If P = sin (5t + x - ) a, and Qs = el* (ax - a,) sin(2ny), determinea) the phasor form of Pb) the instantaneous form of Qs-

a) Phasor form of the P P=sin5t+x-π4ayconvert it into exponential form,P=imgej5t+x-π4aynow drop the…

Answered: If P = sin ( 5t + x -) a, and Qs =…

If P = sin ( 5t + x -) a, and Qs = el*(a, - a,) sin(2ny), determine %3D a) the phasor form of P b) the instantaneous form of Qs.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 3RQ: How many degrees are the current and voltage out of phase in a pure capacitive circuit?

See similar textbooks

Related questions

Q: What is the frequency for a wavelength of 2 meters? Show detailed calculation.

Q: For the flat solar collector shown in the figure. Determine the angle of azimuth-sun pareol (x) and…

Q: Electromagnetics Given A= pzsin(φ) ap. If B= curlA. Determine Bz at (p=6, φ=0.9,z=5) 4 decimals

A: We will find out curl of given vector in cylinderical coordinate system to find out B .

Q: A lossy dielectric has an intrinsic impeadance of 200(30°Ohm at a particular radian frequency w. If,…

A: Please refer the attached images for the complete answer..

Q: rder to change the behavior of a 2nd order underdamped system, we need to move its closed-loop poles…

Q: 3. Explain why Phasor and impedance diagrams have the same angles.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Explain why Phasor and impedance diagrams have the same angles.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Two sinusoidal waves of wavelength A = 2/3 m and amplitude A = 6 cm and differing with their phase…

A: (1) Given data, λ=23 mA=6 cmv=50 m/sThe basic equation for the two sinusoidal wave is given…

Q: 2- Consider the three dielectric materials listed in the below table. At a given voltage, which…

A: Since you have asked multiple questions, we will solve the one question for you. If you want any…

Q: Problem 3: Determine the symmetrical components of the three currents la = 10/0: , Ib = 10/230' ,…

A: Given three phase currentsIa=10∠0° AIb=10∠230° AIc=10∠130° A

Q: Which among the following is not a factor affecting corona effect? Select one: O a. Conductor size…

Q: 2.31 Plot the bounce diagram for the transient circuit shown in the accompanying figure. Include at…

Q: Which among the following is not a factor affecting corona effect? Select one: O a. Conductor size O…

A: according to the question we have to discuss the corona effect.

Q: What value of capacitance is required to produce 50 2 of reactance at 450 MHz?

A: To solve above problem, one should know how to find equivalent capacitance for series and parallel…

Q: The characteristic impedance of a losseless transmission line is 60N. Find the inductance of the…

A: DISTORTION-LESS LINE: A line in which a wave propagates without any distortion is called a…

Q: what value of capacitance is required to produce 50V of reactance at 450 MHz

Q: Electromagnetics Given D= 3pzcos(φ) aφ. If B=curlD, determine Bp at (p=1, φ=1.8 rad,z=-4) 4 decimals

A: Given D=3ρzcosϕ aϕThe point isρ=1,ϕ=1.8 rad z=-4

Q: The angle formed between A = 5a,+ 10a,+10az and surface z = 5 is

A: Given, A=5aρ+10aφ+10az Surface, Z=5

Q: The skin effect would when the is increases. A. decreases, diameter unchanged, frequency С.…

A: The solution is given below

Q: Transmission line is a specialized cable or other structure designed to conduct electromagnetic…

A: Given the electrical characteristic of the transmission line. We need to provide suitable…

Q: A transmission line has characteristic impedance of 75 Ω and it is connected to receiver with Zr=…

Q: Electromagnetics Given A= (x^2y+z) az. If B= curlA, determine By at (2,4,3) 4 decimals

Q: Derive the expressions for the Ex, Ey, Bx, By in Waveguides.

A: Aim: to derive Ex , Ey , Bx , By in waveguides. Below is the complete solution

Q: Derive expression for capacitance in a transmission line.

A: Derive expression for capacitance in a transmission line.

Q: A 200 Watt power of 30 MHz frequency is used to heat a resin piece of area 150 cm^2 and thickness 2…

Q: Step by step determine how you would get the phasor diagram?

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…

Q: Explain in detail (no mathematical expressions) the following terms used in microwave theory:…

A: The transmission line helps in transmission of power from the generation side to the load…

Q: a) A lightning strikes a 30-m unshielded over-head following parameters: Surge impedance of the…

Q: state how corona is formed around HV conductors and explain why corona is self checking

A: The principal reason for the occurrence of corona is excess voltage through the line the atmospheric…

Q: In a nonmagnetic material electric field intensity is given by E =16 cos(4*108t- 2x) ay V/m The…

A: In the question, In a nonmagnetic material electric field intensity is given by E =16 cos(4*108t-…

Q: Calculate the value of ZL in the circuit in order for ZL to receive maximum average power. What is…

A: Maximum power transfer theorem says that to obtain maximum power from a network, the resistance of…

Q: examplein quaterial hight having auavelength of 500 A falls on having aphoto electric work function…

A: The solution is given below

Q: For an antenna with input power Prad = 400 W, rms current i = 4 A, and dc resistance R. = 4,…

A: Given: Input power Prad = 400w Srms current I = 4A DC resistance Ra = 4 ohm

Q: Our basis for the construction of line phasors is the COSINE function. True B False

A: In this question we need to verify the given statement is true or false.

