If the density of sea water is approximated by the equation of state p = p. exp[(p − Patm)/B], where ß is the compressibility, determine the pressure and density at a point 32,000 ft below the surface of the sea. Assume ß = 30,000 psi.

Q: 4. What is the normality of a solution containing 8.5 g of H2SO4 (MW-98.08) to make 500 ml solution?

A: Mass of H2SO4 = 8.5 g Molecular Weight of H2SO4 = 98.08  The volume of Solution =500 ml = 0.5 L…

Q: 2. At 80°F, we mix 10 lb of sulfuric acid with 20 lb of water. What is the resulting heat of mixing…

A:

Q: Ethane (C2H6) is burned with atmospheric air, and the volumetricanalysis of the dry products of…

A: Given, the dry products contains 10% CO2, 1% CO, 3% O2 and 86% N2. Assume the moles of dry products…

Q: Wet coal is dried in a continuous rotary dryer that operates at atmospheric pressure. The chips with…

A: Introduction  Dryer is used in the drying process to take the water out of a solution, suspension,…

Q: Find the specific gravity of kerosene having a specific gravity of 450 API.

A: Write the relation between the specific gravity and API gravity as follows: API = 141.5SG-131.5…

Q: Example: Oil at 20°C (r 5 888 kg/m3 and m 5 0.800 kg/ms) is flowing steadily through a 5-cm-diameter…

A:

Q: Predict the major product of the following reaction. ? 1) MeMgBr 2) H3O+

A:

Q: A nitrogen gas has a molar volume 0.8L at 281K and 30atm. What is the z factor? Please write your…

A: Z factor is defined as the ratio of molar volume of a gas to the molar volume of an ideal gas. The…

Q: 4. A soil contains 3,500 ppm of available Ca²+. Use this information to calculate the following: a.…

A:

Q: Give the major product(s) of the following reactio NaCN ㅁ H CN OH Br OH OH Br OH CN

A:

Q: phase diagram

A:

Q: The heart is effectively made up of two pumps that create flow through the human circulatory system…

A: Introduction  A pump is a tool that moves fluids (drinks or gases), or occasionally slurries, via…

Q: A gas mixture consists of 218mg of ethane, 190 mg of argon and 347 mg of neon. The partial pressure…

A:

Q: What are the independent equations used and the volume of the second

A:

Q: Write the letter that corresponds to the unit processes Unit Process 1. Combustion 2. Neutralization…

A:

Q: A gas whose Cv=1.386 kJ/kg.K and R= 0.485 kJ/Kg.K Determine the MW in kg/kgmol.

A: Given Data  As per the problem , Cv=1.386 KJ/KgKR = 0.485 KJ/KgKTo Find The molecular weight in…

Q: Acidic gases, such as CO₂ and H₂S, must be removed from natural gas prior to use. You want to remove…

A: From the image given, the value of (1/H) for CH4 at a temperature of 25oC is found to be equal to…

Q: What is the pressure på in the figure? The specific gravity of the oil is 0.8. Air PA Oil H₂O 10'…

A: Given thath1=10 in = 0.254 mh2=1 in = 0.0254 mh3=15 in =0.381  m

Q: 1. Two thousand kilograms of a 94% NaNO3 solution in water is at a temperature of 1000C. This is…

A:

Q: Using the data in the table, determine the rate constant of the reaction and select the appropriate…

A: Given reaction between A and B is A+2B→C+D Also given data between concentration and rate is as…

Q: 3. The volume of a certain liquid varies with temperature as V = V(0.75 +3.9 × 10−4T + 1.48 ×…

A:

Q: An evaporative Crystallization Process The flow-chart of a steady-state process to recover…

A:

Q: If moist hydrogen containing 8% water by volume is burnt completely with 34% excess air, calculate…

A: Given that moist hydrogen containing 8% water is burnt entirely with 34% excess air, the reaction is…

Q: Please draw the block diagram of the problem

A: Block diagram of the problem is to be drawn.

