If the flow rate through a 10 cm diameter wrought iron pipe is 0.04 m3/s, and the difference in elevation H of the two reservoirs is 77. Calculate the power of the pump. Assume the pump efficiency is 85%.

Q: EL.90m Goonm-p EL. 30M 1200m A

A:

Q: Considering the figure to the right with flow from A to D, compute the total head loss from A to D…

A: Using the Darcy Weisbach equation: Hf=flv22gd   =flQ212.1d5 Hf2=Hf3flQ212.1d52=flQ212.1d53…

Q: Reservoir B Z8 = 9 m

A: Given:- Water at 20o celsius to be pumped from a reservoirZA=2 mZB=9 mLength of pipes=25 mDiamter of…

Q: The Metro Manila Waterworks System design the pip by using a 300 mm diameter pipeleins made of…

A: Q = 60 l/sμ = 1×10-3 Ns/m2d = 300 mmf = 0.035Vavg = QA = 0.060.25π0.32 = 0.848 m/sRe = ρVDμ =…

Q: Question: A stream with a flow rate of Q = 8 m3 /s is passed through the turbine by means of a…

A: Solution: Given Data: Q=8 m3/s V1=4 m/s V2=1 m/s

Q: A centrifugal pump is to be operated with discharge 2.5 m3/min. If the power of motor is 15…

A:

Q: Two reservoirs (EI 37.6m and EI 91.6m) are connected by two pipelines 1-2 and 2-3 with a pump…

A:

Q: What is the critical depth in a rectangular channel with 2.3 m width and 0.91 m2/s discharge per…

A: What is the critical depth in a rectangular channel and calculate minimum specific energy?

Q: QI:Fig. shows a pump drawing a solution (specific gravity =1.8) from a storage tank through an 8 cm…

A: For the given pump,

Q: An 8hp pump is installed near the reservoir container of oil having a s.g. Of 0.82. The rate of flow…

A:

Q: Q5/ The depth of water before the hydraulic jump is 2.5 m and the velocity is 5 m/sec. Determine the…

A:

Q: A pump is delivering water at atmospheric pressure to an elevation of 400 m. Elevation of the pump…

A:

Q: Water flows from reservoir A through a turbine and discharges to B through a 24 in diameter pipe.…

A:

Q: A pump draws water from reservoir A and lifts to reservoir B. Points 1 and 2 are points just before…

A: Given, Discharge, say Q = 15 L/s = 0.015 m3/s [1 m3 = 1000 L] Diameter of pipe at 1, D1 = 150 mm =…

Q: Compute the specific speed for a pump operating at 4000 rpm delivering 600 gal/minof water at a…

A:

Q: A centrifugal pump discharging 900 gpm and operates at 1800 rpm against a head of 120 feet has a…

A:

Q: Reservoirs A and B have elevations 250 m and 100 m, respectively, and are connected by a pipe having…

A: Q=140L/s To find power generated by turbine

Q: The performance data of a water pump follow the curve fit Havailable = HO = aV^2, where the pump's…

A:

Q: An 18-inch-diameter (~46 cm) well within an aquifer with a transmissivity of 1070 ft2/day (~100…

A: Using relation:S=Q4πTln2.25Ttr2ss=20ftT=1070ft2d

Q: Compute the power input of the pump

A:

Q: It is proposed to build a three- stage centrifugal pump to deliver 4000 kg/min of water at a speed…

A: Given; Total manometric head=70m α=90°β=45°ηm=84%η0=0.75k=0.92Vf1=Vf2=2.5m/s Consider the free body…

Q: c) A pumping plant forces water through a 600 mm diameter main, the friction head being 27 m. In…

A: given Diameter of pipe= 600 m = 0.6 m head loss = hf = 27 m

Q: Consider a single acting triplex pump having 7-in. liners and 12-in. stroke length operating at a…

A: So for calculation of the pump hydraulic horsepower we have to calculate pump factor and pump flow…

Q: Question Water at 15°C is to be discharged from a reservoir at a rate of 18 L/s using two horizontal…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…

Q: Water is pumped at the rate of 20 m3/s from the reservoir located at elevation 100 m and out through…

