Answered: If the cooling tower range and approach…

If the cooling tower range and approach are 10 and 15 degrees centigrade respectively, find the cooling tower effectiveness.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter6: Forced Convection Over Exterior Surfaces

Section: Chapter Questions

Problem 6.51P

See similar textbooks

Related questions

Q: Calculate the load of coil with heating 1.6 m3/s initial air in 22 DBT and 15 WBT and pressure…

A: Air conditioning: It is a process in which air gets heated or cooled to maintain its properties to…

Q: A refrigeration system is used to cool water in the evaporator an 8 kg/s of water from 30C to 2C.…

A: The amount of heat that each pound of refrigerant retains from the refrigerated space to provide…

Q: 2.13: To provide natural draught, a chimney of height 16 m is used. Calculate, )The draught in mm of…

A: Given:- H=16m Find:- Draught in mm of water for maximum discharge (h)=? if Tg=350 degC = 350+273…

Q: 10kg/sec of steam enters a condenser with enthalpy of 2300kJ/kg and velocity of 350m/s , the…

Q: Calculate the height of a chimney required to produce a draught equivalent to 1.7 cm of water it the…

A: The solution is

Q: 2. The actual specific evaporation of a certain boiler is 10. Factor of evaporation is 1.05. If the…

Q: The actual specific evaporation of a certain boiler is 10. Factor of evaporation is 1.05. If the…

Q: 250 degrees saturated steam enters a steam coil. The steam is condensed in the coil, leaving as a…

Q: Find the properties of air at a dry bulb temperature of 35OC and a wet bulb temperature of 21OC.…

A: Given Dry bulb temperature = 35oC Wet-bulb temperature = 21oC Find Properties of air

Q: Question. A boiler unit has forced draught fan maintaining draught of 90 mm of water column while…

A: Data given- V• = 38 m3 /s A = 1.9 m2 Ta = 300 K Tga = 450 K η = 0.80

Q: combustion chamber consists of combustion pipes with a diameter of 15 cm. Compressed air enters the…

Q: How much air is used per kg of coal burnt in a boiler having a chimney of 31.1 m height to create a…

A: When the pressure difference in a certain region falls below the atmospheric pressure value, a…

Q: 11. A diatomic gas (y 1'4) does 200 J of work when it is expanded isobarically. Find the heat given…

A: Data given - Diatomic gas Y = 1.4 W = 200 J Isobarically

Q: If the coefficient of performance of a refrigerator is 4 and operates at the room temperature (350…

A: Given Data⇒ Coefficient of performance of refrigerator is COP=4 It operates at room temperature…

Q: For Problem 2, What is the temperature at core turbine outlet? * The power produced by the core…

A: We have given

Q: A large heat pump cools the river with a temperature of 223.15 K and flow of 10 m³/s by 3.0 K. The…

Q: A steam turbine of a local power plant is sup condensate exits the turbine as saturated va from the…

A: Find the enthply at both states as follows.

Q: at 30°C and 101 kPa is drawn th ith throat area 0.025 m² and exi ge vacuum tank. Determine the

A: Given: po=101kPaTo=30oC

Q: A refrigeration system is used to cool water in the evaporator at 5 kg/s of water from 30 °C to ice.…

A: Given data: The mass flow rate, m˙=5 kg/s. The inlet temperature, T1=30°C. The water is converted…

Q: + For a collector with FR(ta)= 0.82 and FRUL = 6.05 W/m2-°C, find the instantaneous efficiency when…

Q: the efficiency is

A: Given; In order to test the efficiency of reducer gear train, input is given as, 1 kWAt the end of…

Q: Pls. Answer thank you! Water at 55°C is cooled in a cooling tower which has an efficiency of 65%.…

Q: 12kN 30° 7kN

A: For solution refer below images.

Q: Steam expands steadily at a constant temperature. The flow rate is 13.6 kg/min with an inlet state…

A: It is given the question that the steam expands isothermally, thus the graph on the process on T-s…

Q: Design a cooling tower for range of 8 degree celcius You can also assume missing values

Q: Q.3//A// Find the sensible heat ratio, if the latent heat in a room is 25% of the sensible heat…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find all properties for air water system if you know that the wet bulb temperature and dry bulb…

Q: A rocket motor with chamber pressure and temperature of 2.04 MPa, 2200 K, operates at sea level…

A: The answer is given below

Q: In Bilecik province, how many square meters should the surface area be minimum so that a planar type…

A: efficiency =55%volume =250 lit/day =0.25 m3/dayρw=1000kg/m3cpwater=4.184 kJ/kgtemp. of collector…

Q: Given the absolute pressure of 11.45 bars a. Find the saturation temperature b. Specific enthalpy of…

A: From steam table calculator

Q: am end. At a certair hrough diffuser is obse ter and is found to in lit(con Estimate the I

Q: An office to be air conditioned for 50 staff when the outdoor conditions are 30°c DBT and 75% RH if…

A: Given Data The number of persons are: 50 The outdoor temperature is: tdt=30°C The inlet temperature…

Q: The return air temperature of the room is 78F and cooling system load is 48,000 Btu h (sensible).…

Q: for a nozzle with a heat loss (Qout) why is Qin neglected?

