If the overall heat transfer coefficient in question 3 above is 27 W/m²-K find the heat loss per square meter in 1 hours given that the temperature of the hot oil is 92 °C and the outside temperature is 36 °C.

Q: A liquid N2 (LN2) dewar typically has a pressure regulator that helps prevent it from rupturing when…

A: It is given that liquid N2 is stored in spherical dewar. Given data are as follows: Radius of dewar…

Q: A tube 93 mm outer diameter is insulated with a layer of silica foam 38 mm thick of conductivity…

A:

Q: 5) The insulated vessel shown below has two compartments separated by a membrane. On one side is 1…

A:

Q: (a) The amount of water evaporated from the cake is _____ kg.

A: The amount of salt in the filtrate is calculated in kilograms. Wet filtrate cake mass is calculated.…

Q: = heat transfer rate from the compressor in kW

A:

Q: Typically, more frequent measurements are taken at the start of the pharmacokinetic process, where…

A:

Q: For a specific type of cell after 3 hours, the concentration of cells per milliliter of solution is…

A:

Q: 5.16. In the tank in Fig. 5.24 water is under a layer of compressed air, which is at a pressure of…

A: Velocity of water at the exit is to be calculated.

Q: A polluted air stream is saturated with benzene vapor initially at 33°C and 1 atm. To reduce the…

A: Given that- Initial temperature, Ti=330C Final temperature, T2= 330C (constant)  Initial Pressure,…

Q: 20. A continuous, horizontal tube evaporator is fed with a 5% caustic soda solution and the product…

A: Given that, The mass flow rate of caustic soda solution (dilute water) = 100 lb/hr The mass fraction…

Q: heat is discarded to the river at rated power

A:

Q: d.) Starting with 100 kg of the solution containing 93% H2SO4. what equation correspond to HNO3…

A: A usable product is formed by the addition of three different streams.

Q: Under constant pressure P = 1 atm an ideal gas of 1.5 mol undergoes heating from 28°C to 128.0°C,…

A:

Q: Given: Two gray bodies: Body 1 at 200 C and Body 2 at 100 C with emissivity of 0.6 and 0.8…

A: Given that- Body 1 temperature= 2000C = 473K Emissivity, ε= 0.6 Body 2 temperature=1000 C= 373 K…

Q: Water is flowing through a steel pipe having diameter 1 m and water viscosity is 1 Pa s velocity of…

A: Given  Velocity of water in pipe v = 2 m/s Density of water d = 1000 kg/ m3 Diameter of pipe D = 1…

Q: 6.75 For a solution of n-propanol and water, the following partial pressures in kPa are measured at…

A: Vapor pressure and composition of a binary mixture is given.

Q: Ethane (C2H6) in gas phase flows stationary into a straight pipe at 400 K and 6 MPa. The gas is…

A: Given, The mass flow rate of ethane is, m˙ = 2.5 kg/s The inlet temperature of ethane, T1 = 400 K…

Q: What does the Brix (%) represent in terms of filtered juice? What is a refractometer and how does it…

A: 1) The degree Brix (oBx) is the commonly used scale used for the measurement of dissolved or soluble…

Q: Diesel truck exhaust is typically >200 deg. C and contains the following gases, in decreasing order…

A: The exhaust rotates gas between the system and the environment. This system is included to reduce…

Q: Metal powders are blended and mixed in step 1 of a conventional press-and-sinter process in which…

A:

Q: A dilute aqueous slurry containing solids with a diameter of 20 micrometer and SG= 1.5 is fed to a…

A: The flow rate of the centrifuge is obtained from angular velocity, distance to liquid, distance to…

Q: Saturated steam at 267°F is flowing inside a hollow sphere with an ID of 0.824 in. and an OD of 1.05…

A: Refer to the figure shown below based on the given problem statement,

Q: 3. In the steady-state process shown in the following figure, an ideal gas flows through a porous…

A: An ideal gas is sent through a porous plug in which it expands freely. This is related to the Joule…

Q: 3. For the control loop shown below, what is the correct P-only (proportional only) controller…

A:

