If it is known that the deflection measured at the horizontal tangent point of a conductor installed at a 400 meters symmetrical pole span in the ice load area is 16.67 meters, what is the deflection at 188 meters from a suspension point? Write it in the answer box below, two digits after the comma.

If it is known that the deflection measured at the horizontal tangent point of a conductor installed at a 400 meters symmetrical pole span in the ice load area is 16.67 meters, what is the deflection at 188 meters from a suspension point? Write it in the answer box below, two digits after the comma.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 28P

See similar textbooks

Similar questions

23. The arch of a masonry bridge is a semi-ellipse whose span is 95 ft and whose height in the center is 24 ft. What is the height of the arch 16 ft from the center? Express your answer in percent with 2 decimal place.
A box slides from rest at point A down an inclined 30 degrees to the horizontal. After reaching the bottom of the plane, the box moves on a horizontal floor at a distance 2m before coming to rest. Coefficient of friction between the box and the floor is 0.40 a. What is the distance from point A to the intersection of the inclined plane and the horizontal floor? b. What is the velocity of the block as it reaches the intersection of the inclined plane and the horizontal floor? c. What is the total time of travel until it stop?
A stone is dropped from a balloon while ascending at a constant rate of 8.14 m/s and the stone reaches the ground in 7.14 seconds. Determine: a) Height of the balloon when the stone was dropped b) Velocity of the stone after 3 sec before it touches the ground c) Velocity of impact of the stone when it strikes the ground
A windshield wiper 30 cm long (blade and arm) rotates 150°. If the rubber part is 20cm long, what is the area cleared by the wiper?
An observer is located at 35 degrees North latitude and wants to know the declination of something that just reached its maximum altitude 75 degrees above the southern horizon. What is the declination of that object? (Hint: Think about what declination is measured relative to before starting your calculations)
If water with a height of 1.2 m in a manometer is replaced by oil with specific gravity of 0.75, what is the equivalent height?
1. What is the value of M1 and M2? 2. What is the percent error if the true value is 149 g?
A rectangular piece of wood 30 cm square and 5 cm thick floats in water to a depth of 3.25 cm. How heavy an object must be placed on the wood (sp. gr. 0.50) in such a way that it will just be submerged? Note: The final answer must be 15.45 N.
I will downvote the wrong answer. Kindly solve if you are 100% sure A water column in a glass tube is used to measure the pres sure in a pipe. The tube is 1/2 in. in diameter. How much of the water column is due to surface-tension effects? What would be the surface-tension effects if the tube were 1/8 in. or 1/16 in. in diameter?
If snow were piled up to a height of 1.00 ft on a roof that is 30.0 ft x 50.0 ft, determine the mass of snow on the roof in tons. (Assume that 1 ft3 of snow is equal to 0.100 ft3 of water and that 1 ft3 of water is equal to 62.0 lb).
By what factor do you increase the resistance to bending (about y–y axis) if you were to use W460 × 113 beam over W200 × 46.1 ?
1. Calculate the deflection at B in mm. No need to type the sign and the unit of your answer.0 2. Calculate the slope at B in radians. Express your answer in x10-3. No need to type the sign and the unit of your answer.0 3. Calculate the deflection at C in mm. No need to type the sign and the unit of your answer.0