If the temperature is increased by 3 degrees Celsius then efficiency of power output in solar PV system will O a. increase by 3% O b. reduce by 1.5% O c. reduce by 3% O d. increase by 3%

Q: At a temperature of 25°C (common temperature for components in an enclosed operating system),…

A: This problem belong to analog electronics . It is about calculation of thermal voltage at a…

Q: Which among the following statements is incorrect regarding Coal-Based Power Plants? O a. To reduce…

A: To find the correct answer

Q: A student is planning to install a photo-voltaic system in a location where the peak sun hours is 4…

A: given Rated power=200 Welectrical energy =6 KW-hrefficiency=75%

Q: 1. A pump driven by 240V motor lifts 1000 ft / min against a head of 50 m of water. The efficiency…

A: Given pump driven by motor  Voltage v=240 vMotor lifts 1000 ft3/minHead h=50 mThe efficiency of the…

Q: Compare Wind Energy and Solar Energy

A: a) Site requirements: Wind energy: Wind energy systems perform well in plain land states. Solar…

Q: Identify some uses or applications of each Renewable Energy source. Specify also its uses in…

A: Renewable energy  source :  Renewable energy is source of energy which is collected from renewable…

Q: The Thermal Power plant Consumes less amount of fuel when compared to Nuclear Power Plant Select…

A: Coal is used as a fuel in thermal power plants where as uranium is used as fuel in nuclear power…

Q: B// Calculate the average load on a steam power station which spends (47x10°) IDQ (Iraqi Dinar) per…

A: According to question:

Q: In a 100 MW steam power station working at 60% load factor the energy cost is found to be 1.5 baize…

A: Given Installed capacity =100 MW load factor 1 =LF1=60 % load factor 2 =LF2=70 % energy cost =1.5…

Q: Vhich of the following is not a factor which affects solar panel efficiency. O a. Temperature O b.…

A: Given To find which parameter does not effect solar panel efficiency.

Q: (c) Calculate and sketch the power absorbed between 0 and 10 ms. (d) Prove that the electronic…

A:

Q: Calculate the maximum power output of a solar panel whose efficiency is 21 % if the input power is…

A:

Q: 120 V.

A: Given circuit shown

Q: A 75 MW steam power station uses coal of calorific value of 6400 kcal/kg. Thermal efficiency of the…

A: Given data, Capacity of thermal station P = 75 MW, Calorific value = 6400 kcal/kg, Thermal…

Q: what would the demand load be for three 17 kW ranges

A: To calculate the demand factor for three 17 kW ranges.

Q: 96.7% effici

A:

Q: A wind turbine that is 80 meters tall with a blade length of 160 ft will be used to generate…

A: Most of human energy requirement is meet by generating electrical energy. Once electrical energy is…

Q: A laptop is operated for an average of three hours a day, and it remains off but connected to power…

A:

Q: During its use, the temperature of the aluminum wire has increased from room temperature to 80…

A: The temperature of the aluminum wire increased from room temperature to T=80 degree C The…

Q: A power station generate 25 MW wth fuel of 3000 k.calorific/ kwh. The fuel has an calorific value of…

A: Electricity is generated by conventional and renewable energy resources like solar, coal, nuclear,…

Q: Calculate the weight and height required for a gravity light for home use. Assume the bulb wattage…

A:

Q: If the temperature is increased by 3 degrees Celsius then efficiency of power output in solar PV…

A:

Q: What are some of the environmental impacts of the use of geothermal energy sources

A: First and foremost, geothermal power is a source of clean and renewable electricity. No fossil fuels…

Q: 01/ What is the main disadvantage & advantage of the stack as temporary storage

A: Stack over register's drawbacks -The biggest disadvantage is that it is slower than registers due to…

Q: A 316 range voltmeter is having an accuracy of + 0.14% of FSD. Calculate the following for the given…

A: As here Multiple questions are present, So as per the Bartleby guideline I am solving 1,2 & M1…

Q: uestion 5 A natural gas plant with a 50MW operates at an average loading of 75% year round. How…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Linear power warranty refers to the industrial standard of rated power output at a. 10 years at 90%…

A: In this answer let us discuss the linear power warranty concept.

