III. DETERMINE TOTAL AREA USING DMD METHOD. ,L = 11.25 mB =S 79° 41' EL = 9.20 mL = 6.40 mL = 9.25 mB =S 77° 28' WB =S 38° 39' wB = N 12° 31' EABD Show complete solution.Convert angles into degrees and minutes.Round off lengths to 3 decimal places.Do not forget the units.

Answered: Image /qna-images/answer/496284ee-8317-486a-a8b4-d5621944cd5e.jpg

Answered: III. DETERMINE TOTAL AREA USING DMD…

III. DETERMINE TOTAL AREA USING DMD METHOD. , L = 11.25 m L = 9.20 m L = 6.40 m L = 9.25 m B =S 79° 41' E B =S 77° 28' W B B =S 38° 39' w B = N 12° 31' E

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Determine radius of mohr circle

Q: 3: The following figure shows spot levels at 25 m intervals over a small site which is to be made…

Q: line BC and DE. Solve for the area using DMD Method in hectares. Tabulate the values accordingly.

A: Given data: Lines Azimuth from South Distance(m) AB 228o 20' 529.0 BC…

Q: urated Soil d Ratio = 0.45 %3D cific Gravity of Solids = 2.65 %3D d the water content 17% 15% 69%…

A: Given that Void ratio e =0.45 Specific gravity of solids G = 2.65 Saturated soil

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 20+8200…

Q: Situation 4 From the given cross-section of earthworks between A (20+200) and B (20+220) assuming…

A: Earthworks are engineering structures that are built by moving and/or treating large amounts of…

Q: Q2): The table below presents the calculated areas of closed contour lines (reservoir) taken by a…

A: Scale = 1:500 It has been asked in the question to determine the Total capacity of the reservoir…

Q: Develop an earthwork summery tabulating excavation, embankment and mass ordinates given the…

A: Earthworks is the main advance for your home; as it is the finished underpinning of your home and…

Q: 5. A square piece of land 60x60 m is to be leveled down to 6m above elevation zero. To determine the…

A: A=29.8, B=27.3, C=25.2, D=28.3, E=26.5, F=24.3, G=26.9, H=23.3, I=24.2, J=21.3,K=22.6, L=20.5,…

Q: The areas bounded by the water line of a reservoir is determined using a planimeter. The distances…

Q: 2. Complete the Differential Leveling Notes by providing data to the unknown quantities. STA BM1 0+…

A: In this method, following approach is adopted to find the unknown elevations of different points.…

Q: Station Cross section 9.0 4.5 +3.0 +4 4.5 6.0 +2,0 +1.5 +1.0 1+ 020 4.5 9.0 7.5 45 +4.0 +2.0 +5.0 1…

Q: Give the equation for Cunningham correction factor.

A: where C =correction factor λ =mean free path d = particle diameter An are experimentally determined…

Q: From the given cross-section of earthworks. (Width of base is 8m) Sta A 9.5 +2.75 +1.5 +0.5 Sta B 9.…

Q: The area bounded by the water line of a reservoir and the contours with a contour interval of 2 m.…

Q: 1. From the given cross section of an earthworks between A (20 + 200) and B (20 + 220) assuming both…

A: Let the width of the base be 'b' and the slope be 'm' From the right side of the road:…

Q: Define the Effective Area Method (Meyerhoff, 1953) ?

A: When foundations are exposed to both moment and vertical loads, this is a common occurrence.…

Q: From the given cross-section of the proposed 8m wide road: Sta. 1+120 6.45 4.5 +2.3 +1.5 +1.0 Sta.…

Q: Calculate immediate settlement at points A and B q = 400 kPa Es = 19 MN 2 m 2 m u = 0.4 2 m B 2 m

A: Given data- pressure q=400 kPayoung modulus Es=19 MNpoisson's ratio μ=0.4To find-The imediate…

Q: A 4-hour unit hydrograph of a drainage basin is triangular in form with a height of 50 m³/sec and a…

Q: From the ff data of measuring over sloping ground, determine the: a) b) c) Length of line BA Mean…

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 23+8500…

A: To Determine the cross sectional area at STA 23+8500.

Q: A hydrographic survey of a lake generated the following approximate measurements: Area enclosed by…

A: Given: The area enclosed by the waterline is 16,500 m2. The area enclosed by contour A is 9,200 m2.…

Q: 17. From the given cross-section notes of an earthworks having an area of 33.1 m?, compute the value…

A: Area of the cross-section = A = 33.1m2 Side slope 2:1 Width of roadway = W = 10m Horizontal distance…

Q: SITUATION 4- Hydrographic Survey- End Area Hethod The area bounded by the water line of a reservoir…

Q: H.W: - After surveying a borrow-pit, the surveyor produced the following borrow- pit grid below, the…

A: Given:- The borrow-pit grid of the ground surface is given The excavated cut level = 10 m To…

Q: solve the following values indicated in the table then draw the sketch of the survey, with complete…

A: Given: Required to find: The adjusted bearing after applying correction.

