Answered: If the amplifier gain is tripled, the…

Engineering

Electrical Engineering

If the amplifier gain is tripled, the PLL open-loop gain will:

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.3P

See similar textbooks

Related questions

Q: Determine the current flowing through the resistor R1. (assume LED forward voltage is 2.1 volts) *…

A: In this question, We need to determine the current flowing through the resistor R1. Current I= V/R…

Q: Which of the following is not a property of a Fourier Transform? Choices: a.) Modulation b.)…

Q: What is the mass and charge of an electron?

A: In this question, We need to determine the mass and charge of electron

Q: Calculate the wavelength for a 4 GHz frequency. Select your answer. 0.75 µm 0.75 m 75 m 75 mm

A: In this question, We need to choose the correct options What is wavelength if frequency f=4Ghz

Q: Example3/ An open wire T-L with G=0.29× 10-6U/Km ,L=3.52 mH/Km, C=8.7 nF/Km ,R=6.74 K2/Km at F=1 KHZ…

Q: If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship…

A: The solution is given below

Q: 5. The figure below shows a logic circuit and its incomplete truth table. Complete the below truth…

Q: What is the dynamic resistance of a diode if its ID = 2.48 mA? No need for a solution. Just write…

A: The solution is given below

Q: Q A candipous -tine Periodic signl X)is reat Valued and has a funde mentral Period ToS The Hanaca…

A: By using Fourier Series analysis

Q: coil is connected to a 230 volt source. If the voltage across the inductor is 125v, and the power…

A: We need to find Current and power factor for given circuit .

Q: Two parallel conducting plates are placed in free space and are located at y = 0 and y= 0.02 m and…

Q: Calculate the synchronizing torque for unit mechanical angle of phase displacement for a 5,000-kVA,…

A: Given data, S = 5000 kVA f = 50 Hz N = 1500 rpm V = 6600 V Xs = 0.15 pu Poles = 4

Q: 4. The figure below shows a logic circuit and its incomplete truth table. Complete the below truth…

Q: If the signal power is twice to its noise power, the information capacity will: Select your answer.…

A: The solution is given below

Q: 15 D1 R1 5V 1K D2 KH Determine the current flowing through the LED. (assuming its forward voltage is…

A: The given circuit is:

Q: Based on the circuit in Figure Q2, find voltages vi and v2, and calculate the power dissipated in…

A: The solution is given below

Q: If the signal-to-noise ratio is lowered by 60%, the following value will be obtained: Select your…

A: The solution is given below

Q: 17 R2 1K R1 5V D1 1K Determine the current flowing through the resistor R2. (assume LED forward…

A: In this question, We need to determine the current flowing through the resistors R2? Assume…

Q: C(s) s+2 2. G(s) = R(s) Write the state matrix s2+4s+3 equation and the output equation in the phase…

A: Brief description : In the above given question they have mentioned transfer function of the system.…

Q: 17 Determine the current flowing through the LED if its forward voltage is 2.1 volts. * D1 R1 5V 1K

A: The solution is given below

Q: If the amplifier gain is tripled, the PLL open-loop gain will: Select your answer. also tripled…

A: The solution is given below

Q: Increasing the efficiency of power transmission through the antenna can be controlled by making the…

A: The solution is given below

Q: for given conductor is AC resistance is 25 Ohm the the DC resistance is =________Ohm?

A: RAC=RDC K F K=Wire gage factorF= frequency Generally, Rac is 1.2 to 1.3 times Rdc

Q: Example4/ A telephone cable with R=52.5 KO/Km , C=62 nF/Km , G=0 and L=1.1 mH/Km , find ,x ,B ,Vp…

A: The solution is given below

Q: Questoin 7) The size of the pMOS transistor(s) for a standard size NOR3 pseudo-nMOS gate is…

A: A Pseudo-nMOS gate consists of a inverter, where it's gate is pulled to ground and uses a p-device…

Q: The waves transmitted fr the source in the open ci lines suffer complete regression, so the open c

A: When the transmission line is open circuited the open circuit impedance is totally dependent on the…

Q: An discrete time LTI system is characterized by the following LCCDE: y[n] = -0.5y[n – 1] + x[n] –…

Q: What is the dynamic resistance of a diode if its Ip = 4.06 mA? No need for a solution. Just write…

A: The solution is given below

Q: Example3/ An open wire T-L with G=0.29x 10-6U/Km ,L=3.52 mH/Km , C=8.7 nF/Km ,R=6.74 KQ/Km at F=1…

Q: 12.50 An air-filled cubical cavity of size 10 cm has E = 200 sin(307x) sin(30ry) cos(6 × 10°t)a¸ V/m…

A: It is given that: E=200 sin30πx sin30πy cos6×109 az V/m

Q: Determine the current flowing through the 4 ohm resistor.