Q: A 0.81 L glass vessel is to contain 2.70 g of CO2. The vessel can withstand a pressure of only 18.17…

A: Givenmass of CO2 in glass vessel=2.7 gvolume of glass vessel=0.81 Lmaximum permissible pressure in…

Q: 18. Stainless steel can resist corrosion, it is made by adding 10.5% of A. C 19. B. Cr C. Zn D. Ni…

A: Chromium 10.5% is added to resist corrosion. Due to addition of chromium passive layer forms and it…

Q: What mass flow rate of NH3 in lbm/h is required to produce 2190 lbm of NO per day? (Assume that the…

A:

Q: Propionaldehyde decomposes to form carbon monoxide when irradiated with a light of wavelength 3020…

A:

Q: 2. Consider this item as REAL gases: Two hundred and fifty pounds of a mixture of 6.63.% propane…

A: Given, The mass flow rate of the gas mixture,  m = 250lbhr×453.592 g1 lb×1 hr3600 s= 31.5 g/s   The…

Q: Hot water (cph = 4188 J/kg*K) with mass flow rate of 2.5 kg/s at 100 deg C enters a thin- walled…

A:

Q: 1. A rigid tank of volume 0.5 m³ is connected to a piston-cylinder assembly by a valve as shown…

A:

Q: A certain coal is pulverized and burnt in a burner. Analysis of coal showed 70% C, 10.7% ash and…

A:

Q: The specific gravity of white petrolatum is 0.850. Find the weight of this substance needed to fill…

A:

Q: When methane combusts in the presence of oxygen, the following two reactions are possible. CH4 +20₂…

A: Given data: Initial number of moles of CH4 = 10 mol Number of moles of CH4 in the product stream = 2…

Q: 3. Sea water is to be desalinized by reverse osmosis (RO) using the process shown in Figure 1. The…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: What does the concept behind the graph wherein the two points of the line meets at the two end.…

A: Temperature, composition of a binary mixture is given.

Q: 23. For liquid acetone at 20° C and 1 bar, the volume expansivity B is 1.49 x 10-3 °C-1 and the…

A: Given  Volume expansivty  β  = 1.49×10-3 Isothermal compressibility k = 62×10-6 T1 = 20oC T2 = 40 oC…

Q: The specific gravity of white petrolatum is 0.850. Find the weight of this substance needed to fill…

A:

Q: A gas cylinder with a volume of 2.50 m³ contains 1.00 kmol of carbon dioxide at T = 300 K. Use the…

A:

Q: A piston-cylinder assembly contains 5 kg of steam at a pressure of 100 bar and a temperature of 400…

A: Mass balance is applied to a closed system. The First law of thermodynamics is applied. The initial…

Q: 4. The right figure shows a simple combustion calorimeter. The sample is ignited electrically. After…

A: The water and the calorimeter each gained energy from the combustion. We will find out how much…

Q: Convert 0.002 kg/ms to lbm ft s

A:

Q: The lowest temperature at which auto-ignition of the joil vapor occurs above the heated oil sample…

A: Cloud point is the temperature at which the solution forms an emulsion by liquid-liquid phase…

Q: A slice of Ampalaya cake is removed from an oven at 210 °F and left to cool at room temperature,…

A: Write the expression for Newton's law of cooling as follows: Tt-TsT0-Ts = e-kt      ......1   Here,…

Q: average molecular weight

A:

Q: Determine the fugacity of liquid water at 30° C and at the saturation pressure, 10 bar, and 100 bar.

A:

Q: a generic civilian Air Car - a type in this case has an assumed weight of 36287.4 kilos. It is…

A: It is given that weight of hovercar is 36287.4Kg. Hovercar is designed to lift one meter off. It is…

Q: Mass Transfer Coefficient

A:

Q: Make a McCabe-Thiele diagram and use it to distil a binary feed.

A: The McCabe-Thiele diagram is basically a graphical method of designing distillation which was used…

Q: The pressure in a car tire depends on the air temperature in the tyre. At 25°C air temperature, a…

A: Given: Initial temperature is 25°C Initial pressure is 210 kPa Volume is 25 L Atmospheric air…