Q: Situation 5 From the given cross-section of earthworks. (Width of base is 8m) Sta A 9.5 5 +2.75 +1.5…

A: We have to determine the value of area of the station A and B aa per the given data in the question…

Q: e BC and DE. Solve for the area using DMD Method in hectares.

Q: 17. From the given cross-section notes of an earthworks having an area of 33.1 m?, compute the value…

A: Note: Hi! Thank you for the question As per the honour code, We’ll answer the first question since…

Q: find diameter of the well to yield 4000 Iph, if c=0.09/h and depression head = 0.8m. %3D

A: The diameter of the well can be found out by using the following formula: Q=CAh Where, C = Specific…

Q: Station 2+120 Station 2+150 Left Middle Right Left Middle Right 2.25 1.0 0.8 2.75 |. 5 0.5 5.6 9.5…

Q: Find the value of discahrge through rectangular cross section having area 1.3 m2 and velocity of…

A: Introduction : The given question is related with fluid mechanics . In this question we are provided…

Q: P = 1.81" P = 2.15" P = 2.26" P = 2.18" P = 1.62" %3D P = 1.80"

Q: Situation 7: The areas bounded by the waterline of a lake and the contours with contour interval of…

Q: 1. Complete the differential level notes shown below and perform the customary arithmetic check. BS…

A: For Arithmetic check following equations needs to be satisfied. ∑BS-∑FS=Last RL - First…

Q: Q1) An irrigation ditch is with width of 5 m and side slopes 2 to 1. Giving distance from center…

Q: A square piece of land 60x60 m is to be leveled down to 6m above elevation zero. To determine the…

A: A=29.8, B=27.3, C=25.2, D=28.3, E=26.5, F=24.3, G=26.9, H=23.3, I=24.2, J=21.3,K=22.6, L=20.5,…

Q: Compute the area given the following cross section notes: Base for cut = 9m and for fill =8 m. Side…

Q: Complete the following Profile Leveling Notes: (Use 2 decimal places.) STA BS HI FS BM1 0.95 1 2 TP1…

A: Given data: The given table of leveling. BS =Back sight FS=Fore sight IS=Intermediate sight…

Q: Q.1) Answer one only A) A rectangular plot (ABCD) forms the plane of a pit excavated for road work.…

Q: AREA OF RANGE CROSS-SECTION. Soundings were taken along a 38-m long range across a lake (see…

Q: Q2). Calculate volume of cut and fill, the elevation of natural ground shown on all nodes and design…

Q: The areas bounded by the water line of a reservoir is determined by using a planimeter.The contour…

A: Contour interval, h=2mAreas , A1 =20400 m2, A2=18600m2, A3=14300 m2, A4=10200m2, A5=8000m2,…

Q: From the given data of an earthwork at STA. 1+100, compute the area of the cross section assuming…

Q: The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 14+500…

Q: Determine: RA KN, RB KN, V Diagram (2 decimal places), Vmax (kN 2 dec), Area V (2 dec), M Diagram (2…

Q: the perimeter of a sector is 22 m and its radius is 5 m. compute the area of the secotr m^2.

Q: The cross-section notes shown below are for a ground excavation for a 9m wide roadway. STA 24+600…

Q: 7. From the following set of notes, estimate the cross-sectional area: 2.52 3.42 4.1 5.2 5.8 5.52 3…

Concept explainers

Dimensional homogeneity

The term dimensional homogeneity means that in an equation, the dimensions of each term on both sides are equal, which means the dimensions of the left-hand side (LHS) of an equation are similar to the dimensions of the right-hand side (RHS). For a dimensionally homogeneous equation, the powers of fundamental dimensions will be identical on both sides of the equation.

Question

III. DETERMINE TOTAL AREA USING DMD METHOD. ,
L = 11.25 m
B =S 79° 41' E
L = 9.20 m
L = 6.40 m
L = 9.25 m
B =S 77° 28' W
B =S 38° 39' w
B = N 12° 31' E
A
B
D

Show complete solution.
Convert angles into degrees and minutes.
Round off lengths to 3 decimal places.
Do not forget the units.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

please show complete solution Given: F = 800 N θ = 25° μs = 0.35
Show complete solutions in three decimal places. Where w=134
Determine the resultant R. Compute magnitude, sense and angle of inclination with horizontal x.
How to solve for 3,4 and 5?
multiply the decimal fractions. 48.13 inches*30.07
Draw a diagonal scale to show kilometers, hectometers & decameters when 1 km is represented as 2 cm. Take maximum length of scale as 8 kilometers. Mark off 5.89 kilometers.
express each measurement in centimeters.0.07 meter
Find area of a sector of a circle of diameter 20 centimeters with central angle of 60o. What is the area of its corresponding segment? What is the length of its bounding arc? Kindly draw/show the figure and detailed solution.
Please answer in two decimal places po
Find the centroidal distances from x-axis and y-axis
Show complete solutions in 3 decimal places. Where w=134.
Find the centroidal distances from x axis and y axis