Q: In the circuit shown, determine the current flowing through the resistor R1. R2 1K R1 5V D2 1K

A: In this question, We need to determine the current in the resistance R1 Assume forward bias…

Q: Example3/ An open wire T-L with G=0.29x 10-6U/Km ,L=3.52 mH/Km , C=8.7 nF/Km ,R=6.74 KQ/Km at F=1…

Q: write true or false in the following sentences: 1. Load torques which always oppose the motion and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Which multiplexing is used for transmitting information through the осean. FDM STDM WDM TDM Which…

A: We need to answer which multiplexing is used for transmitting information through the ocean and also…

Q: Given the differential amplifier shown, determine If1, VRE, and VC1- Vcc=+15V RC1 5 ka RC2 5 ka RB1…

A: Brief description : In the above given question they have mentioned a differential amplifier circuit…

Q: The impedance of the series RL circuit with R=25 and L=10 mH at 1000 Hz is? Answer in Z<theta.

Q: Given: To = 2 2t – 2, x(t) = {o, 0sts1 1sts2 Find the complex Fourier series coefficient, Xp.

Q: A 5nc Point chabge is located at Rint (x=o; Y=5; z=2) An infrite sheet of charge weth soface charge…

Q: Determine the voltage across R1. (Assume LED forward voltage is 2.1 volts and diode forward voltage…

A: The solution is given below

Q: 12 V 12 V ĮR3 $490k2 R1 Q1 2N2219 R2 2.2k2

Q: .Three resistances have the following ratings : R1= 25+ 5% R2= 43+ 3% R3= 85+5% Determine the…

Q: what is the effect of varying both the integrator and differentiator time constant system? Explain…

A: We have seen in our RC integrator tutorial that when a single step voltage pulse is applied to the…

Q: The waves transmitted from the source in the open circuit lines suffer complete regression, so the…

A: When transmission line is open circuited its impedance is deoendent on the output impedance of the…

Q: a R C The switch in the circuit above has been in position a for a long time. The variables in the…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: The input and output of a linear network at frequency w = 100 rad/s are given, respectively, by v,…

Q: What exactly is a latch?

A: Defination of a latch:

Q: Ca. Solue the difference equetion by uspng <-transPorm. Yon+2)+6461))+9 den)-2ucn)

Q: q4/The diode and the switch places are swapped. Plot the input and output voltages and determine the…

A: A ripple factor is to identify the purity of the output of the rectifier. It is the ratio of AC…

Q: Figure Q3(a) shows a system that produces output m(t) from the input x(t) given in Figure 1. (а) 2…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

I need the answer as soon aa possible with explanation.

If the amplifier gain is tripled, the PLL open-loop gain will:
Select your answer.
also tripled
decreased by one-third
remains constant
approaching to infinity

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Explanation

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A ampliﬁer’s closed-loop voltage gain Av is described by Eq. as shown. What is the minimum value of loop gain T required if the gain error is to be less than 0.2 percent for an ideal gain of 50 dB?
Design an inverting amplifier with equivalent input resistance of Ri kΩ and gain Gspecified in Table 2. 1) Draw the circuit diagram of the amplifier, clearly naming components in the circuit. 2) Determine the component values. Use the component names that correctlycorrespond to those in your circuit diagram.
For the inverting operational amplifier circuit above, if R_{in} = 2k \OmegaRin=2kΩ and the closed-loop gain is to be G = -40G=−40, what is the appropriate value that should be chosen for resistor R_fRf? Enter your answer in units of Ohms, while omitting the unit.
A noninverting ampliﬁer is designed to have a gain of 200 (46 dB) and is built using an operational ampliﬁer with an open-loop gain of 80dB. Find the values of the ideal gain, the actual gain, and the gain error. Express the gain error in percent.
Question: An amplifier has a low-pass frequency response given by only one pole. The magnitude of the gain is 20 dB at DC and 0 dB at 118 kHz.a) What is the frequency of the pole?b) At what frequency is the phase -6°? Please comment each passage and expand every possible equation.
From these data in Table, compute the gains Ad and Acm and verify that they are as designed. (Q2) From these calculations, what is the CMRR of this amplifier? (Q3) Is your differential amplifier working well?
1. For the summing amplifier shown below, solve the voltage gain Av and output voltage Vout
Your Boss asks you to get more knowledge about operational amplifiers by studying specific operational amplifiers of your choice both FET and BJT based technology (make sure datasheets are available with your final report): A) From the datasheet, find the number of pins of the Op-amp IC, the open-loop gain, bandwidth, CMRR, slew rate, Voltage offset, current offset, input and output impedance, recommended supply voltages. Tabulate your outcomes with evidence from the data sheets. For both types of Op-Amps. Discus advantages and disadvantages of both.
Show the manual solution of the simulated values of the unity gain amplifier.
Suppose we have a signal source with an internal (i.e., Thévenin) impedance that is always less than 1000 Ω, but is variable over time. Using the components listed in TableP13.36 , design an amplifier that produces an amplified version of the internal source voltage. The voltage gain should be −20±5 percent.
Find an expression for the closed-loop gain G = v0/vS. Then, assume that R1 = 1kΩ, R2 = 4kΩ, C = 1uF.
(a) Estimate the voltage gain of the inverting amplifier given. (b) Place a bypass capacitor in the circuit to change the gain to approximately−10.(c) Where should the bypass capacitor be placed to change the gain to approximately −20? (d) Where should the bypass capacitor be placed to achieve maximum gain? (e) Estimate this gain.