A: Given data: Flow rate Q = 20 m3 /s  Reservoir 1 height = 100 m Reservoir 2  height = 140 m Pump is…

Q: 3 Consider a horizontal 4-ft-diameter galvanized-iron pipe simulating the Alaska Pipeline. The oil…

A: Given that :

Q: A water tube steam generator operating at 180 bar has 15 m high and 7.5 cm in ID tubes. The pressure…

A: Given data- Operating pressure (P)=180 bar Height (H) = 15 m Diameter (D) =7.5 cm Drop-in pressure…

Q: A rectangular channel (n=0.011) 18 m wide to carry water at a flow rate of 35 m³/s. The slipe of the…

A: Given data in question  Constant value Width Discharge  Slope To find out Critical depth Specific…

Q: For the piping system shown below, determine the flow distribution and the piezometric heads at the…

A:

Q: A motor-driven centrifugal pump delivers 15°C water at the rate of 10 m³/min from a reservoir,…

A: T = Temperature of water = 15°CQ = Rate of flow = 10 m3/min = 1060 = 0.1667 m3/secL = Length of pipe…

Q: What is the required pump power (Pa) for the system below?

A:

Q: Using the pump selection table below to determine the best pump for the given condition: Imp.gpm • A…

A: Following is required answer :

Q: Calculate the required pipe diameter to avoid cavitation, if the pump delivers Q = 30US gallon/min…

A:

Q: The parallel galvanized-iron pipe system delivers water with a total flow rate of 0.036 m3/s. If the…

A: To find discharge in pipe 1 and 2

Q: For the piping system shown below, determine the flow distribution and the piezometric heads at the…

A: We have to find the value of flow distribution and the piezometric head at the junction j according…

Q: Problem 3 Water (60°F) is pumped from a reservoir to a large, pressurized tank as shown. The steel…

A: Solution; Given data; Reynold's numbers, Re=V*dν at 60°F,   ν=1.21*10*5 ft2/s Q=1=AV

Q: hydraulic pump increases the pressure in a system from 500 kPa to 3 MPa at a flow rate of 2 e/s. The…

A:

Q: 6. A pump is connected to a rising main with a diameter of 0.35m and length of 400m. The rising main…

A: Given, D = 0.35 m L = 400 m  λ = 0.01

Q: Two reservoirs A and B have elevations of 250m and 100m respectively. It is connected by a pipe…

A: Given data in question  Elevations  Discharge  Diameter  Length Constant value To find out  Power of…

Q: A pump is installed to deliver water from a reservoir of surface elevation zero to another of…

A:

Q: A pump is used to raised water to a reservoir through 800 m. long of 20 cm diameter with Cw of…

A:

Q: Water from a reservoir is pumped over a hill through a pipe 90 cm in diameter, and a pressure of 200…

A: Given: The diameter of the pipe is 90 cm. The pressure is 200 KPa. The height of the summit is 90 m.…

Q: A 600 mm diameter pipe 900 m. long connected in series to a 40 cm diameter pipe, 625 m long is to…

A: Compute for the discharge. Determine the power available in the jet of the nozzle. What will be the…

Q: A pump can lift water to a head of 25 m with a flow of 0.15 m³/s. The critical cavitation number is…

A: Answer We are given Pump Head = 25 m Flow rate = 0.15 m3/s Critical cavitation number = 0.144 Vapor…

Q: ... Elevation 90m 150mm diameter 100mm diameter Elevation 10m P A pump draws water from reservoir A…

A:

Q: A Francis turbine with internal and external runner diameters are 0.5 m and 1.0 m, and its inlet…

A:

Q: Oil with sp. gr. of 0.87 is being pumped from a lower reservoir to an elevated tank as shown. The…

A: Apply Bernoullis theorem…

Q: Q)Pipes 1, 2, and 3 are parallel with each other as shown.If the energy at the inflow pipe A is 132…

A:

Components of Hydroelectric Power Plant

A hydro electric power plant derives the energy from the force of fast moving water to harness energy. The demand for energy needs has impacted the environment resulting in global warming. Extensive use of non-renewable energy sources like petrol and diesel is the primary reason for environmental pollution. A major shift from non-renewable energy sources to renewable energy sources is the only solution to encounter the rising issue of environmental damage.