V 1Ω Σ1Ω W

A: The superposition theorem states that in a linear circuit with multiple independent sources, the…

Q: Calculate the power factor of the entire circuit of Fig. 11.19 as seen by the source. What is the…

Q: II. USING KIRCHOFFS VOLTAGE LAW (KVL), FIND THE REQUIRED VOLTAGE AND CURRENT BELOW. a. Find I and…

A: Given Data: DC resistive circuits with, Voltage sources To Find: Current in the circuit and the…

Q: A plane electromagnetic wave is travelling from a medium with € = 81 and μ = 1 to a medium with € =…

Q: Determine the complete response of the current through the inductor it (t) for the following circuit…

A: The complete response of the current through the inductor needs to be calculated by analysing the…

Q: A power system has 200 buses including 40 generator buses. For the load flow analysis using…

A: Total number of busbar is given in question n = 200. Number of generators given in question = 40.

Q: D3.3. Given the electric flux density, D = 0.3r-a-nC/m-in free space: (a) find E at point P(r= 2,…

A: The electric flux density, D=0.3r2ar

Q: Q1) For the control system shown in Figure bellow Derive the transfer function C(s)/R(s). G₁ G₂ H₁…

Q: 2) Design a 4-bit up/down gray counter?

A: Step -1-> Design a 4-bit up/down gray counter-:

Q: 12V/ 6Ω =In the shown circuit, τ 2Ω www + Τα 1=0 İo 3Ω 2Η

A: Given circuit diagram is,

Q: Given the Boolean expression Q = ABC + ABC + ABC: Diberi ungkapan boolean Q = ABC + ABC + ABC; H.…

A: In this question we need to find the following Draw a logic circuit for the given Boolean…

Q: Find vo(t) if Vs = 25cos(50,000t) [V]. Give your answer in time domain. Ο 80 ΚΩ www m 80 ΚΩ {20 ΚΩ…

Q: 3120 www 60 3 V डे 1 = 0 www 60 4H iz (t) ३30

Q: (c) 25 (d) 40 The potential difference across resistance R₂ (in mV) is: (b) 784 (c) 560 (d) 300 (a)…

Q: 4. Find the values of the input and output impedances in Figure - 4. Also, determine the closed-loop…

A: The given op-amp circuit diagram is shown below, The parameters are,ZIN=2 MΩ.ZOUT=200 Ω.AOL=50000.

Q: + 20 Ω 40 Ω w 5Α 90 V υπ : 20 Ω + io 10 Ω 10 Ω : 30 Ω

A: We need to find the voltage across 30 ohm resistor by using superposition theorem . The voltage…

Q: Question 1 Find Rab, where each resistance is 3 ohms. a o b ww www ww

A: The circuit diagram,

Q: Z11 a' Z12 w www w A Z13 Z14 B Consider the balanced three-phase network. Z12-40, Z13-130.…

A: In this question We need to determine the voltage Van as shown the circuit. We are solving this…

Q: What is the shortest time taken for a 100 Hz a.c. to change from zero to half its peak value?…

A: Given: A Sine wave of frequency 100Hz To determine Time taken from zero to half it's peak value

Q: (a) Vs R1 R2 R3 R4 Vs=24V R1₁=452 R₂ = 60 Figure 1.1 For the circuit shown in Figure 1.1, calculate…

Q: Q4 (i) A 1200 kg car driving downhill goes from an altitude of 70 m to 40 m above sea level and…

A: we have given data from that we have to find the answer for the solution Height' Initial height…

Q: I. USING KIRCHOFFS CURRENT LAW (KCL), FIND THE REQUIRED CURRENT IN THE FIGURE BELOW. a) Find 11 if…

A: In this question we need to find the current I1 shown in the given fig .