Q: (Calculation of average velocities) (chemical engineering ) A gas mixture ( N_{2} =5% H_{2} =15% .…

A: Solution: Given data; N2=5%, H2=15%, NH3=76%, Ar=4%, flows through pipe diameter D=25.4 mm at 4.05…

Q: the cell: pt / H₂ (latim) / NaOH cm) / HgO cs) / Hg = 0.924V 0.854 V and Егадк Calculate standard…

A:

Q: CO₂ is sold commercially in steel containers at 60 bar. The gas is leaking through the outlet valve…

A: Introduction Ideal gas equation In this equation, P refers back to the pressure of the proper gas, V…

Q: Chemical engineering exercise 2.1  Estimate the heat loss per m² of surface area for a furnace wall,…

A:

Q: Given the following reaction: 24+6B →2C+6D ,if 5 moles of A and 10 moles of B enter the reactor,…

A: Given reaction is: 2A + 6B →2C + 6D Given data are: Initial number of moles of A = 5 moles Initial…

Q: A fuel gas mixture of 10500 lbmol/hr 35 mol% ethane, 25 mol% propane, and the balance butane is fed…

A: Given, The molar feed rate of fuel, n = 10500 lbmol/hr The mole % of the components in the feed are…

Q: 1.31 Refrigerant 22 vapor enters the compressor of a refrigera- tion system at an absolute pressure…

A: Absolute pressure of system = 0.1379 MPa Pressure at exit in gage = 1.93 MPa Atmospheric pressure =…

Q: Calculate the enthalpy change to take liquid water from 100 kPa and 25 °C to superheated steam at…

A: It is given that liquid water initially at 100kPa and 25oC is changed to superheated steam at 100kPa…

Q: 1.a Carefully sketch and label the [012] and [201] directions below (You can increase the size of…

A:

Q: Consider the equilibrium reaction H2O H2 + 0.5 O2, at 1 atm and 298K. The mass fractions of H2O. H2…

A:

Q: The critical temperature of gas TOS is -52 deg Celsius. If the value of its Van der Waals constant b…

A: Critical temperature of gas = -52 0C Van der Waals constant, b = 1.1 × 10–5 m3/n

Q: B) A piston cylinder arrangement has a gas in the cylinder space. During a constant pressure…

A: Given Data  It is given that the piston-cylinder assembly  has  gas  in the cylinder space  The…

Q: Steam, initially at 700 lbf/in.2, 550°F undergoes a polytropic process in a piston-cylinder assembly…

A: Given thatPi  = 700 lbfin2Ti  =550  FPf  = 3600 lbfin2n =1.5

Q: Chemical compounds composed of carbon and hydrogen atoms bonded to one of the inorganic atoms are…

A: ASKED Chemical compounds composed of carbon and hydrogen atoms bonded to one of the inorganic atoms…

Q: Condensation of Steam on Vertical Tubes. Steam at 1 atm pressure abs and 100°C is condensing on a…

A: The average film temperature is, Tf = 100+97.782Tf = 98.89oC The average heat transfer coefficient…

Q: A N2-acetone gas mixture consist of 20% acetone and 80% N2. The mixture is made by bubbling dry N2…

A:

Q: Hello sir I study in chemical engineering 3rd sem please help to understand my class exercise  A…

A: Mach number is ratio of speed of object to that of sound. If mach number> 1 supersonic. =1 sonic…

Q: Heat Loss by Convection and Conduction. A glass window with an area of 0.557 m² is installed in the…

A: The schematic representation of the given problem is as follows:

Q: Consider 2 kg of air has a decrease of internal energy of 25 kJ during a reversible non flow…

A:

Q: A mixture of dichloromethane (1) and ethyl acetate (2) and is separated in a flash drum at 1 bar. a)…

A: A mixture of dichloromethane and ethyl acetate (2) is flashed vaporized.

Q: Predict the value of DAB for the system CO-CO₂ at 296.1K and 1.0 atm total pressure.

A:

Q: For the circuit below : RL =) Determine the range of R₂ and I that will result in VR being…

A:

Q: The reactor operates with an incoming RF flowrate of 20,500 lbmol/hr. There is a 50% excess air in…

A:

Q: calculate the thinning rate of an anode (zinc is 0.4 mg/C and density of zinc is 8 g/cm^3)

A: Given data are as follows: Density of zinc = 8g/cm3. Amount of zinc per coulomb = 0.4mg/C

Q: Which of the following is sulphur compound.

A:

Q: What is the pH of the solution if 100.0 ml of 0.100 M HCl is titrated with 99.9 ml of 0.100 M KOH?

A: Given that- Volume of HCl (strong acid)=100 mL= 0.1 L Concentration of HCl= 0.100 M Volume of KOH…