Answered: In a 33 kV overhead line, there are 3…

Engineering

Electrical Engineering

In a 33 kV overhead line, there are 3 units in the string of insulators. The voltage across the string is ?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2MCQ: Overhead transmission-line conductors are bare with no insulating cover. (a) True (b) False

See similar textbooks

Related questions

Q: QUESTION 16 Consider the AC voltage shown below. v₁ (t) = 2 * cos (50nt + 7) V Specify the minimum…

A: The given AC voltage is v1t=2cos50πt+π6 Volts. We need to determine the minimum value of the voltage…

Q: The bill of commercial load based on Iragi electricity tariff of 1600 kWh costs

Q: The heavier the conductor or cable, the greater the sag. Select one: True False

A: Given The heavier the conductor or cable, the greater the sag

Q: If the area of cross section of a conductor is increasing, then the resistance of the conductor…

A: If the area of the cross section of a conductor is increase then resistance?

Q: What is earth voltage?

A: What is earth voltage.

Q: What is the voltage drop across RB, VB, in volts? (Enter the number, not the units.)

Q: 13. What are the color codes for 470k ohms? Orange, Gray, Orange Yellow, Violet, Yellow…

A: First we write table of color code table for three band resistor then replace each digit with…

Q: What size ungrounded conductors does a 150 A residential service require? a. 2 AWG b. 1 AWG c. 1/0…

A: The correct option could be b and d also because you didn't mentioned which Conductor when it's…

Q: 500 V- 470 Ω Μ 470 Ω 470 Ω

A: Given:

Q: Draw & Explain single line diagram of 11KV substation

A: parts of a substation lighting suppressant Transformer, circuit breakers, relays, fuse isolators,…

Q: High Voltage level in Transmission system ensures ………………… a. High current in Overhead conductors b.…

A: The primary reason to use the high voltage level in the transmission to increase the efficiency.…

Q: If the length of the conductor is increasing, then the resistance of the conductor will

A: It will increase. The explanation is provided below.

Q: 2- Why the measured value of currents differed from the calculation.

A: Measure value generally differ from calculated value because to measure the quantity we are using…

Q: When the size of the largest ungrounded service conductor exceeds 1100 kcmil copper, then the…

A: Correct option is The 12.5% rule

Q: In Kelvin's law, the total minimum cost corresponding to any cross section of conductor is

Q: The older the conductor or cable gets, the lesser the sag. Select one: True False

A: Given Older cables gets lesser sag.

Q: Determine the best current density in A/mm for a 3-0 overhead line if the line is in use for 2000…

A: Given ρ=1.73 Ω-mJ=6200 Kg/m3Cost of conductor = Rs 3/KgTotal time = 2000 hoursWeight = 6200 Kg/m3…

Q: To protect the cable from moisture in the soil, a metallic sheath of material is provided over the…

A: In cables metallic sheath is provided after insulation to protect the cable from moisture.

Q: determine the currents for the given electrical networks

A: Consider node A from the circuit and applying KCL at the same node: By applying KCL in loop…

Q: kV. The voltage level of the super high tension cables is

Q: Calculate the resistance of 1 km cable composed of 19 strands of similar alloy conductors, each…

A: In this question we need to find a resistance of the conductor.

Q: If the area of cross section of a conductor is decreasing, then the resistance of the conductor will

A: Area on the cross sectional of the conductor is decreased then resistance will be?

Q: what is the type of the Iraq electricity tariff

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: If the length of the conductor is increasing, then the resistance of the conductor

Q: If the length of the conductor is decreasing, then the resistance of the conductor will

A: Resistance of conductor is given by R = (Rho*length) / area of Cross section. Resistance…

Q: If the length of the conductor is increasing ,then the resistance will

A: We know that Resistance R=ρlAρ- resistivityl= length of conductorA= Area of conductor

Q: 1. what 15 the percentage saving in copper feeder if the line voltage in a 2-wire D.C. system is…

A: Line voltage raised from 220V to 500V in a 2wire DC system Power transmitted and power loss is same…

Q: . The older the conductor or cable gets, the lesser the sag

A: Choose the correct option The given Statment is The older the conductor or cable gets, the lesser…

Q: One of the following factor, which will not affect the resistance of the transmission line. O…

A: Resistance of a circuit is defined as opposition to the flow of current in a conductor. The value of…

Q: resistive loads of 60 ohms ea each line is

A: In this question, delta connected system given..We have to find current in each line..