A: For a nozzle with Qout (heat loss) , Qin is neglected because the value of Qin is very small…

Q: Find the limit using L'Hopital's Rule

A: limx→∞xe1/x-2x=limx→∞e1/x-21x 0/0 indeterminate form Using L'Hopital's Rule…

Q: under hea sity (p) flows through a n expression of the turl

A: given:

Q: b) Elaborate the response of pressure to the reservoir fluid properties using suitable equation.

A: Introduction: Fluid properties in a reservoir may be vary from space to space and from time to time.…

Q: Q11 (connected to Q10) The water tank has m-100 kg, and it gets Q,- 20 kcal/min solar heat per…

A: Given that, Mass of the water tank, m=100 kg,Solar heat per minute, Qs=50 kcal/min,Heat from heater…

Q: An accumulator tank has a capacity of 20MWh. The flow temperature is 110 ° C and the return is 40 °…

A: Given data, Storage capacity of the accumulator, SC = 20 MWh SC = 20×106×3600 J Inlet temperature,…

Q: A Carnot engine requires 35KJ/sec from the hot source. The engine produces 15 KW of power and the…

A: Given data: The heat required for the hot source is Qh=35 KJs=35 KW The power produces by the engine…

Q: Using Veetor Aualysis, find angulac velacity and anguler accelration of CB anól AB 37.8 in given…

A: given; velocity at C (Vc)=5m/sBC=11in =0.2794mangular velocity of CB (ω1)=?angular acceleration…

Q: Derive expression derivation of below question: (a) Using debyes approximation find the heat…

A: The Debye model is a method developed by Peter Debye in 1912 for estimating the phonon contribution…

Q: The percent rating of water tube boiler is 200%, factor of evaporation of 1.08 and heating surface…

Q: D eriye an expression for thermal efficiency of Brayton сycle,

A: The answer is given below

Q: 2- The sensible heat gain of a given space is 50 kW and its latent load is 15 kW. The inside design…

Q: How many stages of compression are required to produce a pressure ratio of stages of AT, = 50°C…

A: Givenrp=24∆Tt=50°Cec=0.9

Q: e natural frequency of the

A: Givensystem as sshown below

Question

If the cooling tower range and approach are 10 and 15 degrees centigrade respectively, find the cooling tower effectiveness.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

I need answer of this Problem ASAP but don't copy the other solution.
Concept related to the Joule Thomson effect. Handwritten solution allowed.
A cylindrical tank 3 m long and 2 m diameter is used for oil storage. How many days can the tank supply the engine having 27oAPI with fuel consumption of 65 kg/hr?
Find the limit using L'Hopital's Rule
The pressure of the air in a starting air vessel is 40 bar and the temp is 24 deg C. If a fire in the vicinity causes the temperature to rise to 65 deg C, find the pressure of the air. Neglect any increase in volume of the vessel.
Please show the complete solution. (Example: Conversion of Units) If the energy efficiency ratio of the refrigeration system is 12.6, what is the COP of the system?
Find logarithmic mean temperature difference ?
. 10kg/sec of steam enters a condenser with enthalpy of 2300kJ/kg and velocity of 350m/s , the condensate leaves the condenser with enthalpy of 220kJ/kg and a velocity of 70m/s find the heat transfer to the coolingwater in ton/h.
The evaporator of a refrigeration system is to be maintained at-12°C.If degree superheat is 7℃, find the temperature of refrigerant entering the compressor.
1- what's is the main benefit for the cooling tower packages . 2- compare the value of heat that rejected from water with the heat adding to the air and explain the Couse of difference . 3- make a search about cooling tower deals with the following items , a) the kind of cooling tower ., b) the problems that resisted the work of the cooling tower . c) define the approach and pointed the condition that deepened on .
5. a) Using the Euler whirl equation, find the power transfer between a throughput of 100kg/s of air and a rotor where impeller speed in constant at 300m/s and the change in whirl velocity of the air is 150m/s. b) If this impeller is a compressor, producing isentropic compression, find the exit pressure and temperature of air taken in at sea level standard conditions.
Two Carnot engines work in series between source and sink temperature of 04 1200K and 300K. Find out the intermediate temperature if 1) Both engines having same efficiency 2) Both engines develop equal power.