Q: For a source voltage v. = 8 cos(2t - 40°) V applied to the circuit as shown, find the average power…

A: In this question We need to determine the power in the 1 ohm resistance. We know Power P= I2 R…

Q: In the circuit shown in Fig. 5, assume β = 100 for each transistor. Please determine R for that the…

A: The above question is based on DC analysis of 2 pnp BJTs in active regions. Circuit theory is used…

Q: (3): Parallel plate capacitor Q4. A capacitor of initially capacitance 0.08pF is filled with…

A: Given,Initial capacitance, Ci=0.08 pF.and,The table of applied voltage and its charge…

Q: 9. An electric circuit consists of two components as shown in the figure below. ZI www R₁ XL ooooo…

A: here we have to find the total impedance and modulus & argument of the impedance.

Q: Q5)A continuous-time system has a state space model given by X=¹₁2x+ut y(0-[10]x(t) 2] x(1) 1- Find…

Q: A layer of dielectric with a refractive index of 1.64 is deposited on the surface of a GaAs…

Q: Answer letter b only

A: In this question we need to find the value of current i and resistor R shown in the given circuit

Q: Determine the synchronising power and torque per mechanical degree of rotor displacement of a…

A: S = 50 MVAVL = 11 kVZs = 4.181 + j39.78%pf = 0.8lagging

Q: he no load output voltage of a certain zener diode regulator is 9.23 V and the full load output is…

A: The load regulation of a zener diode regulator is expressed as the percentage change in output…

Q: 3) For the given circuit; →Setup state the transition table →Sketch state the satate transition…

Q: (1) Find the input output relation between x(t) and y(t). (ii) Prove that the system is time…

A: From the given system the relationship between the input and the output needs to be calculated and…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: what is given and what to do:

VIEW

Step 2: Solution:

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the Btu/hour output of an electric heater rated at 15 kilowatts? a. 51.15 Btu/hour b. 51,150 Btu/hour c. 5115 Btu/hour d. none of the above
1/A Hydroelectric Plant has a Turbine and Generator with an efficiency of 65%. If the dam has a Head of 70 feet and the water flows at 625cubic feet per second, calculate the Power Generated in KW.
An electric crane lifts two tons of mass to a height of 10m in 10 second. If overall efficiency of the crane and motor is 65%, calculate energy required by crane and motor input power.
A diesel engine power plant has one 600 kW and two 250 kW generating units. The fuel consumption is 0.25 kg per kWh and the calorific value of fuel oil is 10200 kcal/kg. Estimate (i) the fuel oil required for a month of 30 days and (ii) overall efficiency. Plant capacity factor = 45%.
A commercial establishment has a maximum demand of 1000 kW and a load factor of 40%. It buys electrical energy at the rate of PhP 30.5347/kWh consumed. Calculate the monthly electricity bill of the establishment.
Suppose electricity Firm ABC generates 30 billion kilowatthours of electricity, which is about three times the output of electricity Firm XYZ. Which firm will have a higher cost per kilowatt hour? Why?
A 65000-kW thermal power station uses coal of calorific value 15000 kcal per kg. if the coal consumption per kWh is 0.5 kg and the load factor of the station is 40%, calculate (i) the overall efficiency (ii) coal consumption per day.
Assuming that the Philippines is consuming 3.5×10^20 kWh of electrical energy in one year and the power plant has a conversion efficiency of 32%. Determine the annual heat by the system in BTU. Express the answer in 4 significant figures.
A diesel engine power plant has one 700 kW and two 500 kW generating units. The fuel consumption is 0·28 kg per kWh and the calorific value of fuel oil is 10200 kcal/kg. Find the fuel oil required for a month of 30 days and overall efficiency. Plant capacity factor = 40%.
Assuming that the Philippines is consuming 3.5×10^20 kWh of electrical energy in one year and the power plant has a conversion efficiency of 32%. Determine the mass of fuel consumed in kg for one day operation if the fuel used is anthracite coal with heating value of 30080 kJ/kg. Express the answer in 4 significant figures.
A steam power station has a coal consumption of 0.54kg/kwhand a load factor of 50%. If the heating value of coal is 6400kcal/kg,determine the thermal efficiency, the energy generated per annum, and the coal consumption per annum. Maximum demand is 20,000kw.
A consumer has annual consumption 7,00,800 units. If his maximum demand is 200 kW. The load factor will be ??