Q: An antenna with a radiation resistance of 48 ohms, a loss resistance of 2 ohms, and a reactance of…

A: antennae resistance 48 ohms loss resistance 2 ohms reactance 50 ohms voltage 10V IMPEDANCE 100 ohms

Q: Light from a chromatic light source strikes a surface. 20% is reflected and 30% is absorbed. a.)…

A: Light is generated from the monochromatic source. The reflected light is 20%. The absorbed light is…

Q: All antennas types radiate uniformly in all directions O True False O O

A: Antenna:- Antenna is a structure which transmits or captures waves which are radio electromagnetic.…

Q: Prove that when B ,l , and are not mutually perpendicular, motional emf is given by emf=Blv sin θ.If…

A: To prove: B ,l , and are not mutually perpendicular, motional emf is given by emf=Blv sin θ.If is…

Q: False

Q: Q3) Define the return loss of a microwave circuit in terms of the reflection coefficient and the…

A: Given: Return Loss =18 dB Required: (A) The reflection coefficient Γ (B) The…

Q: EXAMPLE 3.3. A 400 watts carrier is modulated to a depth of 75 percent. Find the total sinusoidal…

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: What value of capacitance is required to produce 50 ohm of reactance at 450 MHz

A: According to the question we have to find the value of capacitance.

Q: An antenna with a radiation resistance of 48 ohms, a loss resistance of 2 ohms, and a reactance of…

Q: M.C.Q At higher wavelength , Planck’s law is converted into wein's law rayleigh- jeans law…

A: At higher frequencies, Planck’s law is converted into Wein’s law. About 500 nm of wavelength the…

Q: The relation between impedance and admittance locus is ..

A: Admittance is the reciprocal of impedance.

Q: Design a parasitic antenna for TV channel 7. Show your solutions?

Q: For the figure shown, what is I in rectangular form?

Q: Derive expression for capacitance in a transmission line? Subject: power transmission and…

A: Consider a Capacitance of a Single Phase Two Wire Line comprising of two equal transmitters An and B…

Q: Q.3 Answer any One of the following A. Define the return loss of a microwave circuit in terms of the…

Concept explainers

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.

Question

If P = sin (5t + x - ) a, and Qs = el* (ax - a,) sin(2ny), determine
a) the phasor form of P
b) the instantaneous form of Qs-

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Compensation Techniques in Transmission Line

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What does Ish,Ia,Eg,Ra Stands for in this given problem.
For an end fire array when the the spacing between the elements is lamda by 4 and the phase angle B=180 then the direction of maxima along
i see thes answer, also graph for phase i think wrong, please can you check
When you are converting an instantaneous current to a phasor, how does the phase angle being positive or negative affect solving the problem i.e. the representation being (wt - the phase angle in degrees) or (wt + the phase angle in degrees)?
a) A lightning strikes a 30-m unshielded over-head transmission line tower which has the following parameters: Surge impedance of the tower = 100 12 Surge impedance of lightning channel at tower top = 500 12 Tower-footing resistance = 10 12 Tower height = 30 m Cross-arm height = 27 m The lightning strike current is assumed to be a constant 30 kA for a duration of 20 us. The traveling wave propagation speed in the tower is 1.2 x 108 m/s. i) Determine the voltage reflection coefficients at tower top and tower foot. (ii) Determine the time of travel from tower top to tower foot. (iii) Determine the time of travel from cross arm to tower foot. (iv) Draw the voltage lattice diagram with proper labels of the time. (v) Ignoring the phase voltage, determine the insulator voltage after 2 us. The insulator voltage approaches a constant value after 2 us. If the basic impulse insulation level (BIL) of the insulator for phase conductor is 150 kV, evaluate the condition of the insulator and conclude…
Dose antenna 4g or 5g have heatlh effect on people? How much does this effect goes does it depend on antenna type or frequncey/power.
Sketch the phasor diagram showing ?s , ?R,??R, ?c and I
Step by step answer how to converting Rectangular form, Phasor form, and sinusoidal form
Explain why Phasor and impedance diagrams have the same angles.
If IL = 2IC, which of the given for the following circuit is correct? A) The iC phasor is 90 degrees forward from the iL phasor. B) VR phasor is in phase with iC phasor. C) The iR phasor is 90 degrees forward from the VC phasor. D) The iR phasor is in phase with the iL phasor. E) The VL phasor is 90 degrees forward from the iC phasor.
Step by step determine how you would get the phasor diagram?
The following phasor diagram is: a. The phasor diagram of SG when it is running at lagging power factor b. The phasor diagram of SM when it is running at leading power factor c. The phasor diagram of SM when it is running at lagging power factor with the existence of RA d. The phasor diagram of IM when it is running at lagging power factor