Q: What would be the maximum weight W of the block, shown in the following figure, so that the tension…

Q: 10. Overhead and underground service conductors are governed by the _______ and are the…

A: Conductors: Conductors is a physical medium to carry electrical energy from one place to another…

Q: 1- Why the capacity of SG is taken in kVA and for IM is taken in kW?

A: Electrical machines can be either generator or motors. They can be either AC machines or DC…

Q: 1. In a wye connected circuit, if the line-to-line voltage is 346 volts. What is the line-to-…

A: Wye connection is also called as star connection.

Q: What is ohms low

A: Current: It is a flow of electrical charge carriers like electrons. It is time rate of change of…

Q: 1. explain why A wattmeter will indicate zero when the current lags (or leads) the voltage by 90 0.

A: As per the policy, I can only answer one question at a time. Please ask the second question…

Q: is a common conductor for both incoming and outgoing lines of the substation. O a. Bus-bar O b. LT…

A: Bus bar is the common conductor for both incoming and outgoing lines of the substation. Why because…

Q: What should be the minimum cross-sectional area of each conductor in a two-core cable 100 m long to…

A: Write the expression for the potential difference.

Q: For each set of voltages given below,

Q: Each of the 19 strands of copper cable has a diameter of 59 mils. Calculate the resistance of a mile…

A: According to the question we have to find the value of resistance of a mile of such cable at a…

Q: If the area of cross section of a conductor is increasing, then the resistance of the conductor will

A: Given If area of cross section of conductor increase the resistance ........

Q: Figure 2 is a 120/240 volt 3 wire service. What is the current on the neutral conductor? Figure 2 A…

Q: explain the construction of a wattmeter

Q: Formula of wattage

A: Formula of wattage

Q: Subject - Explain the different methods of electricity distribution Question - Explain…

A: Electrical energy is dominant because it is easier to transport and distribute than other sources of…

Q: In three phase star connected system, the potential between any line and neutral is called 1. Line…

Q: Q1. Why Earth Leakage Circuit Breaker is important? Draw a neat diagram of Earthing system

A: In our electrical installation, there is always a chance of current leakage so it is most probable…

Q: Explain and draw a diagram of 3 wattmeter method?

Q: ssume 100kW of power is to be transmitted. Determine the amount of line current when transmission…

A: Power-It is defined as combination of voltage and current. It is unit of power is Watt. P=VI=V2R=I2R…

Q: 1. With respect to conductor insulation, interpret the following insulation designations: а. Т b. N…

A: a) T - Wire wrapped in thermoplastic insulation for protection below 32oF to 150oF. b) N - made by…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

In a 33 kV overhead line, there are 3 units in the string of insulators. The voltage across the string is ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the voltage drop in kV on the transmission line?
The SAG of the conductors of a transmission line is 2.5 meters when the span is 150 meters. With all other remain unchanged, what will be sag if span is increased by 50%?:
Calculate the line current drawn by the load.
1. what 15 the percentage saving in copper feeder if the line voltage in a 2-wire D.C. system is raised from 220V to 500V for the same power transmitted over the same distance and having the same power loss?
ssume 100kW of power is to be transmitted. Determine the amount of line current when transmission voltages of 1,000 volts are used.
What is the value of VDS if the 33k ohms is shorted?
The column diagram of a dwelling is given in the following figure. The operating voltage of the line is 220V. In the column line where copper conductors are used, the voltage drop is not required to exceed 1.5%. Accordingly, calculate the conductor cross section to be used on the line and the voltage drop on the line. (k = 56m / ohm.mm2)
11. The older the conductor or cable gets, the lesser the sag. Select one: True False
A 12-kW, 240-volt range contributes _____ watts to the load when calculating the service by the standard method
Using nodal analysis, what is the power absorbed by the 15-ohms resistor?
8/The Efficiency of a Transmission Line should be _____? A. as high as possible. B. as low as possible. C. zero or nil D. none of the choices or options
A 220 volts generator supplies 15 amperes to load 500 feet away. If No. 10 copper wires are used for line conductor. Find the following: A. Voltage drop B. Voltage at the load