II. READING A VOLTMETER Indicate the voltage reading of the voltmeter below Directions: Write your answer on the space provided. VOLT AC/DC What is the reading? Vhe Whalen 30 20 50 290 AC1N BATTERY W-375 PANIDA Proper Pointer Position 10 250 201002000

II. READING A VOLTMETER Indicate the voltage reading of the voltmeter below Directions: Write your answer on the space provided. VOLT AC/DC What is the reading? Vhe Whalen 30 20 50 290 AC1N BATTERY W-375 PANIDA Proper Pointer Position 10 250 201002000

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 10PP: In an R-L parallel circuit, ET=240 volts, R=560, and XL=330. Find apparent power.

See similar textbooks

Related questions

Q: A. What is the power absorbed by the 14Ω resistor, R1? (in watts, upto 2 decimal places) B. What is…

Q: B/I A 60 MW steam power station has a thermal efficiency of 30%. If the coal burnt has a calorific…

Q: Calculate for Et in Volts.

Q: What is the relationship between the two given equations? v1=100 cos(377t +30°) volts v2=120…

Q: Choose from the choices and explain why is that the answer. 1. An electric current is made up of…

Q: Q1: A lamp of 110 watt power, 250 volt reaches 2110°C. If the - temperature coefficient ao of the…

A: The solution can be achieved as follows.

Q: A capacitor is constructed with parallel plates and has a value of 50pF. What would be the…

A: b) A capacitor is constructed with parallel plates and has a value of 50pF. What would be the…

Q: 5. Calculate the height in cm of a man 5 ft 11 in. tall. 6. Calculate the mass in kg of 1 yd' of…

Q: If the cost of the insulation is P5,000 ft2, what time will be required to pay for this insulation?…

A: Net energy saved is 250.792 BTU/hrft2Considering 1 ft2 as basis

Q: 14. A 220-volt electrical heater is used to warm 6Li/hr of water from 250C to 930C. Assume heat…

Q: 36. A stove element draws 15 A when connected to 230 V line. How long does it take to consume one…

A: we need to find out time t.

Q: Q/ What does this mean in an electrical single line diagram? L1 11kV 50HZ 3PH 3 WIRE 2000A 40KA FOR…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: POWER DISSIPATED POWER SUPPLIED CALCULATED VALUES (, x E) ,= _A , = _A PR1 = W %3D 2 = __A PR2 = W…

A: The required values of voltage, current and power can be calculated by using the kirchhoff's voltage…

Q: Which of the following is the basic step in calculating LOLE? a. Energy Demand b. Expected Energy…

A: To calculate of loss of load expectation following steps should be performed. 1. Determine the…

Q: I. Fill the following details for the lab Equipment's: Q1. Specification/Range of Voltmeters: Q2.…

Q: If R1 = 120, R2 = 20. The source Voltage is 120 Volts. I, VAC R1 R2 11 12 Find the Total Current in…

Q: 2:44 00:46:32 Remaining Multiple Choice The resistance of a copper wire measures 25-milliohm at 25…

Q: Calculate the current through the heater when it is operating. Express your answer to two…

A: Current in heater = heater power / (voltage across heater). Power consumed by heater =(voltage…

Q: Determine the following for solar PV power system referred to the data given below. (Assume the…

A: Given data: η=15%E=1050 W/m2Area of each solar cell=65 cm2

Q: A copper wire has a diameter 5mm and length 8 cm with a conductivity 5x107 S/m. If an electric field…

Q: How much energy will a 100 W table fan consume in 20 hours? Express the answer in terms of the unit…

A: An energy expenditure of 1 Wh represents 3600 joules.

Q: List down 2 environmental impacts in the comment section associated with each of the following…

A: Renewable energy is derived from renewable resources that are renewed naturally on a human timeline.…

Q: (2) lulhai the power by (element 8 amp source and element with 9 volts across it ) in fig below is…

Q: 0.05 mT 10 cm →y Find magnitude of current and direction of current flowing

Q: Which is a disadvantage of wind energy? O a. It does not use any water. O b. It needs more…

Q: A person working on a steel structure while standing on ground. An accident occurred where 7 A pass…

Q: 13. i) The data for a wind turbine is given below: Wind speed = 14 meters/sec, Length of blade = 10…

Q: Determine the following for solar PV power system referred to the data given below. (Assume the…

A: According to the question we have to find the value, (a) total output voltage and output power of…

Q: V1 2.12 V2 + 1.50 24V Reference 3.60

Q: 8. A current of 2A flows in a wire offering a resistance of 10ohm. Calculate the energy dissipated…

A: we need to find out energy.

