what is the total impedance

Q: Analog to Digital Converter (ADC) ADCO804/0808 3. if 10 DC voltage source has been connected to Pin…

A: Brief description: ADC is used to convert analog value into a digital voltage. Digital voltage means…

Q: If the input voltage in the figure below is increased, the peak negative value of the output voltage…

A: The given circuit is a clamper circuit, it will shift the DC line of the input waveform. The diode…

Q: (a) Complete the following Table Q.la. All numbers are 8 bits. Table Q.1a Signed Magnitude One's +…

A: As per our guidelines we are supposed to be answer the first question only.  Kindly repost the other…

Q: 1-phase alternator has a nameplate rating of 400V, 60Hz. The equivalent impedance of the alternator…

A: Steps: Write the generating voltage equation interms of voltage drop and terminal voltage  Separate…

Q: 4. A circuit has a transfer function (8+1) H(s)-(² +65 +25) a. Determine the partial fraction…

A: A circuit has a transfer function: H(s)=s+1s2+6s+25 a) We need to determine the partial fraction…

Q: Example1/ An open wire T-L with R=10 K/Km,L=3.7 mH/km, C-8.3x 10-⁹F/Km and G=0.4x 10-6U/Km, find…

A: The solution is given below

Q: for the circuit in the FIG.  (a) suppose that the elements of the circuit have values such that…

A: Given the circuit, as shown below: Given:  R = 500Ω  L = 10mH C = 1μF. at t > 0 the switch is…

Q: A capacitive sensor in air measures 4.0 µF. It measures 10.0μF when placed in a non-conducting…

A: Given data, Capacitance in air, Ca=4.0 μF Capacitance in non-conducting liquid, Cl=10.0 μF

Q: - A OO MOVABLE ARM (WIPER) OB If the above potentiometer is rated for 10 kohm and the resistance…

A:

Q: P8.7 A stepper motor has a specification of 200 steps/revolution. The motor shaft drives a linear…

A: A stepper motor has a specification of 200 steps/revolution. The motor shaft drives a linear…

Q: Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic…

A:

Q: 11.69 A balanced three-phase source supplies power to three loads: Load 1: 30 kVA at 0.8 pf lagging…

A: Steps: Find the net active and reactive power Compare with the active power of all load  Compare…

Q: Draw the voltage vm as a function of time when Zo = Ro = 500 for figure shown www 5002 S3 10002…

A: In this question we need to draw the voltage Vm as a function of time

Q: 1- A 200-kVA transformer has an efficiency of 98 % at full-load. If the maximum efficiency occurs at…

A:

Q: 3.- (33) Find the h parameters for I₁ I₂ ww V₁ N R₁ R₂ V₂ the given circuit

A: In this question,   We need to determine the h parameters for the given circuit.  Using the virtual…

Q: conditions. The voltmeter was calibrated at the temperature of T = 25 °C. Table Q2: Voltmeter output…

A: A voltmeter is a device used for measuring potential differences across a point, voltage can be…

Q: 5- A single-phase transformer, working at unity power factor has an efficiency of 90 % at both…

A:

Q: 5.18. A small DC machine has an armature resistance of 4 ohms. Under no-load conditions when…

A: Given data, In first case, Armature resistance Ra=4 Ω Terminal voltage, V = 28 V Speed N1=700 rpm At…

Q: Problem 3: Imagine you have a long straight wire running along the x- axis. Now imagine that…

A: According to the given information in the question, the diagram is shown below,

Q: (b) Based on system in Figure Q2, calculate the overall system impulse response if p[n] = { –3,4,7…

A:

Q: The open loop transfer function of a unity feedback system is given by G(s)= (s+1)…

A: Solve the problem

Q: 11.29 In a balanced three-phase wye-wye system, the total power loss in the lines is 400 W. VAN =…

A: Steps: First, write the per phase mode and calculate the current magnitude using the given power…

Q: The mathematical description of the square wave with the added noise spike above is

A:

Q: A 10-hp six-pole 60-Hz three-phase induction motor runs at 1160 rpm under full-load conditions.…

A: In this question,  We need to determine the the slip and the frequency of the rotor currents at full…

Q: A transformer, when tested on full-load, is found to have Cu loss 1.8% and reactance drop 3.8%.…

A: The transformer is a device used for the transfer of energy, the power can be increased or decreased…

Q: Given the magnetic field vector potential: A= y z ax +2 x y z ay-xz az (A/m), find: (1) magnetic…

A:

Q: + through a conductor prove that §1.ds 7.ds = 0 For a DC current

A: The drift velocity can be explained as the average of the velocities acquired by the free electrons,…

Q: why is it 10 v instead if 20v?

