If the imaginary part of the roots is twice the real part of the roots in a certain control system, find the rise time when the natural undamped frequency of the system is 0.5 rad/sec Select one: O a. 4.549 sec b. 10.549 sec C. 2.549 sec d. 3.549 sec e. 6.549 sec

If the imaginary part of the roots is twice the real part of the roots in a certain control system, find the rise time when the natural undamped frequency of the system is 0.5 rad/sec Select one: O a. 4.549 sec b. 10.549 sec C. 2.549 sec d. 3.549 sec e. 6.549 sec

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 5. A timing diagram below shows a D Flip-flop and the input clock. Show the transition of the output…

A: Writing the characteristic table of D-FF. DQnQn+1000010101111 It could be concluded from the…

Q: CREATE A WINDING TABLE, WINDING DIAGRAM, AND WINDING PLATE: (4 poles, 26 conductors, double…

A: 4 poles,, 26 conductors, double layer, simplex WAVE winding

Q: (b) Describe the definition of open loop and closed loop system.

A: In control systems generally there are two types of systems a. Open loop control system b. Close…

Q: G, R(s) C(s) G2 H2 H1 Figure Q3

A: For the given block diagram, the closed loop transfer function is calculated by using block…

Q: Using the Right-Hand Rule, determine the direction of the magnetic force on a negative charge moving…

Q: 3. Determine the current I and its direction for the network of Fig.P3. + 32 V- 20 v 4.70 5.60

A: Given circuit:

Q: A 50kVA, 550V single phase alternator draws a field current 10A at rated load. With the same field…

A: Definition: measured the voltage across the terminal. when there is no load to connected the…

Q: A four-pole, three phase, 50Hz, star connected AC generator has 24 stator slots. There are 6…

Q: Design a collector-feedback circuit using with Vcc = 5 V, Ic = 10 mA, and VCE =1.5 V. %3D

A: The design-based problem may have multiple answers. It varies based on designers and their…

Q: Find the ratio of permeability of the two media when the wave is incident on the boundary at 90…

Q: Capacitor of 30 microfarad capacitance is in series with a coil with 8000 cycle supply. what…

Q: False statement of Generators А. Consists of two rotating part of stator and rotor В. Convert…

Q: H.W 1-Find the autocorrelation of the following signal g(1) = e-a u(1), a>0. ||

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Please answer a, b, c, d in Q3. Thanks! Q1. An electro-magnet draws 3 kW of active power and 3 kvar…

A: The solution is given below

Q: please draw in paper The band stop filter block diagram

Q: 1. Same figure, solve the loop and branch currents using Maxwell's theorem.

Q: 2ms 2ms 5v - OV 5

Q: Solve the power triangle at Z6 in the circuit diagram below.

Q: 2. Given: R1 R2 1KO 1kQ V2 V1 R3 1KO. = 12V 12V Find the equation assume loopA and loop B using…

Q: An AC current has an rms value of 3.8 A. Determine the peak value of the current (in A).

Q: the current flow (a) in the collector and (b) in the emitter if the base current is 5mA

Q: Given a[n] = 6[n] + 28[n – 1] – d[n – 3], and h[n] = 26[n + 1] + 28[n – 1], compute (a) y[r] = r[n]…

A: We need to find output sequence for given input and impulse sequence .

Q: Example 5 (a) Determine ICQ, VCEQ, and IBQ for the network using the approximate approach even…

A: The Q point parameters for voltage divider biased CE amplifier circuit can be obtained by using the…

Q: 16/For the circuit of Fig. 4-25 calculate (a) the currents delivered by generators 1 and 2, (b) the…

Q: Question Completion Status: shown below. b. Use Karnaugh maps to simplify the following Boolean…

A: Solve the first question, unless the student has asked for a specific question to be solved, subject…

Q: QUESTION 5 All magnets have O flux lines O a magnetic field O north and south poles O all the above

A: Magnet : A magnetic is a metallic device which has two poles that are north and south pole like pole…

Q: Find the electric field when the magnetic field is given by 2cos t in air. Your answer…

Q: The total capacitance in this circuit is

A: The given circuit is shown below:

Q: The current element of the magnetic vector potential for volume current will be Your answer

Q: (b) Elaborate on the factors that need to be considered when choosing a suitable instrument of…

A: The measuring instrument helps a user measure the given variable quantity easily with help of…

Q: a pure inductance of 100mH is connected in parallel to a 25µF capacitor. The network is connected to…

A: It is given that: L=100 mH=100×10-3 HC=25 μF=25×10-6 FVs=200 Vf=60 Hz

Q: k → x M F

A: We need to find transfer function for given system .