Q: I want all the work and answers to these problems

Q: The equivalent power (watts) of three (3) tons of cooling is?

A: Ton of cooling unit is used to measure the power of an AC. 1 ton is equal to 3516.85 W Therefore, 3…

Q: A 220-volt electrical heater is used to warm 6Li/hr of water from 250C to 980C. Assume heat…

Q: Exercise 1.6. New York City requires about 1010 watts of electrical power, at !15 volts (this is…

A: Power delivered = 1010watt Output voltage= 115 V. Current output at the end of cable will be…

Q: Ia W1 T0 Ic 8. Ib W2 eele 10 Given V = 300V Calculate Ia, In, Ic PaiPar Pe, Pt QL, Qc.Calculate Watt…

A: It is given that the line voltage of the source is 300 V. The following voltage can be written for…

Q: What is the current (I) when voltage is 2v and resistance is 44 ohms? Do NOT include units Round…

A: Given : Voltage: V=2 VResistance: R=44 ohmsCalculation of current: I Do NOT include units Round…

Q: a) In a Power System, Define the following (i) Peak Load (ii) Spinning Reserve

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: The correct specific

Q: Calculate the full scale deflection current of the meter movement with sensitivity of 4k ohms/ volts…

Q: Answer number 14.write youe solution pls.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Vb = 100 volts R = 10000 ohms C = 200 μF Assuming that after a long period of time, the switch is…

Q: Two cities are 150 km apart. Electric power is sent from one city to another city through copper…

A: Given: Electric power is sent from one city two another city through copper wire Distance between…

Q: 1 A constant inductance of 1 henry and a variable resistance R are connected in series with a…

Q: 1. Fill the following details for the lab Equipment's: Q1. Specification/Range of Voltmeters: Q2.…

A: 1. Specification/ranges of ammeters a. (0 - 1)A b. (0 - 2 )A c. ( 0 - 5 )A d. ( 0 - 10 )A e. ( 0 -…

Q: Consider the circuit shown in Figure P1.62. Find the current iR flowing through the resistor. Find…

A: Circuit diagram can be redrawn as ; As all the elements are in series therefore same current will…

Q: no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per…

A: In this question AWG wire is given...We have to find out power loss due to current and due to this…

Q: A person working on a steel structure while standing on ground. An accident occurred where 6 A pass…

A: Given: Fault current, If=6 A Radius, r=0.2 m Resistance of man, Rman=2000 Ω Soil resistivity, ρs=100…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

Indicate the voltage reading of the voltmeter below.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction

VIEW

Step 2 Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Schematic diagrams break the wiring of control systems down into a(n) _____ arrangement. a. circuit-by-circuit b. series circuit c. individual circuit d. none of the above
Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to polar and exponential form: (c) calculate A3=(A1+A2), giving your answer in polar form: (d) calculate A4=A1A2, giving your answer in rectangular form: (e) calculate A5=A1/(A2*) giving your answer in exponential form.
Subject: CircuitsGivenRt = 37.9529 ohm..Rcd = 3.6 ohm.Rab=2.3529ohmIt=1.58APt=94.85WV2=3.16VV4=6.32VVab=3.7175vVcd=5.688VI10=0.372AI5=0.7435AI8=0.465AI9=0.632AI6=0.348AP2=4.9928WP4=9.9856WPab=5.88WP14=34.95WPcd=8.99WP12=29.96W
Use delta-wye and wye-delta transformation in solving. Please show complete solution. Complete and neat solution please. Thanks
nodes paths loops meshes branches
Please show your detailed solution Number 19 How much power is represented by a circuit in which the voltage and current equations are e = 180 sin314t and i = 42 sin 314t? A. 771 W C. 7560 W B. 3780 W D. 5346 W
Hİ, V01=?, , V02=? , I0=? (VDSi=0.7V VDGe=0.3V) Can you explain your solution Thank you
Can a full adder circuit be used as a subtractor? If yes, draw the circuit (please ASAP TIA)
Consider the circuit segment shown in the figure below. GivenE1 = 1.94 V, E2 = 9.67 V, R1 = 36.8 kΩ, R2 = 65.9 kΩ, I1 = 34.4 µA, themagnitude of the current passing thru the second resistor is most nearly
Use delta-wye and wye-delta transformation in solving. Please show complete solution. Thanks
answer is a. R=22.5 ohms, X = 30 ohms b. Vs = 747.11<34.82 Vrms How do I solve in steps?
answer the following questions using the attached picture. (c) To measure the current flow though R1 and the voltage onR5, how should we connect the ammeter and voltmeter?Draw a circuit diagram showing your answer. (d) What is the ideal impedance of1). an ammeter?2). a voltmeter?