A: In the given circuit, the input voltage magnitude is given as 20 V (peak-to-peak).

Q: Two single phase alternators operate in parallel

A: For KVL equations- Summation of voltage drops in a closed loop is  always zero. For KCL equations-…

Q: A signal x(t) is shown in Figure 1. 1 0 2 3 Figure 1: Signal x(t). (a) Sketch-x(t), x(t-1) and 2x…

A:

Q: The open loop transfer function of a unity feedback system is given by G(s) = (s+1)…

A: In this question we need to find centroid and choose a correct option

Q: A 1-phase alternator has a nameplate rating of 380V, 60Hz. If the equivalent impedance of the…

A: Here voltage is given as 380 voltage and power factor is 0.8 leading.

Q: Represent Vrms = 120V as a voltage equation O v(t) = 120 V sin(360° x t x f) O v(t) = 84.85 V…

A:

Q: y(n)= y(n-1) - 0.21y(n-2) + 3x(n) + 2x(n-2) a. find zero input response , yzi(k) when the inintial…

A: The solution is given below

Q: QUESTION 5: Consider the ideal inverting summing amplifier in Figure 9.14(a). Design an ideal…

A: We need to find out unknown resistance value for given output expression.

Q: Implement a Boolean function F (A, B, C, D) = A +B'C+A'C'D. Also implement with NAND gates.

A: The solution is given below .

Q: Vi 100 ww 500 500 MA M2 LOVO Linear Source follower

A: MOSFET is a FET transistor with a closed gate where voltage determines the smooth flow of the…

Q: Draw the output waveform and include the voltage value (silicon diode). R O www 2.2 ΚΩ +30 V D₁7 D₂.…

A:

Q: The minimum voltage along a transmission line is 260 volts, while the maximum is 390 volts. The SWR…

A: SWR (standing wave ratio) It defines the mismatch on the line Also it defines as the measure of…

Q: 3) A 450 V, 50 HZ, Y-connected, six-pole synchronous generator is rated at 50 KVA at 0.8 lagging pf.…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Vin R3 10. If Vin= 14V, Vz= 6.1V, Vae = 1.1V, he = 50 then, VOUT = V L = Ic= MA MA MA R2 250 R1 750…

A: We need to find out voltage and current for given circuit

Q: 8.8 Explain what is meant by micro stepping.

A: Micro stepping is a process to drive or run stepper motor in which it rotates upto only a fraction…

Q: A 1-phase alternator has a nameplate rating of 380V, 60Hz. The equivalent impedance of the…

A:

Q: A spherical capacitor having a radius of 5cm and 5.5cm for positive and negative conductor…

A:

Q: (a) Choose sensors, from the list below, to be used in the following situations, and explain your…

A: Sensors are the devices which are used to detect the change of any physical parameter or property of…

Q: Assume that the operational amplifier in figure is ideal, the current I through the 1 K ohm resistor…

A: To find the value of current flowing through 1 kohm resistor

Q: +v B www R1 2.6 ΚΩ 100 V A V2 ww Μ R2 625 Ω R4 6 ΚΩ 5000 11 ww R3 4 ΚΩ + 10^(-3) V2

A: In first paper the required values of open circuit voltage voc/vth,isc,Rth is calculated. In second…

Q: Design a counter with T flip-flops that goes through the following binary repeated sequence: 0, 1,…

A: The solution is given below

Q: 10/0° v www 402 ww 852 C √2.2 ww 2/-90⁰ A J6 -√³52 T b MA ·106 Jon

A:

Q: Plus the following: 8. Find Vs

A: The required parameters of the circuit can be calculated by using nodal analysis.