Q: The percentage of overall efficiency of thermal power plant is O +29% O +28% ±30% O +32%

A:

Q: Calculate the percentage efficiency of a solar PV module whose length is 139 cm and width is 117 cm…

A: For the given solar PV module length (l)=139 cm width (w)=117 cm solar irradiance, P/m2=971 W/m2…

Q: Which one is a non-conventional energy: a. Fossil fuel. O b. Municipal solid waste. O c. Heating…

A: Non conventional sources of energy that are  energy sources which are continuously restore by…

Q: 500 MW Medupi power station generates electricity using coals of calorific value of 4890 kcal/kg.…

A: Given power station with Power,P=500 MWCalorific value =4890 kcal/kgElectrical efficiency ηe=87.4…

Q: An electric kettle need 6 minutes to boil 2kg of water from the initial temperature of 20 degrees.…

A: An electric kettle need 6 minutes to boil 2kg of water from the initial temperature of 20 degrees.…

Q: A 60 MW steam power station has a thermal efficiency of 30%. If the coal burnt has a calorific value…

A: Output Power = 60 Mw Efficiency = 30 % Calorific Value = 6950 kcal/kg

Q: 500 MW Medupi power station generates electricity using coals of calorific value of 4890 kcal/kg.…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subparts for…

Q: The equivalent fuel reserve of a certain country for power generation is 3 x 10 6 MW – year. The…

A: It is given that: Equivalent fuel reserve=QT=3×106  MW-year=3×1012  W-yearPresent peak power…

Q: Problem 2- For your home give an estimate electrical energy needed daily, monthly and yearly in kWh…

A: It is given in the question that cost of 1kWh is 80rs that means 1 kW power for one hour gives 80 rs…

Q: one of the following is a disadvantages of the power electronics system. a. installation b.…

A: Power electronics is that branch of electronics where the movement of the charge carriers occurs…

Q: The specific fuel consumption by a thermal power station is 0.75kg/Kwh. The units generated for a…

A: In this question we need to find a fuel consumption per day by station

Q: Given two loads with the following ratings: CRT TV Set: 190 W LCD TV Set: 96 W Compute the monthly…

A: Given data, Rating of CRT TV set is 190 W. Rating of LCD TV is 86 W. Cost is given 11.25 Rs / kWh

Q: steam power station has an overall efficiency of 20% and 0.6 kg of coal is burnt per kWh of…

A:

Q: Determine its efficiency

A:

Q: A 52.12-hp motor that has an efficiency of 93.79% is soon to be obsolete. It will be replaced by a…

A: Input power is given,  Pin=52.12 hp=52.12×0.745 kw=38.82 kw Efficiency of 1st motor is given 93.79 %…

Q: An appliance is used at a time when the voltage is only 210V(peak hour). If the nameplate says that…

A:

Q: A thermal power station has an overall efficiency of 28% and 0.8kg of coal is burnt per kWh of…

A: Calorific value is the amount of heat energy in tha coal in 1 kg of coal. Overall efficiency is the…

Q: An appliance draws 1A of current when plugged to a 220V outlet.  It was further measured that the…

A: In this question we will find power factor of circuit..

Q: Average efficiency of wind energy is usually more than solar energy, but less than bio energy.…

A:

Q: The charge controller protects the batteries from overcharging in the stand-alone system of PV power…

A: Given :    In the above question they are interested to know the work of charge controllers in the…

Q: A wind turbine that is 80 meters tall with a blade length of 160 ft will be used to generate…

A: In the question,  A wind turbine that is 80 meters tall  a blade length = 160 ft= 48.768meter The…

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).