Question
If a voltage spike lasts for 1.5 nanoseconds, what is the frequency of the spike?
Expand
Transcribed Image Text

If a voltage spike lasts for 1.5 nanoseconds, what is the frequency of the spike?

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: A switch that i s located inside a bedroom for an outdoor light does not require AFCI protection sin...

A: As per the NEC code, "outlet" is defined as the device from where electrical supply is taken for uti...

Q: 2. Given (s+1) s(s+2) Find the starred transform E (s) E(s) =

A: Given function is - Poles are -  

Q: 3. In the diagram at the right, the electric field at point A is zero. What is the charge Q1? a. +32...

A: Part (a) Since point A is equidistant from both the charges and the net electric field strength at t...

Q: Explain why voltage spikes and surges are occurrences. high-frequency

A: A voltage spike is defined as the sudden rise in the voltage above the normal voltage for a duration...

Q: 1 Determine the current through Z3 in the circuit of Figure P4.51. V1 = vg = 170 cos(377t) Z = 5.920...

A: Given circuit is – Given values are –

Q: 10.9 The collector characteristics for a certain transistor are shown in Figure P10.9. a. Find the r...

A: The collector characteristics of the transistor is:

Q: Find the Thevenin equivlent circuit

A: The impedance offered by the inductor is, Impedance offered by the capacitor is,

Q: 7 Solve for V2 in the circuit shown in Figure P4.57. Assume w = 2. 6 H ll 12 Ω ww + Vị +, V = 2520 V...

A: Calculate the impedance of the inductor,

Q: Using a 15-kΩ resistance, design an RC high-passfilter with a breakpoint at 200 kHz.

A: The circuit diagram of the RC high pass filter is,

Q: What will happen in Figure 21–6 if limit switches are installed and the jumpers from terminals 6 and...

A: Before making any predictions about the circuit one needs to analyze the given circuit properly. The...

Q: 7 Find the voltage across C in the circuit of Figure P5.57 for t> 0. Let G = 5 µF; C = 10 µF. Assume...

A: Draw the schematic diagram of the circuit for t>0.

Q: Find RMS using the formula for the wave in the graph

A: Given wave graph is –

Q: Calculate the power delivered by 10 V source using A) Norton analysis B) Mesh analysis C) Sources tr...

A: The given circuit diagram is: The power delivered by 10 V source is determined as follows: A) Norto...

Q: 4 In the full-wave power supply shown in Figure P9.44 the diodes are 1N4001 with a rated peak revers...

A: (a) Given circuit diagram is -   Given values are -

Q: Given a 115kV/13.2kV distribution transformer rated at 30 MVA (OA) with an 8% nameplate impedance (P...

A:   Since we only answer up to 3 sub-parts, we’ll answer the first 3.Please resubmit the question and ...

Q: Consider the Wheatstone bridge shown below: R = R1 = R2 = R3 = R4 = 225 Ω Resistance R1 deviates fro...

A: a. The circuit of Wheatstone bridge is:

Q: 0 Just before the switch is opened at t = 0 in Figure P5.21, the current through the inductor is 1.7...

A: Given circuit is – Given values are –

Q: The process of deriving an equivalent circuit ends when the original series-parallel circuit has bee...

A: When a circuit has many elements connected either in series or parallel then it becomes very much di...

Q: The circuit shown is at steady state when the switch opens at time t = 0. Determine i(t) for t ≥ 0.

A: Case 1: At t=0+, It is known that the inductor opposes the sudden change in the current. Thus, the c...

Q: A short vertical grounded antenna is designed to radiate at 10 MHz. If the radiation resistance of t...

A: A grounded antenna is basically a monopole antenna, The radiation resistance (Rr) of a short vertica...

Q: In the circuit below, R1 = 42 Ω, R2 = 42 Ω, i1 = 4.4 A, and i2 = -7.8 A.Use superposition to find th...

A: As per the superposition theorem, only one source is considered active at a time and the other sourc...

Q: Find the Thévenin equivalent circuit as seen by the3- resistor for the circuit of Figure P3.51

A: To find the equivalent Thevenin equivalent circuit remove the 3 Ω resistor and find the open-circuit...

Q: The directivity of a half wave antenna is 1.642. what will be the effective apeeturenof the antenna ...

A: The directivity of the antenna can be expressed as a function of the effective aperture of the anten...

Q: A./B. Find the Thevenin equivalent circuit. 6Ω -j1Ω 7/2220° V(+ j6 Ω) b C./D. Find the Norton equiva...

A: a). The circuit diagram is: The Thevenin equivalent voltage is: It is the open-circuit voltage acro...

Q: 26. Is the amount of motor reactive power Q higher than the amount of motor active power P when the ...

A: When a three-phase induction motor operates on no-load then the line current drawn by the motor is m...

Q: Find the following value.

A:  Referring to the circuit diagram, redrawing the circuit by marking the inverting and non-inverting ...

Q: Solve part a & b

A: a. The Inverse Laplace transform is determined as:              

Q: A. Find phasor voltages Vr Vc and V, and constuct phaser voltage diagram B. Find the voltages across...

A: The circuit diagram is:

Q: R2 S2 4Ω ww R1 C1 C2 R3 R4 voct): 4F 32 4 A 6Ω 20 V Figure P5.41 .42 For the circuit shown in Figure...

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part y...

Q: Find the inverse z-transfom of the following: ( – 2)z - 5z +6 a. z2 z-4 b. z - 5z +6 z(-5z +22)

A: To find the inverse z- transform of the following functions: Let the function be X(z): So,

Q: Find the Thévenin equivalent of the circuitconnected to RL in Figure P3.57.

A: Firstly, find the Thevenin’s voltage (open circuit voltage) across load RL. Remove the load RL and r...

Q: Using the properties of Laplace transform, find out the Laplace transform of  x(t)=cos(4t) u(t).  u(...

A: The unit step function u(t) is defined as In this case, the continuous-time function is given as U...

Q: 5 In the simple voltage regulator circuit shown in Figure P9.53, R must maintain the Zener diode cur...

A: The circuit diagram is:

Q: In the circuit of Figure P6.9: R = 1.3 k2 R2 = 1.9 k2 C = 0.5182 µF Determine: a. How the voltage tr...

A: The circuit is shown below.   First, the transfer function will be determined in order to solve the...

Q: @ what is the full load for a power Supply has A voltage requlation of 1% and no Load Voltage of 11 ...

A: The voltage regulation (VL) for a power supply is defined as  

Q: Q4- In the circuit shown in figure (4); R1 = 250 (N), R2 =100 (N), R3 = 120 (SN), R4 = 80.0 (2), XL1...

A: Redraw the circuit showing all the impedances along with their phase angles.

Q: Using the definition of the z-transform, find the z-transform and the ROC for each of the following ...

A: Click to see the answer

Q: By using SuperMesh Find :-- All equations- Find Ix- Find Power of Ib

A: Given circuit is –

Q: 3. Prove that the three-phase system of voltages on the secondary of the Y -A transformers lags the ...

A: Click to see the answer

Q: Find the average power delivered to a 445kl resistor by each of the periodic waveforms for current s...

A: Click to see the answer

Q: Solve part c & d

A: Simplifying the given function by using partial fraction Find the value of A and B Thus, 

Q: 9. Find all hazards in the following circuit equations, and realise the hazard free equation. F = [(...

A: Write the expression in the form as shown below.