Q: R1 1KN 13 R2 1.5k2 30V 15V R3 2.2KN

Q: HW1/ Consider the unity-feedback system with the open loop transfer function: G(s) = s+5 Obtain the…

A: As per guidelines given to us ,we can only provide the solution of first question in multiple type…

Q: 9. if C(s) ,the form of response will be %3D s(s²+4s+3) c(t) = (Write in A, B,C for residues) 10. o…

Q: Q4: From the collector characteristic curves and the dc load line when ßDC is 100 and alpha = 0.95 ,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: QUESTION 12 Which has the shortest wavelength? O 10 Hz O 100 Hz 10kHz O 100 kHz QUESTION 13

Q: = 600-90 and la The currents of 3-phase system are la0 = 350-90, Ia1 50-90. Compute the…

Q: For the circuit shown ,if the switch on at t=0, determine Vr, ir and vz as a function of time Ro

A: This circuit has a switch and is opened for a long time. It will close at time t=0. a) t=0, (t<0)…

Q: 1 / 1 100% 1. The total charge entering a terminal is given by q 2e" cos (6rt), in uC. Determine the…

A: The solution is given below

Q: The current through a 120 mH coil is changing at a rate of 150 mA/s. The voltage induced across the…

A: Given, Inductance, L= 120 mH Current changing at a rate, didt=150 mAs

Q: (a) IB, IE, and IC. (b) VCE, VBE, and VCE. (c) adc (d) Is the transistor in saturation, linear, or…

A: The required parameters can be calculated by using the DC analysis of the amplifier circuit.

Q: Determine the instantaneous voltage of an ac generator, where the maximum voltage is 208 V, and the…

A: Given: Maximum voltage, Vm=208 V Angle, θ=ωt=40°

Q: 4. Using the Voltage-Divider-Rule, find the value of resistance R for the network of Fig. P4. 2.2 kn…

A: Given:

Q: Determine the thermal coefficient of resistance of copper at 50°C, then use this value to determine…

Q: How about the d and e

A: The mechanical power generated in the armature is Pmech=Eb·Ia,Pmech=491×18Pmech=8838 W.

Q: Which formula is used to calculate the RMS voltage os a sine wave? O 0.707 x peak 0.637 x peak O…

Q: Q.2 Explain the principle of work to these two sensors and draw the sensor's pinout configuration 1.…

A: 1. Passive Infrared Sensor Unlike any other sensors passive infrared sensors doesn't work or detect…

Q: Q.3 For Resistance temperature detectors (RTDS) I) What's the principle of operation for Resistance…

Q: The task is to draw or illustrate the armature winding, using the description below: -4…

A: 4 poles -26 conductors -double layer -simplex wave winding

Question

i need the answer quickly

If the imaginary part of the roots is twice the real part of the roots in a certain control system, find the
rise time when the natural undamped frequency of the system is 0.5 rad/sec
Select one:
a. 4.549 sec
b. 10.549 sec
C. 2.549 sec
d. 3.549 sec
e. 6.549 sec

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

after using thevenin's theorem choose the value at R and L so that the average power at R becomes maximum. if a current source with w=1000rad/s, and (A=5), and(0,B=0,4)
10.1 Sketch and fully label the impedance diagram (also show the exact value for the magnitude and phase angle of Zt) for the following expression: Zt = 20 – j455 ohm.
With respect to frequency response, output of a system will differ from the input in both magnitude and phase angel. Select one: True False
The power factor of a network is defined as the ______ of the voltage across the network and the current that it draws. A. phase angle difference B. cosine of the phase angle difference
In the circuit shown below, when the supply angular frequency ω doubles the source current Is drops by a factor of 0.7071. Find ω
Which of the following information cannot be obtained from the wind rose? a. Wind speed b. Wind power c. Wind direction d. Frequency distribution
Consider an LTI system with frequency response H(ejw) as given below H(ejw) = (1-e –j2w)/(1+1/2e –j4w) Find y[n] for x[n]= sin(πn/2+π/4).
Determine the impedance, admittance, and if the network is resistive, inductive, or capacitive. Consider that the networks are operating at 60Hz frequency.
find the impedance ZL for maximum average power transfer
RF Electromagnetics: Suppose that you have a transmission line where Z1 = 100 ohms and the load impedance is 50 + 60j. Create an LC matching network between the transmission line where Z1 = 100 ohms and the load impedance. Verify that the impedance is matched by calculating row = (Z_L - Zo)/(Z_L + Zo). The frequency is 500 MHz
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the angular frequency of the ac source? What is the circuit impedance? What is the power factor? What is the real power of the circuit?
determine rab.